Eutectic Media Open a Synthetic Route to Oligocitrazinic Acid Fluorophores of Purple Hue

Under isochoric and solvent-free conditions, the reaction between ammonium formate and citric acid results in a deeply purple reaction product with fluorescent properties. This brings this reaction in the realm of bio-based fluorophores and bottom-up carbon nanodots from citric acid. The reaction conditions are optimized in terms of UV-vis spectroscopic properties and, subsequently, the main reaction product is separated. While the structural analysis does not give any indication for carbon nanodots in a general sense, it points towards the formation of molecular fluorophores that consist of oligomerized citrazinic acid derivatives. Furthermore, EPR spectroscopy reveals the presence of stable free radicals in the product. We hypothesize that such open-shell structures may play a general role in molecular fluorophores from citric acid and are not yet sufficiently explored. Therefore, we believe that analysis of these newly discovered fluorophores may contribute to a better understanding of the properties of fluorophores and CND from citric acid in general.

A smart ratiometric fluoresence and colorimetry dual-responsive sensor for morin determination based on the complex between carbon quantum dots and polyethyleneimine

As a representative flavonoid, morin exhibits multi-biological activities, but its abuse endangers human health. Developing advanced technology for morin determination is urgently needed. In this study, a dual-responsive approach was reported for morin based on the complexing of carbon quantum dots (CQDs) and polyethyleneimine (PEI). The CQDs were fabricated via an improved hydrothermal method employing tyrosine and malic acid. Binding with PEI induced an 8-fold emission enhancement and a slight red-shift to 445 nm of CQDs because of the complexing of PEI and CQDs. Further morin introduction led to the blue emission (445 nm) quenching of CQDs-PEI and a yellow emission (560 nm) generation, which contributed a ratiometric fluorescence approach for morin determination between 2.0 and 32 μM, with a limit of detection (LOD) of 45 nM. Meanwhile, under sunlight the color of CQDs-PEI became yellow upon morin addition, which developed a colorimetric method for morin determination in a wide range between 2.0 and 100 μM (LOD = 69 nM). The developed dual-responsive method either displayed accurate results for morin in diluted human and bovine serum, being potential for actual sample analysis. Finally, a visual detection based on the smartphone was constructed and applied for the real-time determination of morin.

Radiative and Non-Radiative Decay Pathways in Carbon Nanodots toward Bioimaging and Photodynamic Therapy

The origin and classification of energy states, as well as the electronic transitions and energy transfers associated with them, have been recognized as critical factors for understanding the optical properties of carbon nanodots (CNDs). Herein, we report the synthesis of CNDs in an optimized process that allows low-temperature carbonization using ethanolamine as the major precursor and citric acid as an additive. The results obtained herein suggest that the energy states in our CNDs can be classified into four different types based on their chemical origin: carbogenic core states, surface defective states, molecular emissive states, and non-radiative trap states. Each energy state is associated with the occurrence of different types of emissions in the visible to near-infrared (NIR) range and the generation of reactive oxygen species (ROS). The potential pathways of radiative/non-radiative transitions in CNDs have been systematically studied using visible-to-NIR emission spectroscopy and fluorescence decay measurements. Furthermore, the bright photoluminescence and ROS generation of these CNDs render them suitable for in vitro imaging and photodynamic therapy applications. We believe that these new insights into the energy states of CNDs will result in significant improvements in other applications, such as photocatalysis and optoelectronics.

Preparation of highly crystalline nitrogen-doped carbon dots and their application in sequential fluorescent detection of Fe3+ and ascorbic acid

Carbon dots (CDs) have been a new class of fascinating carbon-based fluorescent nanomaterials. In the present work, new N-doped CDs with highly crystalline graphite structures are prepared from renewable precursors, chitosan and tartaric acid, and are well characterized. The prepared CDs are applied as a biocompatible fluorescent sensor for the sequential detection of Fe³⁺ and AA. Among various transition metal ions, Fe³⁺ can selectively quench the fluorescence of CDs. Upon the further addition of AA, the quenched fluorescence of CDs is then restored as Fe³⁺ is reduced to Fe²⁺ by AA, which can be utilized for the fluorescent determination of AA. A good linear relationship in the range of 0-150 μM of AA concentration is established with a low detection limit of 0.02 µM. Moreover, the practical applications of this fluorescent sensing method in measurement of AA in food samples are successfully realized with satisfactory results.

Recent Advancements in Doped/Co-Doped Carbon Quantum Dots for Multi-Potential Applications

Carbon quantum dots (CQDs)/carbon nanodots are a new class of fluorescent carbon nanomaterials having an approximate size in the range of 2–10 nm. The majority of the reported review articles have discussed about the development of the CQDs (via simple and cost-effective synthesis methods) for use in bio-imaging and chemical-/biological-sensing applications. However, there is a severe lack of consolidated studies on the recently developed CQDs (especially doped/co-doped) that are utilized in different areas of application. Hence, in this review, we have extensively discussed about the recent development in doped and co-doped CQDs (using elements/heteroatoms—e.g., boron (B), fluorine (F), nitrogen (N), sulphur (S), and phosphorous (P)), along with their synthesis method, reaction conditions, and/or quantum yield (QY), and their emerging multi-potential applications including electrical/electronics (such as light emitting diode (LED) and solar cells), fluorescent ink for anti-counterfeiting, optical sensors (for detection of metal ions, drugs, and pesticides/fungicides), gene delivery, and temperature probing.

Ultrafast spectroscopic investigation on fluorescent carbon nanodots: the role of passivation

Femtosecond spectroscopy allows to clarify the role of passivation on the fluorescence of carbon nanodots and reveals the lack of interplay between core and surface electronic states.

Citrate-Based Fluorescent Biomaterials

Fluorescence imaging has emerged as a promising technique for monitoring and assessing various biologically relevant species in cells and organisms, driving the demand for effective fluorescent agents with good biocompatibility and high fluorescence performance. However, traditional fluorescent agents, such as quantum dots (QDs) and organic dyes, either suffer from toxicity concerns or poor fluorescence performance (e.g., low photobleaching-resistance). In this regard, citrate-based fluorescent biomaterials, which are synthesized from the natural and biocompatible precursor of citric acid (CA), have become competitive alternatives for fluorescence imaging owing to their biocompatibility, cost effectiveness, straightforward synthetic routes, flexible designability, as well as strong fluorescence with adjustable excitation/emission wavelengths. Accordingly, numerous citrate-based biomaterials, including carbon dots (CDs), biodegradable photoluminescent polymers (BPLPs), and small molecular fluorophores, have been developed and researched in the past few decades. This review discusses recent progress in the research and development of citrate-based fluorescent materials with emphasis on their design and synthesis considerations, material properties, fluorescence properties and mechanisms, as well as biomedical applications. It is expected that this review will provide an insightful discussion on the citrate-based fluorescent biomaterials, and lead to innovations for the next generation of fluorescent biomaterials and fluorescence-based biomedical technology.

Fluorescence quenching capillary analysis for determining trace-level nitrite in food based on the citric acid/ethylenediamine nanodots/nitrite reaction

We found that nitrite after protonation can react with amine radical on citric acid/ethylenediamine carbon nanodots (CA/EDA-CDs) to form nitrosamines, and fluorescence quenching of CA/EDA-CDs occurred during this process. Using the reaction mechanism a fluorescence quenching capillary analysis (FQCA) was developed. After optimized reaction conditions, the following results were obtained: the required concentration of CA/EDA-CDs was 12 mg/L, HCl concentration was 32 mmol/L, and the reaction conducted in room temperature for 20 min. Under optimized conditions, FQCA has a linear response in 20-500 μg/L in which RSD was less 4.5% (n = 11), the detection limit was 6.5 μg/L and the recovery was in 95-105%. The measured results were consistent with the national standard method. FQCA has been used for determining nitrite in foods and nature waters. The capillary in FQCA was used as the container for CA/EDA-CDs/NO₂^- reaction and NO₂^- determination, and realized trace-level analysis for micro-volume samples (<10 μL/time).

Artful and multifaceted applications of carbon dot in biomedicine

Carbon dots (C-dots) are luminescent carbon nanomaterial having good biocompatibility and low toxicity. The characteristic fluorescence emission property of C-dots establishes their role in optical imaging. C-dots which are superior to fluorescent dyes and semiconductor quantum dots act as a safer in vivo imaging probe. Apart from their bioimaging application, other applications in biomedicine such as drug delivery, cancer therapy, and gene delivery were studied. In this review, we present multifaceted applications of C-dots along with their synthesis, surface passivation, doping, and toxicity profile.

Protein-derived carbon nanodots with an ethylenediamine-modulated structure as sensitive fluorescent probes for Cu2+detection

The increasing use of fluorescent carbon nanodots (CNDs) demonstrates their advantages for sensing applications; these include superior photostability, absence of toxicity, and rapid analytical capability.

Comparative study for N and S doped carbon dots: Synthesis, characterization and applications for Fe(3+) probe and cellular imaging

A facile and eco-friendly approach to prepare nitrogen(N)- and sulfur(S)-doped carbon dots (CDs) by one step microwave-assisted pyrolysis of the precursors with dl-malic acid as carbon source, ethanolamine and ethane-sulfonic acid as N and S dopants, respectively, was reported. Through the extensive investigation on morphology, chemical structures and optical properties of the carbon dots, it was found that the obtained CDs exhibited good luminescence stability, high resistance to photo bleaching and favorite solubility. Compared with undoped CDs, adding the N or S dopant could give rise to a slightly smaller particle size and a long fluorescence lifetime of CDs. Moreover, the optimal N-CDs was successfully employed as good multicolor cell imaging probes due to its fine dispersion in water, excitation-dependent emission, excellent biocompatibility and low toxicity. Besides, such N-CDs showed a wide detection range and excellent accuracy as fluorescent probe for Fe(3+) ions. This probe enabled the selective detection of Fe(3+) ions with a linear range of 6.0-200 μM and a limit of detection of 0.80 μM.

Solid-phase synthesis of graphene quantum dots from the food additive citric acid under microwave irradiation and their use in live-cell imaging

The work demonstrated that solid citric acid, one of the most common food additives, can be converted to graphene quantum dots (GQDs) under microwave heating. The as-prepared GQDs were further characterized by various analytical techniques like transmission electron microscopy, atomic force microscopy, X-ray diffraction, X-ray photoelectron spectroscopy, Fourier transform infrared spectroscopy, fluorescence and UV-visible spectroscopy. Cytotoxicity of the GQDs was evaluated using HeLa cells. The result showed that the GQDs almost did not exhibit cytotoxicity at concentrations as high as 1000 µg mL(-1). In addition, it was found that the GQDs showed good solubility, excellent photostability, and excitation-dependent multicolor photoluminescence. Subsequently, the multicolor GQDs were successfully used as a fluorescence light-up probe for live-cell imaging.

Nanomaterial-based biosensors using dual transducing elements for solution phase detection

Biosensors incorporating nanomaterials have demonstrated superior performance compared to their conventional counterparts. Most reported sensors use nanomaterials as a single transducer of signals, while biosensor designs using dual transducing elements have emerged as new approaches to further improve overall sensing performance. This review focuses on recent developments in nanomaterial-based biosensors using dual transducing elements for solution phase detection. The review begins with a brief introduction of the commonly used nanomaterial transducers suitable for designing dual element sensors, including quantum dots, metal nanoparticles, upconversion nanoparticles, graphene, graphene oxide, carbon nanotubes, and carbon nanodots. This is followed by the presentation of the four basic design principles, namely Förster Resonance Energy Transfer (FRET), Amplified Fluorescence Polarization (AFP), Bio-barcode Assay (BCA) and Chemiluminescence (CL), involving either two kinds of nanomaterials, or one nanomaterial and an organic luminescent agent (e.g. organic dyes, luminescent polymers) as dual transducers. Biomolecular and chemical analytes or biological interactions are detected by their control of the assembly and disassembly of the two transducing elements that change the distance between them, the size of the fluorophore-containing composite, or the catalytic properties of the nanomaterial transducers, among other property changes. Comparative discussions on their respective design rules and overall performances are presented afterwards. Compared with the single transducer biosensor design, such a dual-transducer configuration exhibits much enhanced flexibility and design versatility, allowing biosensors to be more specifically devised for various purposes. The review ends by highlighting some of the further development opportunities in this field.

A simple strategy for synthesizing highly luminescent carbon nanodots and application as effective down-shifting layers

We propose a novel strategy to prepare highly luminescent carbon nanodots (C-dots) by employing a hydrothermal method with citric acid as the carbon source and ethylenediamine as the nitrogen source, together with adding moderate ammonia water (AW) to achieve both appropriate inner structure and excellent N passivation. The effect of pH value and AW amount on the luminescence properties has been thoroughly investigated. The photoluminescence quantum yield of the resultant C-dots reaches as high as 84.8%, which is of 10.56% higher than that of the C-dots synthesized in the absence of AW in the reaction precursors. We have further combined the highest luminescent C-dots with polyvinyl alcohol to form luminescent down-shifting layers on silicon nanowire solar cells. An effective enhancement of short-circuit current density has been realized and the contribution of the down-shifting has been extracted quantitatively from the deterioration of surface reflectance and the gain of the optical absorption redistribution by means of a theoretical model on external quantum efficiency analysis.

Novel efficient fluorophores synthesized from citric acid

Citric acid was reacted with α,β-diamines, β-amino thiols and β-amino alcohols to produce fluorescent derivatives of 2-pyridone (QY up to ∼79%). The chemical structures of these compounds were confirmed by analyses of 1D, 2D NMR and ESI-MS data.

One-pot synthesis of photoluminescent carbon nanodots by carbonization of cyclodextrin and their application in Ag+ detection

A simple one-pot approach was developed for synthesis of photoluminescent carbon nanodotsfromcyclodextrins.