Highly crystalline and uniform conjugated polymer thin films by a water-based biphasic dip-coating technique minimizing the use of halogenated solvents for transistor applications

Enhanced Optoelectronic Properties of Polythiophene-g-Poly(dimethyl amino ethyl methacrylate)-b-Poly(diethylene glycol methyl ether methacrylate) Copolymers using "Grafting onto" Synthetic Strategy

The optoelectronic properties of polythiophene (PT) graft block copolymers are most important for fabricating optoelectronic devices, and recently, we reported a single-pot atom-transfer radical polymerization (ATRP) technique for preparation of PT graft block copolymers between thermoresponsive poly(diethylene glycol methyl ether methacrylate) (PDEGMEM) and pH-responsive poly(dimethyl amino ethyl methacrylate) (PDMAEMA) from the PT backbone via the "grafting from" strategy with an 11 mol % contamination. A "grafting onto" strategy has been opted to eliminate the contamination from the block copolymer where we synthesized poly(thiophene acetic acid) (P3TAA) followed by the coupling with PDEGMEM-b-PDMAEMA-Cl, PDMAEMA-b-PDEGMEM-Cl, and PDMAEMA-ran-PDEGMEM-Cl copolymers, produced separately by the ATRP technique. The polymers were characterized using 1H NMR, SEC, etc. TEM study exhibits mostly vesicular morphology and optical properties measured using UV-vis and photoluminescence spectroscopy showing pH dependent behavior. dc conductivity values indicate semiconducting nature in the order P2 > P3 > P1. The abrupt hike of P2 (∼80 times) in conductivity at pH 3 from that of previously prepared P2 copolymers formed by the grafting from process is attributed to the absence of ∼11 mol % contamination. Conductivity decreases with increasing pH, due to coiling of the PT backbone in accordance with the blue shifts of λabs peaks. The current (I)-voltage (V) plots exhibit bimodal memory and organic mixed ionic and electronic conductivity. Higher current (3.3 mA for P2, pH 3) and electronic memory occur upon light irradiation than that of dark. Photoswitching property decreases with increase of pH, showing highest photocurrent gain of 8.05 for P2 at pH 3. Photocurrent gain follows the order P2 > P3 > P1 indicating P2 is the best to develop photoswitches in the P-series polymers. Fitting of growth and decay curves suggests that they are a two-stage process: photocurrent raises fast at the on state initially and then at a slower rate and similar at an off state. Impedance spectra suggest charge-transfer resistance and Warburg impedance values follow the order of P1 > P3 > P2, whereas capacitance value follows the opposite order.

Lamellar orientation at the surface of isotactic polystyrene thin films analyzed by sum frequency generation spectroscopy

Analyzing the orientation of polymeric crystalline lamella at the surface of thin films can be challenging. Even though atomic force microscopy (AFM) is often sufficient for this analysis, there are cases when imaging is not sufficient to confidently determine lamellar orientation. Here, we used sum frequency generation (SFG) spectroscopy to analyze the lamellar orientation at the surface of semi-crystalline isotactic polystyrene (iPS) thin films. The SFG orientation analysis indicated that the iPS chains are oriented perpendicular to the substrate (flat-on lamellar orientation), which was confirmed by AFM. By analyzing the evolution of the SFG spectral features with the progress of crystallization, we demonstrated that the ratios of the SFG intensities of the phenyl ring resonances are a good indication of the surface crystallinity. Furthermore, we explored the challenges associated with SFG measurements of heterogeneous surfaces, which is commonly present in many semi-crystalline polymeric films. To the best of our knowledge, this is the first time that the surface lamellar orientation of semi-crystalline polymeric thin films was determined by SFG. Also, this work pioneers in reporting the surface conformation of semi-crystalline and amorphous iPS thin films by SFG and in linking the SFG intensity ratios to the progress of the crystallization and the surface crystallinity. This study demonstrates the potential applicability of SFG spectroscopy in the conformational analysis of polymeric crystalline structures at interfaces and opens the way to the investigation of more complex polymeric structures and crystalline arrangements, especially for the case of buried interfaces, where AFM imaging is not an option.