Separation of phenolic acids by centrifugal partition chromatography

One-step enrichment of phenolics from Chaenomeles speciosa (Sweet) Nakai fruit using macroporous resin: Adsorption/desorption characteristics, process optimization and UPLC-QqQ-MS/MS-based quantification

Chaenomeles speciosa (Sweet) Nakai fruit is a good source of phenolics with many health benefits. In this work, the enrichment of C. speciosa fruit total phenolics (CSFTP) using macroporous resins was studied. NKA-Ⅱ resin was selected for enriching CSFTP due to its highest adsorption/desorption quantity. Adsorption characteristics of CSFTP on NKA-Ⅱ resin exhibited a good fit with the Langmuir isotherm model and pseudo-second order kinetics model. This adsorption was spontaneous, exothermic, and entropy-decreasing through a physisorption mechanism. The breakthrough-elution curves were studied to optimize CSFTP enrichment conditions. One-step enrichment increased CSFTP content in the extracts from 26.51 % to 78.63 %, with a recovery of 81.03 %. A UPLC-QqQ-MS/MS method in multiple reaction monitoring (MRM) mode was established and validated for the simultaneous quantification of seven phenolic compounds. This study demonstrates the feasibility of industrial enrichment of CSFTP using NKA-Ⅱ resin and proposes a reliable method for quality control of CSFTP-rich products.

Separation of natural compounds using eutectic solvent-based biphasic systems and centrifugal partition chromatography

A study on the formation of ternary biphasic systems composed of heptane, 1-butanol or ethyl acetate and type III or type V deep eutectic solvents based on levulinic acid and choline chloride or thymol was carried. Binodal curves and densities and phase compositions of phases in equilibrium for seven systems are reported. The partition coefficients of six natural compounds, namely quercetin, apigenin, coumarin, β-ionone, retinol, and α-tocopherol, in these systems were measured. Results show that the influence of choline chloride on the partition coefficients is more significant in systems with 1-butanol or ethyl acetate than previously reported for ethanol, and that the separation of natural compounds is worst when using DES containing thymol instead of choline chloride. Based on these partition coefficients, one system composed of heptane, 1-butanol and the DES choline chloride:levulinic acid at molar ratio 1:3 was selected to be applied in centrifugal partition chromatography, and the results obtained confirmed that it allows a good separation of apigenin, coumarin, β-ionone and α-tocopherol.

Extraction and characterization of phenolic compounds and their potential antioxidant activities

For thousands of years, plant has been widely applied in the medical area and is an important part of human diet. A high content of nutrients could be found in all kinds of plants, and the most outstanding group of nutrients that attracts scientists' attention is the high level of phenolic compounds. Due to the relationship between high phenolic compound content and high antioxidant capacity, plant extracts are expected to become a potential treatment for oxidation stress diseases including diabetes and cancer. However, according to the instability of phenolic compounds to light and oxygen, there are certain difficulties in the extraction of such compounds. But after many years of development, the extraction technology of phenolic compounds has been quite stable, and the only problem is how to obtain high-quality extracts with high efficiency. To further enhance the value of plant extracts, concentration and separation methods are often applied, and when detailed analysis is required, characterization methods including HPLC and LC/GC-MS will be applied to evaluate the number and type of phenolic compounds. A series of antioxidant assays are widely performed in numerous studies to test the antioxidant capacity of the plant extracts, which is also an important basis for evaluating value of extracts. This paper intends to provide a view of a variety of methods used in plants' phenolic compound extraction, separation, and characterization. Furthermore, this review presents the advantages and disadvantages of techniques involved in phenolic compound research and provides selected representative bibliographic examples.

Selective Separation of Vanillic Acid from Other Lignin-Derived Monomers Using Centrifugal Partition Chromatography: The Effect of pH

In this work, centrifugal partition chromatography (CPC) assisted by a polyethylene glycol (PEG)/sodium polyacrylate (NaPA) aqueous biphasic system (ABS) was applied in the separation of five lignin-derived monomers (vanillin, vanillic acid, syringaldehyde, acetovanillone, and p-hydroxybenzaldehyde). The influence of the system pH (unbuffered, pH 5, and pH 12) and added electrolytes (inorganic salts or ionic liquids (ILs)) on the compound partition was initially evaluated. The obtained data revealed that ILs induced more adequate partition coefficients (K < 5) than inorganic salts (K > 5) to enable separation performance in CPC, while alkaline conditions (pH 12) demonstrated a positive impact on the partition of vanillic acid. CPC runs, with buffered ABS at pH 12, enabled a selective separation of vanillic acid from other lignin monomers. Under these conditions, a distinct interaction between the top (PEG-rich) and bottom (NaPA-rich) phases of the ABS with the double deprotonated form of vanillic acid is expected when compared to the remaining lignin monomers (single deprotonated). This is an impactful result that shows the pH to be a crucial factor in the separation of lignin monomer compounds by CPC, while only unbuffered systems have been previously studied in the literature. Finally, the recovery of vanillic acid up to 96% purity and further recycling of ABS phase-forming components were approached as a proof of concept through the combination of ultrafiltration and solid-phase extraction steps.

Carotenoid Production from Microalgae: The Portuguese Scenario

Microalgae have an outstanding capacity to efficiently produce value-added compounds. They have been inspiring researchers worldwide to develop a blue biorefinery, supporting the development of the bioeconomy, tackling the environmental crisis, and mitigating the depletion of natural resources. In this review, the characteristics of the carotenoids produced by microalgae are presented and the downstream processes developed to recover and purify them are analyzed, considering their main applications. The ongoing activities and initiatives taking place in Portugal regarding not only research, but also industrialization under the blue biorefinery concept are also discussed. The situation reported here shows that new techniques must be developed to make microalgae production more competitive. Downstream pigment purification technologies must be developed as they may have a considerable impact on the economic viability of the process. Government incentives are needed to encourage a constructive interaction between academics and businesses in order to develop a biorefinery that focuses on high-grade chemicals.

From Lignin to Valuable Aromatic Chemicals: Lignin Depolymerization and Monomer Separation via Centrifugal Partition Chromatography

Lignin has long been recognized as a potential feedstock for aromatic molecules; however, most lignin depolymerization methods create a complex mixture of products. The present study describes an alkaline aerobic oxidation method that converts lignin extracted from poplar into a collection of oxygenated aromatics, including valuable commercial compounds such as vanillin and p-hydroxybenzoic acid. Centrifugal partition chromatography (CPC) is shown to be an effective method to isolate the individual compounds from the complex product mixture. The liquid-liquid extraction method proceeds in two stages. The crude depolymerization mixture is first subjected to ascending-mode extraction with the Arizona solvent system L (pentane/ethyl acetate/methanol/water 2:3:2:3), enabling isolation of vanillin, syringic acid, and oligomers. The remaining components, syringaldehyde, vanillic acid, and p-hydroxybenzoic acid (pHBA), were resolved by using ascending-mode extraction with solvent mixture comprising dichloromethane/methanol/water (10:6:4) separation. These results showcase CPC as an effective technology that could provide scalable access to valuable chemicals from lignin and other biomass-derived feedstocks.

Bioassay-Guided Isolation of Two Eudesmane Sesquiterpenes from Lindera strychnifolia Using Centrifugal Partition Chromatography

In this study, a centrifugal partition chromatography (CPC) separation was applied to identify antioxidant-responsive element (ARE) induction molecules from the crude extract of Lindera strychnifolia roots. CPC was operated with a two-phase solvent system composed of n-hexane-methanol-water (10:8.5:1.5, v/v/v) in dual mode (descending to ascending), which provided a high recovery rate (>95.5%) with high resolution. Then, ARE induction activity of obtained CPC fractions was examined in ARE-transfected HepG2 cells according to the weight ratios of the obtained fractions. The fraction exhibiting ARE-inducing activity was further purified by preparative HPLC that led to isolation of two eudesmane type sesquiterpenes as active compounds. The chemical structures were elucidated as linderolide U (1) and a new sesquiterpene named as linderolide V (2) by spectroscopic data. Further bioactivity test demonstrated that compounds 1 and 2 enhanced ARE activity by 22.4-fold and 7.6-fold, respectively, at 100 μM concentration while 5 μM of sulforaphane induced ARE activity 24.8-fold compared to the control.