Synthesis and structure–property relationships of phthalimide and naphthalimide based organic π-conjugated small molecules

Tripodal Triazine and 1,8-Naphthalimide-based Small Molecules as Efficient Photocatalysts for Visible-light Oxidative Condensation

Tripodal donor-acceptor (D-A) small molecules Tr-Np3 and Tr-T-Np3 consisting of triphenyl triazine and 1,8-naphthalimide, without and with a thiophene spacer have been synthesized. Their optical and redox properties were thoroughly investigated along with their utilization as photocatalysts in organic transformations. Compounds Tr-Np3 and Tr-T-Np3 showed broad absorption in the range of 290-480 nm in solutions and 300-510 nm in thin films. These tripodal molecules displayed wide optical bandgaps of (Eg opt ) 3.10 eV and 2.64 eV with very deep-lying HOMO energy levels (-6.60 eV and -6.03 eV) and low-lying LUMO levels (-3.50 eV and -3.40 eV). Appreciable electron mobilities of 5.24×10-4  cm2 /Vs and 6.14×10-4  cm2 /Vs were obtained for compounds Tr-Np3 and Tr-T-Np3 respectively by space-charge limited current (SCLC) measurements. Metal-free tripodal molecules Tr-Np3 and Tr-T-Np3 showed excellent photocatalytic abilities towards condensation of aromatic aldehydes and o-phenylenediamine followed by cyclization under visible light to yield benzimidazole derivatives that are of high medicinal value.

Effect of N-phenyl substituent on thermal, optical, electrochemical and luminescence properties of 3-aminophthalimide derivatives

The seven N-phthalimide derivatives substituted with the amine group at the 3-C position in the phenylene ring were synthesized. The effect of N-substituent chemical structure was investigated. The thermal, electrochemical and optical studies were performed and supported by the density functional theory calculations (DFT). The electrochemical investigations of the synthesized low-molecular phthalimides revealed the one oxidation and reduction process with the HOMO energy level under - 5.81 eV and energy-band gap below 3 eV. The N-phthalimide derivatives were emitted light in a blue spectral region in solutions (in polar and non-polar) with the quantum yield between 2 and 68%, dependent on the substituent at the nitrogen atom, solvent and concentration. The N-phthalimide derivatives were emissive also in a solid state as a thin film and powder. They were tested as a component of the active layer with PVK:PBD matrix and as an independent active layer in the organic light-emitting diodes. The registered electroluminescence spectra exhibited the maximum emission band in the 469-505 nm range, confirming the possibility of using N-phthalimides with PVK:PBD matrix as the blue emitters.

Electroactive Dyes Based on 1,8-Naphthalimide with Acetylene Linkers as Promising OLED Materials - the Relationship Between Structure and Photophysical Properties

Four A-π-D-π-A type small organic molecules with 1,8-naphthalimide motifs were successfully synthesised. The designed compounds are built of two 1,8-naphthalimide units linked via ethynyl π-linkages with selected functionalised donor motifs i. e. 2,2'-bithiophene, fluorene, phenothiazine and carbazole derivative. The synthesis based on Sonogashira cross-coupling allowed us to obtain the presented dyes with good yields. The resulting symmetrical small molecules' optical, electrochemical and thermal properties were thoroughly investigated, and their potential applicability for the OLED devices was demonstrated. In addition, the relationship between molecular structure and properties was considered by employing experimental and theoretical studies. As a result of using various donor groups, it was possible to achieve efficient electroluminescence in the range from green (DEV4) to orange-red light (DEV3) with a maximum luminance of 3 820 cd/m2 for DEV4. Upon the insertion of an acetylene linker to the designed molecules, the free rotation of D and A fragments, and hence the effective π-electron communication within the entire molecule, is possible, which was confirmed by DFT studies. The obtained dyes are characterised by high thermal stability, reversible oxidation-reduction process, satisfactory optoelectronic properties and good solubility in organic solvents, which is advisable for the application in small molecular organic light-emitting diodes (SM-OLEDs) technology.

Naphthalene Phthalimide Derivatives as Model Compounds for Electrochromic Materials

Electrochromism of organic compounds is a well-known phenomenon; however, nowadays, most research is focused on anodic coloring materials. Development of efficient, cathodic electrochromic materials is challenging due to the worse stability of electron accepting materials compared with electron donating ones. Nevertheless, designing stable cathodic coloring organic materials is highly desired-among other reasons-to increase the coloration performance. Hence, four phthalimide derivatives named 1,5-PhDI, 1,4-PhDI, 2,6-PhDI and 3,3'-PhDI were synthesized and analyzed in depth. In all cases, two imide groups were connected via naphthalene (1,5-PhDI, 1,4-PhDI, 2,6-PhDI) or 3,3'-dimethylnaphtidin (3,3'-PhDI) bridge. To observe the effect of chemical structure on physicochemical properties, various positions of imide bond were considered, namely, 1,5- 1,4- and 2,6-. Additionally, a compound with the pyromellitic diimide unit capped with two 1-naphtalene substituents was obtained. All compounds were studied in terms of their thermal behavior, using differential calorimetry (DSC) and thermogravimetric analysis (TGA). Moreover, electrochemical (CV, DPV) and spectroelectrochemical (UV-Vis and EPR) analyses were performed to evaluate the obtained materials in terms of their application as cathodic electrochromic materials. All obtained materials undergo reversible electrochemical reduction which leads to changes in their optical properties. In the case of imide derivatives, absorption bands related to both reduced and neutral forms are located in the UV region. However, importantly, the introduction of the 3,3'-dimethylnaphtidine bridge leads to a noticeable bathochromic shift of the reduced form absorption band of 3,3'-PhDI. This indicates that optimization of the phthalimide structure allows us to obtain stable, cathodic electrochromic materials.

Alkyl-Side-Chain Engineering of Nonfused Nonfullerene Acceptors with Simultaneously Improved Material Solubility and Device Performance for Organic Solar Cells

Two nonfullerene small molecules, TBTT-BORH and TBTT-ORH, which have the same thiophene-benzothiadiazole-thiophene (TBTT) core flanked with butyloctyl (BO)- and octyl (O)-substituted rhodanines (RHs) at both ends, respectively, are developed as electron acceptors for organic solar cells (OSCs). The difference between the alkyl groups introduced into TBTT-BORH and TBTT-ORH strongly influence the intermolecular aggregation in the film state. Differential scanning calorimetry and UV-vis absorption studies reveal that TBTT-ORH exhibited stronger molecular aggregation behavior than TBTT-BORH. On the contrary, the material solubility is greatly improved by the introduction of a BO group in TBTT-BORH, and the inevitably low molecular interaction and packing ability of the as-cast TBTT-BORH film can be effectively increased by a solvent-vapor annealing (SVA) treatment. OSCs based on the two acceptors and PTB7-Th as a polymer donor are fabricated owing to their complementary absorption and sufficient energy-level offsets. The best power conversion efficiency of 8.33% is obtained with the SVA-treated TBTT-BORH device, where, together with a high open-circuit voltage of 1.02 V, the charge-carrier mobility and the short-circuit current density were greatly improved by the SVA treatment to levels comparable to those of the TBTT-ORH device because of the suppressed charge recombination and improved film morphology. In this work, the simultaneous improvement of both material solubility and device performance is achieved through alkyl side-chain engineering to balance the trade-offs among material solubility/crystallinity/device performance.

Synthesis of aromatic imide tetramers relevant to organic electronics by direct (hetero)arylation

We report six tetrameric compounds synthesized via direct (hetero)arylation methods based on phthalimide, naphthalimide, and perylene diimide end groups with fused thiophene cores.

Naphtho[1,2-c:5,6-c']bis[1,2,5]thiadiazole-Based Nonfullerene Acceptors: Effect of Substituents on the Thiophene Unit on Properties and Photovoltaic Characteristics

The development of new electron-accepting π-conjugated systems for application as nonfullerene acceptors in organic solar cells (OSCs) is urgently needed. Although π-conjugated systems based on naphtho[1,2-c:5,6-c']bis[1,2,5]thiadiazole (NTz) and naphthalimide (Np) as central and terminal units, respectively, represent possible candidates for nonfullerene acceptors, our knowledge of the structure-property-device performance relationship of these compounds remains limited. We report herein on an investigation of the effect of the substituents on the thiophene (T) linker between NTz and Np on the properties and photovoltaic performance. The photophysical and physicochemical measurements showed that the absorption behavior as well as frontier-orbital energy levels can be fine-tuned by the choice of the substituent on the thiophene rings. Bulk-heterojunction-type OSCs based on these acceptors under blending with poly(3-hexylthiophene) as a donor showed various power conversion efficiencies, ranging from 0.26 to 2.14%. The substituents on the thiophene rings also have a significant influence on the blend film properties, which explain the differences in the short-circuit current densities and fill factors in the OSCs. These results indicate the importance of molecular design in preparing nonfullerene acceptors with NTz and Np units in terms of tuning both the molecular properties of the materials and donor-acceptor interface engineering in the blended films.

Direct (Hetero)Arylation for the Synthesis of Molecular Materials: Coupling Thieno[3,4-c]pyrrole-4,6-dione with Perylene Diimide to Yield Novel Non-Fullerene Acceptors for Organic Solar Cells

Herein we report on the synthesis of an N-annulated perylene diimide (PDI) disubstituted thieno[3,4-c]pyrrole-4,6-dione (TPD) molecular acceptor (PDI–TPD–PDI) by direct heteroarylation (DHA) methods. Three sets of DHA conditions that explore the effects of solvent, temperature, and catalyst were employed to find the optimal conditions for the synthesis of two PDI–TPD–PDI derivatives. We then selected one PDI–TPD–PDI for use as a non-fullerene acceptor in organic solar cell devices with the donor polymer PBDB-T. Active layer bulk-heterojunction blends were modified using several post-deposition treatments, including thermal annealing, solvent vapour annealing, and high boiling solvent additives. It was found that active layers cast from o-dichlorobenzene with a 3% v/v diphenylether additive yielded films with adequate phase separation, and subsequently gave the best organic solar cell performance, with power conversion efficiencies greater than 3%.

The Effect of Random and Block Copolymerization with Pendent Carbozole Donors and Naphthalimide Acceptors on Multilevel Memory Performance

Polymeric materials have been widely used in the fabrication of data-storage devices, owing to their unique advantages and defined conduction mechanisms. To date, the most-functional polymers that have been reported for memory devices were synthesized through random copolymerization, whilst there have been no reports regarding the memory effect of block polymers. Herein, we synthesized a random copolymer (PMCz₈ -co-PMBNa₂ ) and its corresponding block copolymer (PMCz₈ -b-PMBNa₂ ) to study the effect of the method of polymerization on the memory properties of the corresponding devices. Interestingly, both devices (ITO/PMCz₈ -co-PMBNa₂ /Al and ITO/PMCz₈ -b-PMBNa₂ /Al) exhibited ternary memory performance, with threshold voltages of -1.7 V/-3.3 V and -2.7 V/-3.8 V, respectively. However, based on comprehensive measurements, the memory properties of PMCz₈ -co-PMBNa₂ and PMCz₈ -b-PMBNa₂ were found to be owing to the operation of different conduction mechanisms, which resulted from different molecular stacking in the film state. Therefore, we expect that this work will be helpful for improving our understanding of the conduction mechanisms in polymer-based data-storage devices.

Structural variation determined by length-matching effects: towards the formation of flexible porous molecular crystals

The length ratio of the alkyl chain to the spacer will significantly influence the packing motif of gemini molecules.

Exploiting direct heteroarylation polymerization homocoupling defects for the synthesis of a molecular dimer

Molecular dimerization: an effective design strategy for spectral engineering.

Optimized synthesis of π-extended squaraine dyes relevant to organic electronics by direct (hetero)arylation and Sonogashira coupling reactions

This study reports on the synthesis and characterization of four molecular π-extended squaraine compounds relevant to the field of organic electronics.

Tetraphenylethene (TPE) modified polyhedral oligomeric silsesquioxanes (POSS): unadulterated monomer emission, aggregation-induced emission and nanostructural self-assembly modulated by the flexible spacer between POSS and TPE

Mono-TPE modified POSS molecules exhibit monomer and AIE emission under different conditions.