Activation of H2O2-HCO3- by Ca2Co2O5 for pollutant degradation

The bicarbonate-activated hydrogen peroxide (BAP) system is widely studied for organic pollutant degradation in wastewater treatment. Ca2Co2O5, a heterogeneous catalyst containing multivalent cobalt including Co(II) and Co(III), was herein investigated as a BAP activator, and Acid Orange 7 (AO7) was used as a model pollutant. Ca2Co2O5 exhibited good activation performance. The degradation rate and the initial rate constant of the Ca2Co2O5-activated BAP system were 5.4 and 11.2 times as high as the BAP system, respectively. The removal rate of AO7 reached 90.9% in 30 min under optimal conditions (AO7 20 mg/L, Ca2Co2O5 0.2 g/L, H2O2 1 mM, NaHCO3 5 mM, pH 8.5, 25℃). The Ca2Co2O5 catalyst exhibited good stability and recyclability, retaining 85% of AO7 removal rate in the fifth run. Compared to the BAP system, a lower dosage of H2O2 was required and a higher initial concentration of pollutants allowed for effective degradation in the Ca2Co2O5-BAP system. X-ray photoelectron spectroscopy was used to analyze the catalytic mechanism. The analysis showed that the good catalytic performance of Ca2Co2O5 attributes to its high proportion of oxygen vacancies and Co(III) species, and the presence of Ca. The active species O2•-, •OH, and 1O2 are responsible for the degradation, as indicated by the quenching experiments. The degradation mechanism of AO7 was speculated based on UV-Vis spectral analysis and the identification of degradation intermediates. The azo form, naphthalene and benzoic rings in the AO7 structure are destroyed in the decomposition. This research provides a feasible approach to designing effective and reusable BAP activators for pollutant degradation in wastewater treatment.

Oxygen doped graphitic carbon nitride nanosheets for the degradation of organic pollutants by activating hydrogen peroxide in the presence of bicarbonate in the dark

The development of novel wastewater treatment processes that use heterogeneous catalysts to activate hydrogen peroxide (H2O2) with bicarbonate (HCO3 -) has been a subject of great interest in recent years; however, significant challenges remain, despite research into numerous metal-based catalysts. The work presented herein employed oxygen-doped graphitic carbon nitride (O/g-C3N4) as a non-metal catalyst for activating H2O2 in the presence of HCO3 -, and this method represented the first system capable of removing organic pollutants in the dark, to our knowledge. The catalysts were characterized using several microscopic imaging, spectroscopic, electrochemical, and crystallographic techniques, as well as N2-physorption procedures. Analysis of the results revealed that the O/g-C3N4 catalyst possessed a high specific surface area and many defect sites. Various operational parameters, including the relative amounts of HCO3 -, H2O2, and O/g-C3N4, were systemically investigated. A clear performance enhancement was observed in the degradation of organic contaminants when subjected to the HCO3 --H2O2-O/g-C3N4 system, and this result was ascribed to the synchronous adsorption and chemical oxidation processes. The novel system presented herein represented a new water treatment technology that was effective for removing organic contaminants.

Non-radical PMS activation by the nanohybrid material with periodic confinement of reduced graphene oxide (rGO) and Cu hydroxides

A new strategy was applied by periodic stacking of active sites of Cu and reduced graphene oxide (rGO) in the form of Cu-rGO LDH nanohybrid material. The experimental results revealed that newly prepared Cu-rGO LDH nanohybrid material was extremely reactive in PMS activation as evident from the degradation rate of 0.115 min^-1, much higher than Mn-rGO LDH (0.071 min^-1), Zn-rGO LDH (0.023 min^-1) or other benchmarked material used during the degradation of bisphenol A (BPA). This excellent activity of Cu-rGO LDH nanohybrid was attributed to the better PMS utilization efficiency as compared to the other catalysts. Additionally, the characterization techniques disclosed that the layer by layer arrangement of active sites in the Cu-rGO LDH catalyst promotes interfacial electron mobility owing to the synergistic association between Cu in LDH and interlayered rGO. Based on the in-situ electron paramagnetic resonance spectroscopy (EPR) and chemical scavengers, singlet oxygen (¹O₂) was unveiled as dominant reactive species for pollutant removal, resulting from the recombination of superoxides (O₂^-) or reduction of active Cu centers. We believe that this novel Cu-rGO LDH/PMS system will open up a new avenue to design efficient metal-carbon nanohybrid catalysts for the degradation of emerging aquatic pollutants in a real application.

Facile synthesis of laccase mimic Cu/H3BTC MOF for efficient dye degradation and detection of phenolic pollutants

Herein, we report an effectual method for designing a novel form of nanozyme laccase mimic namely Cu/H3BTC, using copper ions and 1,3,5-benzene tricarboxylic acid (1,3,5-H3BTC). This Cu-based metal-organic framework (MOF) was synthesized through a simple procedure of mixing of two usual reagents at room temperature. Amido Black 10B (AB-10B) was chosen as a model dye for degradation consequences. Results showed that Cu/H3BTC MOF revealed significantly higher catalytic efficacy under certain conditions like high pH, extreme temperature and high salt conditions and it has long-term storage stability, which can lead to a significant decline in catalytic activity of laccase. In addition, the degradation of AB-10B was up to 60% after ten cycles, showing good recyclability of Cu/H3BTC MOF. The UV-visible spectral changes clearly showed that Cu/H3BTC MOF is an effective laccase mimic for the degradation of azo dye AB-10B, which was degraded more easily within the time duration of 60 min. The Cu/H3BTC MOF also possessed fundamental activities like laccase with regard to oxidation of the phenolic compounds. Moreover, a technique for the quantitative detection of epinephrine by Cu/H3BTC MOF was established. These findings help to understand the laccase-like reactivity and provide a basis for the future design and application of metal-based catalysts.

Hybridization of Nanodiamond and CuFe-LDH as Heterogeneous Photoactivator for Visible-Light Driven Photo-Fenton Reaction: Photocatalytic Activity and Mechanism

Establishing a heterojunction for two kinds of semiconductor catalysts is a promising way to enhance photocatalytic activity. In this study, nanodiamond (ND) and CuFe-layered double hydroxide (LDH) were hybridized by a simple coprecipitation method as a novel heterojunction to photoactivate H2O2. The ND/LDH possessed a hydrotalcite-like structure, large specific surface area (SBET = 99.16 m2/g), strong absorption of visible-light and low band gap (Eg = 0.94 eV). Under the conditions of ND/LDH dosage 0.0667 g/L, H2O2 concentration 19.6 mmol/L, and without initial pH adjustment, 93.5% of 10 mg/L methylene blue (MB) was degraded within 120 minutes, while only 78.3% of MB was degraded in the presence of LDH instead of ND/LDH. The ND/LDH exhibited excellent stability and maintained relatively high activity, sufficient to photoactivate H2O2 even after five recycles. The mechanism study revealed that in the heterojunction of ND/LDH, the photoelectrons transferred from the valence band of LDH (Cu/Fe 3d t2g) to the conduction band of LDH (Cu/Fe 3d eg) could spontaneously migrate onto the conduction band of ND, promoting the separation of photo-induced charges. Thus, the photoelectrons had sufficient time to accelerate the redox cycles of Cu3+/Cu2+ and Fe3+/Fe2+ to photoactivate H2O2 to produce hydroxyl radicals, resulting in excellent photo-Fenton efficiency on MB degradation.

Pd based in situ AOPs with heterogeneous catalyst of FeMgAl layered double hydrotalcite for the degradation of bisphenol A and landfill leachate through multiple pathways

In situ degradation of organic contaminants by Pd and electro-generated H₂ and O₂ overcomes the drawbacks to traditional Fenton process, and conducting heterogeneous catalyst of FeMgAl layered double hydrotalcite (LDH) further improved the efficiency and stability. Using bisphenol A (BPA) as the model contaminants, 90% removal can be achieved with 1200 mg/L Pd/Al₂O₃ and FeMgAl-2. The reusability was satisfying due to the very limited leaching of Fe ions at 0.1 ppm level. FeMgAl also amplified the window of pH for Pd-catalyzed in situ advanced oxidation processes (AOPs) from 3 by homogenous Fe(II) to 3-7 by FeMgAl LDH. The COD of landfill leachate effluent of the MBR system removed by about 52.3% by this system by the initial pH was 5. Characterizations revealed the distinguishing features associated with LDH structure such as large surface area, good stability, basic character, and strong linage among active sites were accounted for the remarkable performances over a wide pH window. Five reactive intermediates were observed and multiple degradation pathways were proposed in Pd-catalyzed in situ AOP for the first time. Interestingly, because of the unique role of Pd catalyst, these degradation pathways were clearly distinguished from traditional Fenton or Fenton-like AOPs and may provide a new approach of in situ heterogeneous AOPs for refractory contaminants in future.

Multipath fabrication of hierarchical CuAl layered double hydroxide/carbon fiber composites for the degradation of ammonia nitrogen

In this work, a series of flower-like CuAl layered double hydroxides (LDHs) and hierarchical CuAl/carbon fiber-LDH (CuAl/CF-LDH) materials were synthesized, and these materials were used as catalysts for the degradation of ammonia nitrogen from simulated wastewater. The morphologies and structures of the materials were characterized using scanning electron microscopy (SEM), Fourier transform infrared (FTIR) spectroscopy, Raman spectroscopy (RS), X-ray diffraction (XRD), and the Brunauer-Emmett-Teller (BET) technique. The effects of the catalyst and H₂O₂ loading dosages, reaction temperature, pH, Cu/Al ratio of the samples, and contact time on the degradation process were investigated by degrading ammonia nitrogen under different conditions, and the possible degradation mechanism was discussed. CuAl/CF-LDH exhibited more effectively catalytically degradation of ammonia nitrogen than others as-prepared samples, and removal efficiency reached 99.7% under the optimized conditions. The reusing capability and stability of the materials were studied. Meanwhile, the versatility of the materials was investigated by testing their performance in the absorption of azo dye, the highest removal efficiency was found to be 99.28%. The prepared materials are promising for use as effective catalysts for the degradation of ammonia nitrogen from wastewater.

Nanocrystalline Cellulose-Derived Doped Carbonaceous Material for Rapid Mineralization of Nitrophenols under Visible Light

Nitrophenols (NPs) and related derivatives are industrially important chemicals, used notably to synthesize pharmaceuticals, insecticides, herbicides, and pesticides. However, NPs and their metabolites are highly toxic and mutagenic. They pose a serious threat to human health and ecosystem. Current work was undertaken to develop a suitable visible-light active catalyst for the sustainable and efficient mineralization of NPs in an aqueous environment. Nanocrystalline cellulose (NCs)-based nitrogen-doped titanium dioxide and carbonaceous material (N-TiO₂/C) was synthesized by pyrolysis and sol-gel methods using NCs, polydopamine, and TiO₂. The synthesized N-TiO₂/C was characterized using different analytical techniques. Photocatalytic degradation of NPs under visible light indicated that acidic pH (3) was most suitable for the optimal degradation. 4-NP degradation followed both pseudo-first-order (R ² = 0.9985) and Langmuir-Hinshelwood adsorption kinetic models (adsorption constant, K _LH = 1.13 L mg^-1). Gas chromatography-mass spectrometry and ion chromatography analysis confirmed the total mineralization of 4-NP into smaller molecular fragments such as acids, alcohols, and nitrates. The total organic carbon showed that 67% of total carbon present in 4-NP was mineralized into CO₂ and CO. The catalyst was recycled for five consecutive cycles without losing its catalytic activities. The degradation mechanism of NPs with N-TiO₂/C was also explored.

Facile synthesis of yolk shell Mn2O3@Mn5O8 as an effective catalyst for peroxymonosulfate activation

The Mn₂O₃@Mn₅O₈ catalyst exhibits unique structural properties for catalytic activities and shows efficient performance for the degradation of 4-CP in a PMS system.