Surface-enhanced Raman scattering-active gold nanoparticles modified with a monolayer of silver film

Trends in Application of SERS Substrates beyond Ag and Au, and Their Role in Bioanalysis

This article compares the applications of traditional gold and silver-based SERS substrates and less conventional (Pd/Pt, Cu, Al, Si-based) SERS substrates, focusing on sensing, biosensing, and clinical analysis. In recent decades plethora of new biosensing and clinical SERS applications have fueled the search for more cost-effective, scalable, and stable substrates since traditional gold and silver-based substrates are quite expensive, prone to corrosion, contamination and non-specific binding, particularly by S-containing compounds. Following that, we briefly described our experimental experience with Si and Al-based SERS substrates and systematically analyzed the literature on SERS on substrate materials such as Pd/Pt, Cu, Al, and Si. We tabulated and discussed figures of merit such as enhancement factor (EF) and limit of detection (LOD) from analytical applications of these substrates. The results of the comparison showed that Pd/Pt substrates are not practical due to their high cost; Cu-based substrates are less stable and produce lower signal enhancement. Si and Al-based substrates showed promising results, particularly in combination with gold and silver nanostructures since they could produce comparable EFs and LODs as conventional substrates. In addition, their stability and relatively low cost make them viable alternatives for gold and silver-based substrates. Finally, this review highlighted and compared the clinical performance of non-traditional SERS substrates and traditional gold and silver SERS substrates. We discovered that if we take the average sensitivity, specificity, and accuracy of clinical SERS assays reported in the literature, those parameters, particularly accuracy (93-94%), are similar for SERS bioassays on AgNP@Al, Si-based, Au-based, and Ag-based substrates. We hope that this review will encourage research into SERS biosensing on aluminum, silicon, and some other substrates. These Al and Si based substrates may respond efficiently to the major challenges to the SERS practical application. For instance, they may be not only less expensive, e.g., Al foil, but also in some cases more selective and sometimes more reproducible, when compared to gold-only or silver-only based SERS substrates. Overall, it may result in a greater diversity of applicable SERS substrates, allowing for better optimization and selection of the SERS substrate for a specific sensing/biosensing or clinical application.

In situ detection of fluid media based on a three-dimensional dendritic silver surface-enhanced Raman scattering substrate

A simple substitution reaction was used to grow 3D dendritic silver structures in microfluidic channels, and a highly active SERS detection platform was formed. The system can realize in situ detection of 10−10 mol L−1 R6G solution.

Programmable SERS active substrates for chemical and biosensing applications using amorphous/crystalline hybrid silicon nanomaterial

We present the creation of a unique nanostructured amorphous/crystalline hybrid silicon material that exhibits surface enhanced Raman scattering (SERS) activity. This nanomaterial is an interconnected network of amorphous/crystalline nanospheroids which form a nanoweb structure; to our knowledge this material has not been previously observed nor has it been applied for use as a SERS sensing material. This material is formed using a femtosecond synthesis technique which facilitates a laser plume ion condensation formation mechanism. By fine-tuning the laser plume temperature and ion interaction mechanisms within the plume, we are able to precisely program the relative proportion of crystalline Si to amorphous Si content in the nanospheroids as well as the size distribution of individual nanospheroids and the size of Raman hotspot nanogaps. With the use of Rhodamine 6G (R6G) and Crystal Violet (CV) chemical dyes, we have been able to observe a maximum enhancement factor of 5.38 × 10⁶ and 3.72 × 10⁶ respectively, for the hybrid nanomaterial compared to a bulk Si wafer substrate. With the creation of a silicon-based nanomaterial capable of SERS detection of analytes, this work demonstrates a redefinition of the role of nanostructured Si from an inactive to SERS active role in nano-Raman sensing applications.

Electrochemically fabricated gold dendrites with underpotential deposited silver monolayers for a bimetallic SERS-active substrate

SERS of Ag-covered Au-dendrites (Ag–Au-Ds) outperforms that of Au-Ds at a specific 633 nm laser excitation, and is attributed to improved chemical mechanism (CM) SERS with the Ag–p-NTP bonding and the p-NTP molecular architecture.

Silver nanopartical over AuFON substrate for enhanced raman readout and their application in pesticide monitoring

Surface-enhanced Raman detection of thiram is demonstrated by using Ag-nanoparticles (Ag NPs) on Au film over nanosphere (AuFON) substrate as the hybrid substrate. The SERS signal of the Ag NPs attached to solid supports is studied. The close coupling together of thousands of Ag NPs on AuFON leads to the generation of hot spots for SERS. The Ag NPs on AuFON can be applied to detect rhodamine-6G (R6G) with the detection limitation of 10⁻¹¹ M and the pesticide thiram in acetone with a detection limit of as low as 0.24 ppm, which is much lower than the maximal residue limit (MRL) of 7 ppm in fruit prescribed by the U.S. Environmental Protection Agency (EPA). The hybrid substrates are shown to be highly sensitive for the detection of thriam, which produce highly enhanced Raman signals with good uniformity and reproducibility due to having plenty of hot spots on its surface.

Porous metallic nanocone arrays for high-density SERS hot spots via solvent-assisted nanoimprint lithography of block copolymer

We present a facile method of fabricating SERS substrate by combining solvent-assisted nanoimprint lithography and selective etching of block copolymer.

Room-temperature sensor based on surface-enhanced Raman spectroscopy

As reported in the literature, several factors, such as scattering cross sections, polarisability and wavelength suitability, contribute to increased SERS enhancement. In general, the advantage of surface-enhanced Raman scattering (SERS)-active Ag nanoparticles (NPs) is their higher SERS enhancement over Au NPs because the molar extinction coefficient of the Ag NPs is the highest of its kind among metals. Nevertheless, the corresponding SERS-active hot spots on Au are of inherently greater stability than on Ag. In this work, innovative temperature sensors based on SERS-active Au and Ag substrates prepared by sonoelectrochemical deposition-dissolution cycles (SEDDCs) are first reported. The SERS intensity of the model probe molecules of Rhodamine 6G (R6G) adsorbed on a SERS-active Ag substrate is monotonically increased from 25 to 50 °C. Moreover, this temperature-dependent intensity is linear with a slope of ca. 430 cps per °C between 25 to 45 °C. In addition, the reversibility and reusability of the developed temperature sensors are evaluated after the R6G-adsorbed sensors are alternately exposed to the temperatures of 25 and 45 °C in a sealed chamber. After every five cycles, the SERS spectra of treated substrates were recorded and compared with those of the as-prepared substrates. Experimental results indicate that SERS enhancement capability is mostly reversible based on 90% intensity of the Raman signal being maintained for the SERS-active Au substrate after 25 cycles (only 15 cycles for the Ag substrate).