Ag/AgCl@MIL-88A(Fe) heterojunction ternary composites: towards the photocatalytic degradation of organic pollutants

Interface Engineering-Modulated Nanoscale Bimetallic CoFe-MIL-88A In-Situ-Grown on 2D V2CTx MXene for Electrocatalytic Nitrogen Reduction

The electrochemical nitrogen reduction reaction (eNRR) provides a sustainable green development route for the nitrogen-neutral cycle. In this work, bimetallic CoFe-MIL-88A with two active sites (Fe, Co) were immobilized on a 2D V2CTx MXene surface by in situ growth method to achieve the purpose of the control interface. A large number of heterostructures are formed between small CoFe-MIL-88A and V2CTx, which regulate the electron transfer between the catalyst interfaces. The adsorption and activation of nitrogen on the active sites were enhanced, and the NRR reaction kinetics was accelerated. CoFe-MIL-88A is tightly arranged on V2CTx, which makes CoFe-MIL-88A/V2CTx have better hydrophobicity and can significantly inhibit the hydrogen evolution reaction. The synergistic effect of multicatalytic active sites and multi-interface structure of CoFe-MIL-88A/V2CTx MXene is propitious to nitrogen efficiently and stably to convert into ammonia under environmental conditions with superior selectivity and good catalytic activity. The NH3 yield rate is 29.47 μg h-1 mgcat-1 at -0.3 V vs RHE, and the Faradaic efficiency (FE) is 28.86% at -0.1 V vs RHE. The catalytic mechanism was verified to conform to the distal pathway. This work will provide a new way to develop an MXene-based electrocatalyst for eNRR.

Polyoxometalate supported on a magnetic Fe3O4/MIL-88A rod-like nanocomposite as an adsorbent for the removal of ciprofloxacin, tetracycline and cationic organic dyes from aqueous solutions

In this work, a magnetic H₃PW₁₂O₄₀/Fe₃O₄/MIL-88A (Fe) rod-like nanocomposite as a stable and effective ternary adsorbent was fabricated by the hydrothermal method and utilized for the removal of ciprofloxacin (CIP), tetracycline (TC) and organic dyes from aqueous solution. Characterization of the magnetic nanocomposite was accomplished by FT-IR, XRD, Raman spectroscopy, SEM, EDX, TEM, VSM, BET specific surface area and zeta potential analyses. The influencing factors on the adsorption potency of the H₃PW₁₂O₄₀/Fe₃O₄/MIL-88A (Fe) rod-like nanocomposite including initial dye concentration, temperature and adsorbent dose were studied. The maximum adsorption capacities of H₃PW₁₂O₄₀/Fe₃O₄/MIL-88A (Fe) for TC and CIP were 370.37 mg g^-1 and 333.33 mg g^-1 at 25 °C, respectively. In addition, the H₃PW₁₂O₄₀/Fe₃O₄/MIL-88A (Fe) adsorbent had high regeneration and reusability capacity after four cycles. In addition, the adsorbent was recovered through magnetic decantation and reused for three consecutive cycles without a considerable reduction in its performance. The adsorption mechanism was mainly ascribed to electrostatic and π-π interactions. According to these results, H₃PW₁₂O₄₀/Fe₃O₄/MIL-88A (Fe) can act as a reusable effective adsorbent for the fast elimination of tetracycline (TC), ciprofloxacin (CIP) and cationic dyes from aqueous solutions.

Heterojunction photocatalysts for the removal of nitrophenol: A systematic review

Nitrophenols are the most widely used raw materials in the chemical, pesticide, and pharmaceutical industries. Due to improper waste management and excessive usage, nitrophenol is listed as a priority pollutant and garnered global research attention. This review highlights the recent progress on heterojunction photocatalysts toward eliminating nitrophenols. The detailed mechanisms of the electron-hole pair separation using different heterojunctions such as traditional, p-n, Z-scheme, S-scheme, and Schottky heterojunctions are elaborated. The performance of the photocatalysts is evaluated using quantum efficiency. Among the heterojunctions, Z-scheme exhibited maximum removal efficiency of 100% and found superior over other heterojunctions. Even though heterojunctions exhibit good efficiency, the reusability of the heterojunction photocatalyst is not reported beyond 5 cycles. Further research is indeed to develop a highly reusable photocatalyst for environmental remediation.

Multipollutant Abatement through Visible Photocatalytic System

Water pollution damages the aquatic environment due to the presence of organic contaminants, which in turn is distressing to the ecosystem. Photocatalytic activity is a greener and promising method to degrade these organic contaminants. In this research, we present the degradation of diverse water pollutants through zinc/iron oxide nanoparticles serving as photocatalysts. The photocatalyst was studied for its efficiency to photodegrade congo red, brilliant green and para nitro phenol. Moreover, it also presented an antibacterial activity against the bacterium E. coli. Photocatalyst was characterized via X-ray diffraction, scanning electron microscopy-energy dispersive X-ray spectroscopy, and fourier-transform infrared spectroscopy. Tauc plot was used to measure the optical band gap (1.84 eV). The effect of various parameters such as catalyst dose, contact time, dye dose/concentration and pH were also investigated to determine the optimum point of maximum degradation through response surface methodology. A face-centered composite design was used, and a quadratic model was followed by congo red, brilliant green dyes and para nitrophenol. The maximum photodegradation efficiencies were 99%, 94.3%, and 78.5% for congo red, brilliant green and phenol, respectively. Quantum yield for congo red, brilliant green and para-nitrophenol were 9.62 × 10−8, 1.17 × 10−7 and 4.11 × 10−7 molecules/photons, while the reaction rates were 27.1 µmolg−1h−1, 29.61 µmolg−1h−1 and 231 µmolg−1h−1, respectively.

Efficient Removal of Inorganic and Organic Pollutants over a NiCo2O4@MOF-801@MIL88A Photocatalyst: The Significance of Ternary Heterojunction Engineering

Energy problems are a substantial concern in a global society that can be solved by replacing with sustainable energies. In recent years, designing nanomaterials as photocatalysts that can produce chemical energy with the utilization of infinite visible light energy became a new solution for water treatment. In the present study, NiCo₂O₄@MOF-801 has been synthesized with multiple properties, and then, a novel three-layer NiCo₂O₄@MOF-801@MIL88A photocatalyst has been successfully synthesized to improve meropenem degradation and Cr(VI) reduction. The prepared photocatalyst was characterized by XRD, IR, XPS, TEM, SEM, TGA, BET, EIS, PL, and UV-vis. According to the structural and optical analysis performed, the interaction between the components formed a heterojunction structure that prevented the recombination of charge carriers and increased the photocatalytic performance. Photocatalytic simulation tests also proved the reduction of chromium and degradation of antibiotics to find the optimal heterogeneous performance. As a result, the NiCo₂O₄@MOF-801@MIL88A composite can completely reduce Cr(VI) in 45 min, which is strongly preferable to any pure component's performance. Overall, this work offers a low-cost but high-efficiency material that can remove organic and inorganic contaminants from water.

Efficient ofloxacin degradation via photo-Fenton process over eco-friendly MIL-88A(Fe): Performance, degradation pathways, intermediate library establishment and toxicity evaluation

The high-throughput production of the eco-friendly MIL-88A(Fe) was achieved under mild reaction conditions with normal pressure and temperature. The as-prepared MIL-88A(Fe) exhibited efficient photo-Fenton catalytic ofloxacin (OFL) degradation upon visible light irradiation with good stability and reusability. The OFL (20.0 mg/L) was completely degraded within 50 min under visible light with the aid of MIL-88A(Fe) (0.25 g/L) and H₂O₂ (1.0 mL/L) in aqueous solution (pH = 7.0). The hydroxyl radicals (·OH) are the main active species during the photo-Fenton oxidation process. Meanwhile, the degradation intermediates and the corresponding degradation pathways were identified and proposed with the aid of both ultra-high performance liquid chromatography tandem quadrupole time-of-flight mass spectrometry (UHPLC-Q-TOF-MS) and density functional theory (DFT) calculations. Finally, the degradation product library was firstly established to identify intermediate transformation products (TPs) with their variation of concentration, and their corresponding toxicologic activities were assessed via Toxtree and T.E.S.T software as well. Finally, the MIL-88A is efficient and stable with four cycles' catalysis operations, demonstrating good potential for water treatment.

Hybrid metal organic frameworks as an Exotic material for the photocatalytic degradation of pollutants present in wastewater: A review

In this world, water is considered as the Elixir for all living creatures. Human life rolls with water, and every activity depends upon water. Worldwide water resources are being contaminated due to the elevation in the population count, industrialization and urbanization. Ejection of chemicals by industries and domestic sewages remains the major reason in the destruction of natural water resources. Contaminated water with harmful microbes, chemical dyes, pesticides, and carcinogens are the root cause of many diseases and deaths of living species. In this scenario, researchers engaged in producing ultra components to remove the contaminants. Metal organic frameworks (MOF) are the desired combination of organic and inorganic materials to achieve the required target. MOFs possess unique characteristics like tunable internal structure, porosity, crystallinity and high surface area which enable them for energy and environmental application. For the past years, MOFs are concentrated more as a photocatalyst in the treatment of polluted water. These research studies discuss the improvement of photocatalytic performance of MOF by the incorporation of metals, metal coupled with nanoparticles like polymers, graphene, etc., into it to achieve the enhanced photocatalytic activity by scavenging entire chemicals and harmful microbes to retain the quality of water. The target of this review article is to focus on the state of the art research work on MOFs in photocatalytic water treatment technique.

Coating metal–organic frameworks on plasmonic Ag/AgCl nanowire for boosting visible light photodegradation of organic pollutants

Photoactive metal–organic frameworks, MIL-100(Fe), with controllable thickness are coated on plasmonic Ag/AgCl nanowire, for boosting visible light photodegradation of rhodamine B and tetracycline hydrochloride. The morphology and composition of the obtained nano-heterostructure were investigated in detail by SEM imaging, TEM imaging, XRD patterns, FT-IR spectra, N₂ adsorption–desorption curves and TGA patterns. Photoelectric performance test suggested that a Z-scheme photocatalysis system for efficient transfer of photogenerated charge carriers was established between MIL-100(Fe) and plasmonic Ag/AgCl nanowire.

A photoactive metal–organic framework, MIL-100(Fe), with controllable thickness was coated on plasmonic Ag/AgCl nanowire for boosting the visible light photodegradation of rhodamine B and tetracycline hydrochloride.

Self-photoreduced Ag0-doped Ag(i)–organic frameworks with efficient visible-light-driven photocatalytic performance

A series of Ag0-doped Ag(i)organic frameworks have been constructed via a facile self-photoreduction strategy and can be applied as efficient photocatalysts for the photocatalytic degradation of methyl orange.