A FRET-based fluorescent and colorimetric probe for the specific detection of picric acid

Recent advances in colorimetric and photoluminescent fibrillar devices, photonic crystals and carbon dot-based sensors for mercury (II) ion detection

The escalating environmental contamination with mercury has become a pressing issue, significantly impacting human beings and nature. For instance, small-scale gold mining has led to severe contamination in the Brazilian Yanomami village, highlighting the urgent need for action. The development of fibrillar-based sensors for mercury (II) ions represents an important issue to be considered in the point-of-care and simple detection of contaminants in water. Herein, this review discussed different colorimetric/photoluminescent-based prototypes for Hg2+ ions sensors and corresponding strategies to improve selectivity and sensitivity associated with the regeneration and reuse of the devices. Given these aspects, the electrospinning technique is promising for developing advanced mercury (II) ion sensors.

Selective sensing of picric acid using a Zn(II)-metallacycle: experimental and theoretical validation of the sensing mechanism and quantitative analysis of sensitivity in contact mode detection

A combination of N,N',N''-tris(3-pyridyl)-1,3,5-benzenetricarboxamide (L1) and p-chlorobenzoic acid (HL2) with Zn(NO3)2·6H2O resulted in the formation of a dinuclear metallacycle [ZnL1(L2)2(DMF)2]2 (1(DMF)4). In 1(DMF)4, the Zn(II) centre adopts a square pyramidal geometry, while one of the pyridyl N out of the three pyridyl groups in L1 remained uncoordinated. Solvated DMF molecules are present in 1(DMF)4. The structural and chemical nature of 1(DMF)4 is effective for it to act as a potential fluorescent probe for the detection of nitroaromatic compounds. It is observed that the probe, 1(DMF)4, could selectively detect picric acid (PA) among various aromatic compounds in solution (DMSO), while the solid state (contact mode) detection showed a positive sensing response for the nitrophenols (PA: 87% quenching efficiency, 2,4-dinitrophenol (2,4-DNP): 57% quenching efficiency and 4-nitrophenol (4-NP): 40% quenching efficiency). The limit of detection (LOD) of PA by the probe in DMSO was found to be 6.8 × 10-11 M while the LOD in contact mode detection was estimated to be 0.49 ng cm-2. The mechanism of selective detection of PA by 1(DMF)4 in DMSO was analyzed through photophysical studies, 1H-NMR experiments and also by density functional theory (DFT) calculations. The effective overlap of the absorption spectrum of 1(DMF)4 and emission spectrum of PA in DMSO suggests that the Förster resonance energy transfer (FRET) is responsible for quenching phenomena in DMSO. The DFT calculations and molecular docking studies showed the adduct formation due to the favorable interactions between 1(DMF)4 and PA in DMSO, while negligible interactions were observed between 1(DMF)4 with other aromatic compounds. The experimental and DFT studies showed that the efficient sensing ability of PA by 1(DMF)4 in the solid-state was due to photoelectron transfer (PET) and FRET phenomena described herein.

Molecular Weights of Polyethyleneimine-Dependent Physicochemical Tuning of Gold Nanoparticles and FRET-Based Turn-On Sensing of Polymyxin B

Environmental monitoring and the detection of antibiotic contaminants require expensive and time-consuming techniques. To overcome these challenges, gold nanoparticle-mediated fluorometric "turn-on" detection of Polymyxin B (PMB) in an aqueous medium was undertaken. The molecular weight of polyethyleneimine (PEI)-dependent physicochemical tuning of gold nanoparticles (PEI@AuNPs) was achieved and employed for the same. The three variable molecular weights of branched polyethyleneimine (MW 750, 60, and 1.3 kDa) molecules controlled the nano-geometry of the gold nanoparticles along with enhanced stabilization at room temperature. The synthesized gold nanoparticles were characterized through various advanced techniques. The results revealed that polyethyleneimine-stabilized gold nanoparticles (PEI@AuNP-1-3) were 4.5, 7.0, and 52.5 nm in size with spherical shapes, and the zeta potential values were 29.9, 22.5, and 16.6 mV, respectively. Accordingly, the PEI@AuNPs probes demonstrated high sensitivity and selectivity, with a linear relationship curve over a concentration range of 1-6 μM for polymyxin B. The limit of detection (LOD) was calculated as 8.5 nM. This is the first unique report of gold nanoparticle nano-geometry-dependent FRET-based turn-on detection of PMB in an aqueous medium. We believe that this approach would offer a complementary strategy for the development of a highly sophisticated and advanced sensing system for PMB and act as a template for the development of new nanomaterial-based engineered sensors for rapid antibiotic detection in environmental as well as biological samples.

Fluorescein based fluorescent and colorimetric sensors for sensitive detection of TNP explosive in aqueous medium: Application of logic gate

Rapid detection of 2,4,6-trinitrophenol (TNP) in real samples has recently attained considerable attention from the perspective of national security, human health, and environmental safety. In this context, cost-effective and convenient detection of TNP explosive was accomplished through two new fluorescein based sensors F2 and F3. Sensors displayed effective fluorescence quenching response towards TNP in the aqueous medium. Highly sensitive fluorescence detection of TNP explosive (detection limit, 0.73 (F2) and 1.7 nM (F3)) was governed by ground-state charge transfer complex formation, facilitated by favorable H-bonding between sensor and TNP explosive. Fluorescence quenching mechanism for the detection of TNP explosive was investigated through UV-Visible absorption, dynamic light scattering (DLS), density functional theory (DFT) calculations, the Benesi-Hildebrand, and Job's plots. Advantageously, sensors displayed selective and immediate colorimetric recognition of TNP explosive. Importantly, sensors exhibited quick response time towards TNP even in the presence of potential interferences that make them highly suitable for practical applications. Sensors were successfully applied for fluorescent and colorimetric detection of TNP explosive in industrial water samples and fabrication of logic gates. Further, convenient contact mode and instant surface sensing of TNP explosive were achieved through the fabrication of fluorescent strips and explosive responsive test kits.

A Pyrene-Rhodamine FRET couple as a chemosensor for selective detection of picric acid

Selective detection of nitroaromatic compounds such as Picric acid (PA), those being explosive materials and hazardous pollutants of environmental and biological concern is highly desirable. With the operational advantages of the chemosensing approach, a pyrene-rhodamine-B couple (1) was explored in this investigation as a ratiometric molecular probe for selective and sensitive detection of picric acid. The bi-fluorophoric probe displayed absorption and fluorescence enhancements along with colourless to reddish-brown colour transition as signaling responses in the selective presence of PA among all the nitro aromatic analyte investigated. The signaling module relies on PA- mediated modulation of various operational photo-physical processes such as (a) inhibition of photo-induced electron transfer (PET) operative from amino-donor to excited pyrene (b) a conformational translation through spiro-ring opening of rhodamine-B segment, and (c) initiation of Fluorescence Resonance Energy Transfer (FRET) between excited pyrene donor and ring-opened rhodamine acceptor. The ratio of fluorescence from both fluorophores (pyrene and Rhodamine) as output channel displayed sensitive signaling performance (LOD = 13.8 nM) in the detection of PA. The investigation that inferred to the PA-induced selectivity in signalling, higher binding affinity (log K_a≈11), a faster response time, and reversibility in signalling with a counter analyte and an operational pH range established the probe's efficacy as a chemosensor for PA detection.

Imidazole-based AIEgens for highly sensitive and selective detection of picric acid

A new family of imidazole-based AIEgens has been synthesized as fluorescent probes for specific recognition of picric acids over a variety of nitroaromatic compounds in aqueous media with high sensitivity.

A novel high sensitive Cd-MOF fluorescent probe for acetone vapor in air and picric acid in water: Synthesis, structure and sensing properties

A novel three-dimensional luminescence Cd-MOF sensor with the molecular formula {[(CH₃)₂NH₂]₂ Cd₃(ptptc)₂} (complex 1) has been synthesized by using terphenyl-3,3',5,5'-tetracarboxylic acid (H₄ptptc) and Cd(NO₃)₂·4H₂O under solvothermal conditions. Single crystal X-ray diffraction analysis shows that complex 1 crystallizes in the monoclinic system C2/c space group and consists of one-dimensional channels. Complex 1 exhibits characteristic fluorescence emission (λ_em = 380 nm) both in solid state and solvents upon excitation at 300 nm. Real-time fluorescence quenching of complex 1 was observed in the fluorescence sensing of acetone vapor and picric acid. Intriguingly, ppm scale detection limit for acetone vapor in air and nano-mole scale detection limit for picric acid in water were observed. Moreover, good reusability and liner/nonlinear relationships were observed in the fluorescent titration.

A stilbazolium dye-based chromogenic and red-fluorescent probe for recognition of 2,4,6-trinitrophenol in water

Probe DMAS-DP in water shows highly selective decrease in absorbance (475 nm) and fluorescence intensity (615 nm) with 2,4,6-trinitrophenol and colour change from red to yellow (visible light) and red fluorescent to black (365 nm light).

Double-ratiometric fluorescence imaging of H2Se and O2˙− under hypoxia for exploring Na2SeO3-induced HepG2 cells' apoptosis

Sodium selenite (Na₂SeO₃), as an anti-tumor drug for inducing tumor cells' apoptosis, has been widely studied under normoxic conditions and has been shown to exhibit oxidative stress process-induced apoptosis. However, since the real tumor environment is hypoxic, the actual mechanism is still unclear. Hence, considering the main metabolite of Na₂SeO₃ in the metabolic process to be hydrogen selenide (H₂Se) and also that it can be converted to superoxide anion (O₂˙⁻) instantaneously in the presence of oxygen, a dual-ratiometric fluorescence imaging system for simultaneous monitoring of the changes of H₂Se and O₂˙⁻ induced by Na₂SeO₃-guided tumor cell apoptosis under hypoxic conditions was constructed. Two molecular probes NIR-H₂Se and dihydroethidium were used to detect H₂Se and O₂˙⁻, respectively, whereas Rhodamine 110 was used as the reference fluorophore. Notably, H₂Se levels significantly increased under hypoxic conditions, but there was no change in the level of O₂˙⁻, which is inconsistent with the results of the previous researches. Therefore, we hypothesize that the mechanism of Na₂SeO₃-induced apoptosis for tumor cells is caused by reductive stress; also, this method can be applied for the future study of other anti-cancer selenium compounds.

Sodium selenite (Na₂SeO₃), as an anti-tumor drug for inducing tumor cells' apoptosis, has been widely studied under normoxic conditions and has been shown to exhibit oxidative stress process-induced apoptosis.