Mechanisms induced by transition metal contaminants and their effect on the hydrothermal stability of zirconia-containing bioceramics: an XPS study

Annealing-Induced Off-Stoichiometric and Structural Alterations in Ca2+- and Y3+-Stabilized Zirconia Ceramics

In the current study, high-temperature stability was investigated in two types of zirconia ceramics stabilized with two different additives, namely, calcia and yttria. The evolutions of structure and oxygen-vacancy-related defects upon annealing in air were investigated as a function of temperature by combining X-ray diffractometry with Raman, X-ray photoelectron and cathodoluminescence spectroscopies. We systematically characterized variations in the concentration of oxygen vacancies and hydroxyl groups during thermal treatments and linked them to structural alterations and polymorphic transformation. With this approach, we clarified how the combined effects of different dopants and temperature impacted on structural development and on the thermal stability of the oxygen-vacancy-related defect complex.

Hydrothermal-aging-induced lattice distortion in yttria-stabilized zirconia using EBSD technique

The destabilization problem is of importance in the application of yttria-stabilized zirconia (YSZ) bio-ceramic in the oral environment due to phase transformation between tetragonal to monoclinic. Thus, in this study, the lattice distortion induced by hydrothermal aging in yttria-stabilized zirconia (YSZ) was investigated, in which YSZ specimens were subjected to hydrothermal-aging treatment for 0-48 h. The Kikuchi-band based method was employed to calculate the lattice distortion after phase transformation and the results from EBSD were compared with these obtained by X-ray diffraction (XRD). Both measurement methods showed a similar tendency of the lattice change in the a- and c- axes. EBSD results showed that the strain rates were 7.98 % and -5.03 % at the a- and c-axes, respectively. A significant decrease in the c/a ratio from 1.429 to 1.257 for the tetragonal matrix after 48 h aging is observed, which indicated Kikuchi-band based method using EBSD technique can successfully determine the local strain in tetragonal matrices.

Burst Strength of BIOLOX®delta Femoral Heads and Its Dependence on Low-Temperature Environmental Degradation

Zirconia-toughened alumina (ZTA) currently represents the bioceramic gold standard for load-bearing components in artificial hip joints. ZTA is long known for its high flexural strength and fracture toughness, both properties arising from a microscopic crack-tip shielding mechanism due to the stress-induced tetragonal-to-monoclinic (t→m) polymorphic transformation of zirconia. However, there have been concerns over the years regarding the long-term structural performance of ZTA since the t→m transformation also spontaneously occurs at the material’s surface under low-temperature environmental conditions with a concomitant degradation of mechanical properties. Spontaneous surface degradation has been extensively studied in vitro, but predictive algorithms have underestimated the extent of in vivo degradation observed in retrievals. The present research focused on burst-strength assessments of Ø28 mm ZTA femoral before and after long-term in vitro hydrothermal ageing according to ISO 7206-10. An average burst strength of 52 kN was measured for pristine femoral heads. This value was ~36% lower than results obtained under the same standard conditions by other authors. A further loss of burst strength (~13% in ultimate load) was observed after hydrothermal ageing, with increased surface monoclinic content ranging from ~6% to >50%. Nevertheless, the repetitively stressed and hydrothermally treated ZTA heads exceeded the minimum burst strength stipulated by the US Food and Drug Administration (FDA) despite severe test conditions. Lastly, Raman spectroscopic assessments of phase transformation and residual stresses on the fracture surface of the femoral heads were used to clarify burst-strength fluctuations and the effect of hydrothermal ageing on the material’s overall strength degradation.