Potentiometric Determination of Glutathione and Glutathione Transferase Activity

Evaluation of the reactivity of exhaust from various biodiesel blends as a measure of possible oxidative effects: A concern for human exposure

Diesel exhaust particles (DEP) are a major constituent of ambient air pollution and are associated with various adverse health effects, posing a major safety and public health concern in ambient and occupational environments. The effects of DEP from various biodiesel blends on biological systems was investigated using glutathione (GSH) as a marker of possible oxidative effects, based on the decrease in the concentration of GSH at physiological pH. The fluorophoric agent 2,3-naphthalenedicarboxaldehyde (NDA) was used as a selective probe of GSH in the presence of any likely interferents via fluorescence detection. Three different polar solvents (acetonitrile, methanol and water) were used to extract DEP generated during the combustion of different biodiesel blends (5%-99%). Oxidation of GSH to the disulfide (GSSG) was confirmed using electrospray ionization mass spectrometry. A decrease in the concentration of GSH was observed in the presence of DEP extracts from all of the biodiesel blends studied, with reaction rates that depend on the biodiesel blend. Interestingly the reactivity peaked at 50% biodiesel (B50) rather than decreasing monotonically with increased biodiesel content, as was expected. Organic solvent DEP extracts showed wider variations in reactivity with GSH, with methanol extracts giving the largest decrease in GSH concentrations. This may imply a more organic nature of the oxidants in the biodiesel exhaust. It is therefore important to consider ways of reducing concentrations of organic components in biodiesel exhaust that can cause different toxic activity before any blend is offered as a preferred alternative to petroleum diesel fuel.

Colorimetric assay of glutathione based on the spontaneous disassembly of aggregated gold nanocomposites conjugated with water-soluble polymer

This article describes the glutathione-triggered disassembly of gold nanocomposites composed of gold cores and water-soluble copolymers [poly(N-n-isopropylacrylamide-co-acryloyldiethyletriamine)] attached to the surfaces of gold cores. The gold nanocomposites exhibit a bluish purple color because of the assembled gold cores that are conjugated with the diethylenetriamine groups incorporated into the copolymers. Glutathione added to the gold nanocomposite solution adsorbs onto the surface of the gold cores to liberate diethylenetriamine groups, resulting in spontaneous disassembly that changes the color of the solution to a reddish shade. Increasing the glutathione concentration facilitates the spontaneous disassembly of the gold nanocomposites. For the determination of glutathione, the colorimetric change of the gold nanoparticles is quantified with the a* value of the L*a*b* color coordinates defined by the CIE (Commission Internationale de l'Eclairage) chromaticity diagram. A linear relationship between the a* value and the glutathione concentration of up to 6 x 10(-6) mol/L is obtained 15 min after the addition of glutathione that has a detection limit (defined as 3sigma) of 2.9 x 10(-8) mol/L. The colorimetric assay is successfully applied to the determination of glutathione in eye drops and health supplements.

Electrocatalytic determination of reduced glutathione in human erythrocytes

The determination of reduced glutathione (GSH) in human erythrocytes using a simple, fast and sensitive method employing a glassy carbon electrode modified with cobalt tetrasulfonated phthalocyanine (CoTSPc) immobilized in poly(L: -lysine) (PLL) film was investigated. This modified electrode showed very efficient electrocatalytic activity for anodic oxidation of GSH, decreasing substantially the anodic overpotentials for 0.2 V versus Ag/AgCl. The modified electrode presented better performance in 0.1 mol l(-1) piperazine-N,N'-bis(2-ethanesulfonic acid) buffer at pH 7.4. The other experimental parameters, such as the concentration of CoTSPc and PLL in the membrane preparation, pH, type of buffer solution and applied potential, were optimized. Under optimized operational conditions, a linear response from 50 to 2,160 nmol l(-1) was obtained with a high sensitivity of 1.5 nA l nmol(-1) cm(-2). The detection limit for GSH determination was 15 nmol l(-1). The proposed sensor presented good repeatability, evaluated in terms of the relative standard deviation (1.5%) for n = 10. The modified electrode was applied for determination of GSH in erythrocyte samples and the results were in agreement with those obtained by a comparative method described in the literature The average recovery for these fortified samples was 100 +/- 1)%. Applying a paired Student's-t test to compare these methods, we could observe that, at the 95% confidence level, there was no statistical difference between the reference and the proposed methods.

Electrocatalytic activity of cobalt phthalocyanine CoPc adsorbed on a graphite electrode for the oxidation of reduced l-glutathione (GSH) and the reduction of its disulfide (GSSG) at physiological pH

Modified electrodes coated by adsorbed cobalt phthalocyanines are known to show substantial electrocatalytic activity for the electro-oxidation of several thiols in alkaline aqueous solution. In this context, we explore in this study the electrocatalytic activity of adsorbed cobalt phthalocyanine (CoPc) on ordinary pyrolytic graphite electrode for the oxidation of reduced L-glutathione GSH and the reduction of its disulfide GSSG at physiological pH. To do so, cyclic and rotating disk voltammetries were performed and the amperometric results show that a stable electrochemical sensing material, with good reproducibility and sensitivity (in accordance with the concentrations of GSH expected in biological media), can be easily achieved. This opens the way for the design of an electrochemical sensor able to detect these two analytes in biologically relevant experimental conditions (in terms of pH).

Development of an amperometric biosensor based on glutathione peroxidase immobilized in a carbodiimide matrix for the analysis of reduced glutathione from serum

The development of an amperometric biosensor for the reduced glutathione determination in serum is described. The biosensor is based on glutathione peroxidase (GSH-Px, EC 1.11.1.9) immobilized onto a pyrolytic graphite-working electrode using carbodiimide as enzymatic condensing reagent. This resulted in an amperometric biosensor with good sensitivity and stability. The reduced glutathione (GSH) was enzymatically converted to glutathione disulfide (GSSG) in the presence of hydroperoxide, which was monitored amperometrically by its electrooxidation at +0.65 V vs. SCE (saturated calomel electrode). Glutathione measurement was carried out by maintaining the ratio between GSH and hydrogen peroxide at 2:1 (25 degrees C). The amperometric response of the biosensor was linearly proportional to the GSH concentration between 1.9x10(-5) and 1.4x10(-4) mol/l, in 0.1 mol/l phosphate buffer (pH=7.8), containing 0.1 mol/l KCl and 0.5 mmol/l Na(2)H(2)EDTA, as the supporting electrolyte. In presence of interfering compounds, the recoveries ranged between 97.2% and 110.7%. The biosensor useful lifetime was at least 2 months when it was evaluated after continuous use. Serum samples analyzed by this biosensor showed a good correlation with the results from the spectrophotometric method (Ellman's reagent) used as reference, presenting relative deviations lower than 7.0%. The low apparent Michaelis-Menten constant value, K(M)(app)=1.6 mmol/l, demonstrated that GSH-Px immobilized on pyrolytic graphite exhibited a high affinity to GSH, without loss of enzymatic activity.