An open-source programmable smart pipette for portable cell separation and counting

Computational Hyperspectral Microflow Cytometry

Miniaturized flow cytometry has significant potential for portable applications, such as cell-based diagnostics and the monitoring of therapeutic cell manufacturing, however, the performance of current techniques is often limited by the inability to resolve spectrally-overlapping fluorescence labels. Here, the study presents a computational hyperspectral microflow cytometer (CHC) that enables accurate discrimination of spectrally-overlapping fluorophores labeling single cells. CHC employs a dispersive optical element and an optimization algorithm to detect the full fluorescence emission spectrum from flowing cells, with a high spectral resolution of ≈3 nm in the range from 450 to 650 nm. CHC also includes a dedicated microfluidic device that ensures in-focus imaging through viscoelastic sheathless focusing, thereby enhancing the accuracy and reliability of microflow cytometry analysis. The potential of CHC for analyzing T lymphocyte subpopulations and monitoring changes in cell composition during T cell expansion is demonstrated. Overall, CHC represents a major breakthrough in microflow cytometry and can facilitate its use for immune cell monitoring.

Ender3 3D printer kit transformed into open, programmable syringe pump set

A cheap, open source 3D printer (Creality Ender 3) is transformed into an Open Hardware, programmable syringe pump set. Only 3 parts need to be purchased outside of the printer kit. All other parts are either in the Ender 3 kit, or can be 3D printed. No prior knowledge in electronics or programming languages is required. The pumps are controlled by the 3D printer firmware and motherboard and programmed in simple G-code text files. The total cost of a three pumps setup is ∼€170. The pumps are capable of reaching stable flows down to 5 µL/min using cheap, disposable 10 mL syringes. Higher flow speeds are also achievable, in the order of mL/min.

Open-hardware wireless controller and 3D-printed pumps for efficient liquid manipulation

Many routines in biological experiments require the precise handling of liquid volumes in the range of microliters up to liters. In this paper, we describe a new wireless controller that is adapted to liquid manipulation tasks, in particular when combined with the proposed 3D-printed pumps. It can be built from widely available electronic components and managed with open-source software. The use of peristaltic pumps enables to move volumes from milliliters to liters with a relative error below 1% or a syringe pump capable of injecting volumes in the range of milliliters with microliter accuracy. The system is remotely controllable over WiFi and easily automated using the MQTT communication protocol. The programming of the microcontroller is performed on the Arduino IDE. The WiFi settings and the calibration value can be easily modified, stored and exported in the form of a JSON file to create a user friendly, plug and play and easily scalable device. Additional sensors or actuators can be added, allowing the system to adapt to various usages. Finally, in addition to its low manufacturing cost and its capability to fit a large variety of tasks involving liquid handling, our system has been specifically designed for research environments where adaptability and repeatability of experiments is essential.