TiO2 Co-doped with Zr and Ag shows highly efficient visible light photocatalytic behavior suitable for treatment of polluted water

Hydrothermally synthesized Ag-TiO2 nanofibers (NFs) for photocatalytic dye degradation and antibacterial activity

This work successfully utilised eco-friendly green synthesis to produce Ag-TiO₂ nanofibers (NFs). As pollution and energy limitations have become global issues, there is an ongoing need to develop more effective catalysts through straightforward and environmentally friendly methods. The Ag-TiO₂ nanofibers (NFs) XRD pattern exhibits an anatase TiO₂ and FCC crystal structure of Ag nanoparticles. The SEM investigation revealed a nanofiber-like surface morphology. The Ag-TiO₂ nanofibers (NFs) exhibits an optical band gap energy is 2.5 eV. Methylene blue (MB), malachite green (MG), Congo red (CR), and crystal violet (CV) dye aqueous solutions were used to evaluate the photocatalytic performance of the synthesized Ag-modified TiO₂ nanofibers (NFs) under direct sunlight irradiation. The effects of catalyst size on the efficient breakdown of MB dye were also investigated. The optimum catalyst concentration was found to be at 0.02 mg/mL. At 120 min of direct sunlight, the highest photosynthetic degradation efficiency (DE percentage) of 94% was achieved for MB dye. Ag-TiO₂ nanofibers (NFs) have been demonstrated to have exceptional antibacterial activity against Gram-positive bacteria such as Staphylococcus aureus and Gram-negative bacteria E-Coli. Because of these great qualities, it seems likely that the Ag-TiO₂ nanofibers (NFs) made could be a great photocatalyst for getting dye pollutants out of wastewater.

Studies on Synthesis, Characterization, and Photocatalytic Activity of TiO2 and Cr-Doped TiO2 for the Degradation of p-Chlorophenol

TiO₂ and Cr-TiO₂ nanoparticles (NPs) have been synthesized by the sol-gel method using titanium isopropoxide as the precursor of Titania. The prepared samples were analyzed by employing scanning electron microscopy, energy-dispersive X-ray spectroscopy, X-ray diffraction, X-ray photoelectron spectroscopy, and Fourier transform infrared analyses. Under UV irradiation, the photocatalytic activities of TiO₂ and Cr-TiO₂ were observed by estimating the % degradation of p-chlorophenol (PCP) as a sample pollutant. The extent of degradation was investigated, varying the catalyst dosage, initial PCP concentration, irradiation time, and solution pH. The experimental results show that efficiency of catalysts initially increases but decreases later on, whereas the % degradation of PCP is the highest at its lowest initial concentration. For TiO₂ and Cr-TiO₂ NPs at their optimal catalyst dosage of 2.0 g/L, acidic pH, and with UV irradiation for 90 min, the observed % degradation of PCP is 50.23 ± 3.12 and 66.51 ± 2.14%, respectively. Thus, the prepared Cr-TiO₂ NPs have enhanced the degradation efficiency of PCP with an irradiation time which is four time less than those reported earlier. From the kinetics analysis, the degradation reaction of PCP is found to follow a pseudo-first-order model and the rate constants are 0.0075 and 0.0122 min^-1 for pure TiO₂ and Cr-TiO₂ NPs, respectively. The present study has further revealed that owing to the lower rate of electron-hole pair recombination, the photocatalytic activity of Cr-TiO₂ NPs becomes higher than that of TiO₂. Therefore, as viable photocatalytic agents, Cr-TiO₂ NPs are suggested to be used also for efficient degradation of other organic pollutants.

Valorization of spent double substituted Co-Ni-Zn-Fe LDH wastewater nanoadsorbent as methanol electro-oxidation catalyst

Finding suitable non-expensive electrocatalyst materials for methanol oxidation is a significant challenge. Waste valorization of spent wastewater nanoadsorbents is a promising route toward achieving circular economy guidelines. In this study, the residual of layered double hydroxide (LDH) can be used as an electrocatalyst in direct methanol fuel cells as a novel approach. The Co-Ni-Zn-Fe LDH was prepared by the co-precipitation method followed by the adsorption of methyl orange (MO). Moreover, the spent adsorbent was calcined at different temperatures (200, 400, and 600 °C) to be converted to the corresponding mixed metal oxides (MMO). The prepared samples were characterized using XRD, FTIR, HRTEM, zeta potential, and hydrodynamic size measurements. The spent adsorbent was tested as an electro-catalyst for direct methanol electro-oxidation. The spent LDH/MO adsorbent showed a maximum current density of 6.66 mA/cm² at a 50 mV/s scan rate and a 1 M methanol concentration. The spent MMO/MO adsorbent showed a maximum current density of 8.40 mA/cm² at a 200 °C calcination temperature, 50 mV/s scan rate, and a 3 M methanol concentration. Both samples show reasonable stability over time, as indicated by the chronoamperometric response. Further nanoengineering of used nanoadsorbents could be a promising path to repurposing these wastes as electro-oxidation catalysts.

A stable and plug-and-play aluminium/titanium dioxide/metal-organic framework/silver composite sheet for sensitive Raman detection and photocatalytic removal of 4-aminothiophenol

The sensitive detection and rapid removal of 4-aminothiophenol (4-ATP, a poisonous pesticide) demand special design to potential substrates. Herein, a metal-organic framework (ZIF-8) and Ag nanoparticles were fabricated one by one on the TiO₂ coated Al sheet, and thus the Al-TiO₂-ZIF-8-Ag sheet with sandwich structure was successfully synthesized. The cost-effective Al-TiO₂-ZIF-8-Ag sheet (3.7 wt% Ag) possessed a low detection concentration of 1 × 10^-9 M towards 4-ATP, and surface-enhanced Raman scattering (SERS) analytical enhanced factor (AEF) of the Al-TiO₂-ZIF-8-Ag was 2.6 × 10⁶, which was higher than other similar substrates. Furthermore, 4-ATP can be selectively and repeatedly detected on the Al-TiO₂-ZIF-8-Ag even through it was in real samples. It indicated that the Al-TiO₂-ZIF-8-Ag was a very active and stable SERS materials for the monitoring of 4-ATP. Importantly, the substrate exhibited faster and more efficient photocatalytic activity for 4-ATP degradation. The SERS and photocatalytic mechanisms of 4-ATP on the Al-TiO₂-ZIF-8-Ag substrate were proposed. The cost-effective Al-TiO₂-ZIF-8-Ag sheet with double function is plug-and-play, and could be used in the detection and treatment of pollutants in wastewater.