Tuning the oxidation state of manganese oxide nanoparticles on oxygen- and nitrogen-functionalized carbon nanotubes for the electrocatalytic oxygen evolution reaction

Caveat Emptor: Commercialized Manganese Oxide Nanoparticles Exhibit Unintended Properties

Nano-encapsulated manganese oxide (NEMO) particles are noteworthy contrast agents for magnetic resonance imaging (MRI) due to their bright, pH-switchable signal ("OFF" to "ON" at low pH), high metal loading, and targeting capability for increased specificity. For the first time, we performed a head-to-head comparison of NEMO particles from In-house and commercialized sources (US Nano vs Nanoshel) to assess their potential as bright T₁ MRI contrast agents. Manganese oxide nanocrystals (MnO, Mn₂O₃, and Mn₃O₄) were systematically evaluated for size, chemistry, release of manganese ions, and MRI signal pre- and post-encapsulation within poly(lactic-co-glycolic acid) (PLGA). Suprisingly, a majority of the commercialized formulations were not as advertised by displaying unintended sizes, morphologies, chemistry, dissolution profiles, and/or MRI signal that precludes in vivo use. US Nano's Mn₃O₄ and Mn₂O₃ nanocrystals contained impurities that impacted Mn ion release as well as micron-sized rodlike structures. Nanoshel's MnO and Mn₂O₃ nanoparticles had very large hydrodynamic sizes (>600 nm). In-house MnO and Nanoshel's Mn₃O₄ nanoparticles demonstrated the best characteristics with brighter T₁ MRI signals, small hydrodynamic sizes, and high encapsulation efficiencies. Our findings highlight that researchers must confirm the properties of purchased nanomaterials before utilizing them in desired applications, as their experimental success may be impacted.

Oxygen evolving reactions catalyzed by different manganese oxides: the role of oxidation state and specific surface area

A set of the four manganese oxide powders α-MnO2 (hollandite), δ-MnO2 (birnessite), Mn2O3 (bixbyite), and Mn3O4 (hausmannite) have been synthesized in a phase-pure form and tested as catalysts in three different oxygen evolution reactions (OER): electrochemical OER in KOH (1 mol L−1), chemical OER using aqueous cerium ammonium nitrate, and H2O2 decomposition. The trends in electrochemical (hollandite >> bixbyite > birnessite > hausmannite) and chemical OER (hollandite > birnessite > bixbyite > hausmannite) are different, which can be explained by differences in electric conductivity. H2O2 decomposition and chemical OER, on the other hand, showed the same trend and even a linear correlation of their initial OER rates. A linear correlation between the catalytic performance and the manganese oxidation state of the catalysts was observed. Another trend was observed related to the specific surface area, highlighting the importance of these properties for the OER. Altogether, hollandite was found to be the best performing catalyst in this study due to a combination of the high manganese oxidation state and a large specific surface area. Likely, due to a sufficient electrical conductivity, this intrinsically high OER performance is also found to some extent in electrocatalysis for this specific example.

PEGylation of Metal Oxide Nanoparticles Modulates Neutrophil Extracellular Trap Formation

Novel metal oxide nanoparticle (NP) contrast agents may offer safety and functionality advantages over conventional gadolinium-based contrast agents (GBCAs) for cancer diagnosis by magnetic resonance imaging. However, little is known about the behavior of metal oxide NPs, or of their effect, upon coming into contact with the innate immune system. As neutrophils are the body's first line of defense, we sought to understand how manganese oxide and iron oxide NPs impact leukocyte functionality. Specifically, we evaluated whether contrast agents caused neutrophils to release web-like fibers of DNA known as neutrophil extracellular traps (NETs), which are known to enhance metastasis and thrombosis in cancer patients. Murine neutrophils were treated with GBCA, bare manganese oxide or iron oxide NPs, or poly(lactic-co-glycolic acid) (PLGA)-coated metal oxide NPs with different incorporated levels of poly(ethylene glycol) (PEG). Manganese oxide NPs elicited the highest NETosis rates and had enhanced neutrophil uptake properties compared to iron oxide NPs. Interestingly, NPs with low levels of PEGylation produced more NETs than those with higher PEGylation. Despite generating a low rate of NETosis, GBCA altered neutrophil cytokine expression more than NP treatments. This study is the first to investigate whether manganese oxide NPs and GBCAs modulate NETosis and reveals that contrast agents may have unintended off-target effects which warrant further investigation.

Electrode surface embedded manganese(iii)–pincer complexes: efficient electrocatalysts for the oxygen evolution reaction

Highly stable and robust gold electrode surface anchored Mn(iii)–pincer complex exhibits an excellent electrocatalytic activity towards the oxygen evolution reaction at a low overpotential with a medium Tafel slope under neutral pH condition.

Particle size-controlled synthesis of high-performance MnCo-based materials for alkaline OER at fluctuating potentials

Mn and Co containing nanocubes were produced by hydrothermal synthesis. The materials consist of metal spinels and carbonates, where spinels ensure high activity and carbonates contribute to high stability in the oxygen evolution reaction.

Factors Governing the Activity of α-MnO2 Catalysts in the Oxygen Evolution Reaction: Conductivity versus Exposed Surface Area of Cryptomelane

Cryptomelane (α-(K)MnO2 ) powders were synthesized by different methods leading to only slight differences in their bulk crystal structure and chemical composition, while the BET surface area and the crystallite size differed significantly. Their performance in the oxygen evolution reaction (OER) covered a wide range and their sequence of increasing activity differed when electrocatalysis in alkaline electrolyte and chemical water oxidation using Ce4+ were compared. The decisive factors that explain this difference were identified in the catalysts' microstructure. Chemical water oxidation activity is substantially governed by the exposed surface area, while the electrocatalytic activity is determined largely by the electric conductivity, which was found to correlate with the particle morphology in terms of needle length and aspect ratio in this sample series. This correlation is rather explained by an improved conductivity due to longer needles than by structure sensitivity as was supported by reference experiments using H2 O2 decomposition and carbon black as additive. The most active catalyst R-cryptomelane reached a current density of 10 mA cm-2 at a potential 1.73 V without, and at 1.71 V in the presence of carbon black. The improvement was significantly higher for the catalyst with lower initial activity. However, the materials showed a disappointing catalytic stability during alkaline electrochemical OER, whereas the crystal structure was found to be stable at working conditions.

Tuning the size and composition of manganese oxide nanoparticles through varying temperature ramp and aging time

Manganese oxide (MnO) nanoparticles (NPs) can serve as robust pH-sensitive contrast agents for magnetic resonance imaging (MRI) due to Mn2+ release at low pH, which generates a ~30 fold change in T1 relaxivity. Strategies to control NP size, composition, and Mn2+ dissolution rates are essential to improve diagnostic performance of pH-responsive MnO NPs. We are the first to demonstrate that MnO NP size and composition can be tuned by the temperature ramping rate and aging time used during thermal decomposition of manganese(II) acetylacetonate. Two different temperature ramping rates (10°C/min and 20°C/min) were applied to reach 300°C and NPs were aged at that temperature for 5, 15, or 30 min. A faster ramping rate and shorter aging time produced the smallest NPs of ~23 nm. Shorter aging times created a mixture of MnO and Mn3O4 NPs, whereas longer aging times formed MnO. Our results indicate that a 20°C/min ramp rate with an aging time of 30 min was the ideal temperature condition to form the smallest pure MnO NPs of ~32 nm. However, Mn2+ dissolution rates at low pH were unaffected by synthesis conditions. Although Mn2+ production was high at pH 5 mimicking endosomes inside cells, minimal Mn2+ was released at pH 6.5 and 7.4, which mimic the tumor extracellular space and blood, respectively. To further elucidate the effects of NP composition and size on Mn2+ release and MRI contrast, the ideal MnO NP formulation (~32 nm) was compared with smaller MnO and Mn3O4 NPs. Small MnO NPs produced the highest amount of Mn2+ at acidic pH with maximum T1 MRI signal; Mn3O4 NPs generated the lowest MRI signal. MnO NPs encapsulated within poly(lactide-co-glycolide) (PLGA) retained significantly higher Mn2+ release and MRI signal compared to PLGA Mn3O4 NPs. Therefore, MnO instead of Mn3O4 should be targeted intracellularly to maximize MRI contrast.

A sol-gel synthesis to prepare size and shape-controlled mesoporous nanostructures of binary (II-VI) metal oxides

A base-catalyzed sol–gel approach combined with a solvent-driven self-assembly process at low temperature is augmented to make manganese oxide (Mn₃O₄), copper oxide (CuO), and magnesium hydroxide (Mg(OH)₂) nanostructures with size- and shape-controlled morphologies. Nanostructures of Mn₃O₄ with either hexagonal, irregular particle, or ribbon shape morphologies with an average diameter ranged from 100 to 200 nm have been prepared in four different solvent types. In all morphologies of Mn₃O₄, the experimental XRD patterns have indexed the nanocrystal unit cell structure to triclinic. The hexagonal nanoparticles of Mn₃O₄ exhibit high mesoporocity with a BET surface area of 91.68 m² g⁻¹ and BJH desorption average pore diameter of ∼28 nm. In the preparation of CuO nanostructures, highly nanoporous thin sheets have been produced in water and water/toluene solvent systems. The simulated XRD pattern matches the experimental XRD patterns of CuO nanostructures and indexes the nanocrystal unit cell structure to monoclinic. With the smallest desorption total pore volume of 0.09 cm³ g⁻¹, CuO nanosheets have yielded the lowest BET surface area of 18.31 m² g⁻¹ and a BHJ desorption average pore diameter of ∼16 nm. The sol of magnesium hydroxide nanocrystals produces highly nanoporous hexagonal nanoplates in water and water/toluene solvent systems. The wide angle powder XRD patterns show well-defined Bragg's peaks, indexing to a hexagonal unit cell structure. The hexagonal plates show a significantly high BET surface area (72.31 m² g⁻¹), which is slightly lower than the surface area of Mn₃O₄ hexagonal nanoparticles. The non-template driven sol–gel synthesis process demonstrated herein provides a facile method to prepare highly mesoporous and nanoporous nanostructures of binary (II–IV) metal oxides and their hydroxide derivatives, enabling potential nanostructure platforms with high activities and selectivities for catalysis applications.

A base-catalyzed sol–gel approach combined with a solvent-driven self-assembly process at low temperature is augmented to make highly mesoporous metal oxide nanostructures of manganese and copper, and hydroxide nanostructures of magnesium.

Synergistic Control of Structural Disorder and Surface Bonding Nature to Optimize the Functionality of Manganese Oxide as an Electrocatalyst and a Cathode for Li-O2 Batteries

An efficient way to improve the electrocatalyst and Li-O₂ battery performances of metal oxide is developed by an exquisite synergistic control over structural disorder and surface bonding nature. The effects of amorphous nature and surface chemical environment on the functionalities of metal oxide are systematically investigated with well-crystalline and amorphous MnO₂ nanocrystals with/without surface anchoring of highly oxidized iodate clusters. The amorphous MnO₂ nanocrystal containing anchored iodate clusters shows much better performance as an oxygen evolution electrocatalyst and cathode catalyst for Li-O₂ batteries than both iodate-free amorphous and well-crystalline homologues, underscoring the remarkable advantage of simultaneous enhancement of structural disorder and surface electron density. In situ X-ray absorption spectroscopic analysis demonstrates the promoted formation of double (MnO) bond, a critical step of oxygen evolution reaction, upon amorphization caused by the poor orbital overlap inside highly disordered crystallites. The beneficial effects of iodate anchoring and amorphization on electrocatalyst functionality are attributable to the alteration of surface bonding character, stabilization of Jahn-Teller active Mn³⁺ species, and enhanced charge transfer of interfaces. The present study underscores that fine-tuning of structural disorder and surface bonding nature provides an effective methodology to explore efficient metal oxide-based electrocatalysts.

Two-way desorption coupling to enhance the conversion of syngas into aromatics by MnO/H-ZSM-5

We herein report a composite catalyst containing partially reducible and highly active manganese oxide and nano-size H-ZSM-5 with short b-axis, prepared for the direct conversion of syngas into aromatics.

Oxidative Deposition of Manganese Oxide Nanosheets on Nitrogen-Functionalized Carbon Nanotubes Applied in the Alkaline Oxygen Evolution Reaction

The development of nonprecious catalysts for water splitting into hydrogen and oxygen is one of the major challenges to meet future sustainable fuel demand. Herein, thin layers of manganese oxide nanosheets supported on nitrogen-functionalized carbon nanotubes (NCNTs) were formed by the treatment of NCNTs dispersed in aqueous solutions of KMnO₄ or CsMnO₄ under reflux or under hydrothermal (HT) conditions and used as electrocatalysts for the oxygen evolution reaction (OER) in alkaline media. The samples were characterized by X-ray photoelectron spectroscopy, X-ray diffraction, transmission electron microscopy, and Raman spectroscopy. Our results show that the NCNTs treated under reflux were covered by partly amorphous and birnessite-type manganese oxides, while predominantly crystalline birnessite manganese oxide was observed for the hydrothermally treated samples. The latter showed, depending on the temperature during synthesis, an electrocatalytically favorable reduction from birnessite-type MnO₂ to γ-MnOOH. OER activity measurements revealed a decrease of the overpotential for the OER at a current density of 10 mA cm^-2 from 1.70 V_RHE for the bare NCNTs to 1.64 V_RHE for the samples treated under reflux in the presence of KMnO₄. The hydrothermally treated samples afforded the same current density at a lower potential of 1.60 V_RHE and a Tafel slope of 75 mV dec^-1, suggesting that the higher OER activity is due to γ-MnOOH formation. Oxidative deposition under reflux conditions using CsMnO₄ along with mild HT treatment using KMnO₄, and low manganese loadings in both cases, were identified as the most suitable synthetic routes to obtain highly active MnO _x /NCNT catalysts for electrochemical water oxidation.

Carbon nanotube containing polyacrylonitrile materials for the oxygen evolution reaction

Composite materials of polyacrylonitrile (PAN) and CNT are efficient metal-free catalysts for OER reaching a minimum overpotential of 368 mV.