Induced defect and ZnO nano-flower formation by N, N, dimethylformamide solvent for natural sunlight responsive floating photocatalytic advanced oxidation process

The increasing disposal of dyes and face-mask propel to hunt for a solution to fight water pollution while assisting sustainability. This research overcomes the key challenges associated with implementing photocatalytic water treatment by using natural sunlight active photocatalyst, changing slurry system, eliminating the use of external triggering sources, and reusing face-mask fabric coated with ZnO to act as a floating photocatalyst. Unique morphological structures-cauliflower, hydrangea, and petals-likes are obtained with the variation in synthesis medium (Diethylene glycol (DEG), N, N-dimethyl formamide (DMF), H₂O) and methods (precipitation, solvothermal) which are found to be dependent on the solvent properties. With the use of DMF having a higher dielectric constant and formation of dimethyl amine via hydrolysis, it influences in forming petals and flower-like morphologies, unlike DEG solvent. The ZnO-coated face-mask fabric is used as the floating photocatalyst under natural sunlight observing comparable 91% degradation efficiency in 100 min with that of 99% efficiency in the UV light-illuminated slurry system. The formation of petals-like structures, defects from the liberation of DMF molecules from the ZnO surface by calcination, larger pore sizes and pore volumes provided a synergistic effect on enhancing the degradation efficiency in these cases.

Solvent assisted evolution and growth mechanism of zero to three dimensional ZnO nanostructures for dye sensitized solar cell applications

We report the structural engineering of ZnO nanostructures by a consistent solution method using distinct solvents such as ethylene glycol, 1-butanol, acetic acid and water. The growth kinetics are found to depend strongly on the physicochemical properties of the solvent and zeta potential of the colloidal solution. Furthermore, the resulting nanostructures as a photoanode material, displayed a prominent structure dependent property in determining the efficiency of dye-sensitized solar cells (DSSCs). The fabricated solar cell with ZnO nanostructures based photoanode exhibited improved conversion efficiency. Moreover, the nanoflower based DSSCs showed a higher conversion efficiency of 4.1% compared to the other structures. The excellent performance of ZnO nanoflower is attributed to its better light-harvesting ability and increased resistance to charge-recombination. Therefore ZnO nanostructures can be a promising alternative for TiO2 in DSSCs. These findings provide new insight into the simple, low cost and consistent synthetic strategies for ZnO nanostructures and its outstanding performance as a photoanode material in DSSCs.

Photocatalytic Activity of Zn x Mn3-x O4 Oxides and ZnO Prepared From Spent Alkaline Batteries

Oxides with Zn x Mn3-xO4 stoichiometries and ZnO were synthesized from the "black mass" material recovered from spent alkaline batteries. The oxides were characterized by XRF, XRD with Rietveld refinement, SEM, and TEM methods. Optical characterization included diffuse reflectance (DRS) and photoluminescence (PL) measurements. ZnO presented a clear band edge in the UV region, and PL signals were detected. The Zn/Mn oxides showed strong absorption in the UV region and a continuous absorption band in the Vis-IR regions. There is a non-detected PL signal due to excited charges being trapped on sub-band energy states and/or transfer by non-radiative paths. Photocatalytic activity under both irradiation conditions was evaluated using the resazurin dye test, terephthalic acid fluorescence probe method, and NOx air purification evaluation. In the three photoactivity tests, ZnO performed well under both UV and Vis irradiation, whereas no evidence of any appreciable photocatalytic activity was observed for the Zn/Mn oxides. The results are discussed in terms of the findings of previously reported optical measurements.