Fully Aromatic Thermotropic Copolyesters Based on Vanillic, Hydroxybenzoic, and Hydroxybiphenylcarboxylic Acids

Several series of new polymers were synthesized in this study: binary copolyesters of vanillic (VA) and 4'-hydroxybiphenyl-4-carboxylic (HBCA) acids, as well as ternary copolyesters additionally containing 4-hydroxybenzoic acid (HBA) and obtained via three different ways (in solution, in melt, and in solid state). The high values of logarithmic intrinsic viscosities and the insolubility of several samples proved their high molecular weights. It was found that the use of vanillic acid leads to the production of copolyesters with a relatively high glass transition temperature (~130 °C). Thermogravimetric analysis revealed that the onset of weight loss temperatures of ternary copolyesters occurred at 330-350 °C, and the temperature of 5% mass loss was in the range of 390-410 °C. Two-stage thermal destruction was observed for all aromatic copolyesters of vanillic acid: decomposition began with VA units at 420-480 °C, and then the decomposition of more heat-resistant units took place above 520 °C. The copolyesters were thermotropic and exhibited a typical nematic type of liquid crystalline order. The mechanical characteristics of the copolyesters were similar to those of semi-aromatic copolyesters, but they were much lower than the typical values for fully aromatic thermotropic polymers. Thus, vanillic acid is a mesogenic monomer suitable for the synthesis of thermotropic fully aromatic and semi-aromatic copolyesters, but the processing temperature must not exceed 280 °C.

Synthesis and Characterization of Novel Wholly Aromatic Copolyesters Based on 4'-Hydroxybiphenyl-3-Carboxylic and 3-Hydroxybenzoic Acids

A series of new wholly aromatic (co)polyesters based on m-substituted bifunctional comonomers-4'-hydroxybiphenyl-3-carboxylic (3HBCA) and 3-hydroxybenzoic (3HBA) acids with molar ratios of 3HBCA:3HBA from 0:100 to 60:40, respectively-was synthesized. NMR and FTIR spectroscopy methods proved the full compliance of the copolymer composition with the target ratio of comonomers, as well as high compositional homogeneity (absence of block sequences). The resulting copolyesters have a sufficiently high molecular weight and their intrinsic viscosity values are in the range of 0.6-0.8 dL/g. Thermal analysis showed that all 3HBCA-3HBA copolyesters are amorphous, and with an increase in the content of biphenyl units (3HBCA), the glass transition temperature increases significantly (up to 190 °C). The onset of the intense thermal decomposition of the synthesized polyesters occurs above 450 °C. Thus, this indicates a sufficiently high thermal stability of these polyesters. Rheological measurements have shown that melts of copolyesters with a high content of 3HBCA units exhibit anisotropic properties. At the same time, the method of polarization optical microscopy did not confirm the transition to the liquid crystal state for these polyesters. These results confirm that it is possible to obtain high-performance polyesters based on 3HBCA, but not a mesogenic comonomer. Thus, 3HBCA is a promising comonomer for the synthesis of new thermotropic copolyesters with controlled anisotropic properties.

Melt polycondensation of carboxytelechelic polyethylene for the design of degradable segmented copolyester polyolefins

Chain-transfer ring-opening metathesis polymerization (CT-ROMP) provided a route to carboxytelechelic polyethylene (PE) with subsequent incorporation into segmented copolymers.