Rheological Behavior of Some Cationic Polyelectrolytes

Viscosity Behavior of P(DAC-AM) with Serial Cationicity and Intrinsic Viscosity in Inorganic Salt Solutions

The poly(acryloyloxyethyl trimethyl ammonium chloride-co-acrylamide), P(DAC-AM), is a kind of cationic polyelectrolyte usually applied in a solution form, and its performance is affected by its structure and the environment where it is used. In particular, its viscosity properties in salt solutions are directly related to its efficacy in various applications, and the performance is one of the most important solution properties. Therefore, in this paper, the effects of the salt concentration and valence of seven kinds of inorganic salts, NaCl, LiCl, KCl, MgCl₂, AlCl₃, Na₂SO₄, and Na₃PO₄, on the values of apparent viscosity (η_a) of P(DAC-AM) samples with cationicity of 10%, 50%, and 90%, and intrinsic viscosity ([η]) of 5, 10, and 15 dL/g were investigated. The η_a was determined using a rotational viscometer. The interaction mechanism between the polymers and salt ions was also investigated. The results showed that depending on the salt concentration, the η_a firstly decreased sharply to the inflection point which indicated the minimum volume of the molecule shrinking, and then either maintained the value unchanged or increased. The salt concentration corresponding to the inflection point decreased with the increase of the salt ion valence but with the reduction of the cationicity of the polymer. The η_a at the inflection point increased as the [η] of the polymer grew. This indicated that the salt concentration and the salt ion valence had a notable impact on the stretch of the cationic polymer molecule in the salt solutions. It was discovered that the phenomenon of the increase of the η_a of P(DAC-AM) samples in the multivalent salt solutions after the inflection point was caused by not only the increase of the η_a of the complexes formed from the pure salts, but also the viscosity resistance of the charge and volume between the polymer molecules and salt ions, as well as the complexes themselves. The linear relationship between the increased η_a and the salt concentration, representing the interaction both among the complexes themselves and between the polymer and complexes, was obtained. Furthermore, the interaction model between the salt ions and P(DAC-AM) molecules in a wide range of salt concentrations was illustrated.

Cationic polyelectrolyte induced separation of some inorganic contaminants and their mixture (zirconium silicate, kaolin, K-feldspar, zinc oxide) as well as of the paraffin oil from water

The flocculation efficiency of a cationic polyelectrolyte with quaternary ammonium salt groups in the backbone, namely PCA5 was evaluated on zirconium silicate (kreutzonit), kaolin, K- feldspar and zinc oxide (ZnO) suspensions prepared either with each pollutant or with their mixture. The effect of several parameters such as settling time, polymer dose and the pollutant type on the separation efficacy was evaluated and followed by optical density and zeta potential measurements. Except for ZnO, the interactions between PCA5 and suspended particles led to low residual turbidity values (around 4% for kreutzonit, 5% for kaolin and 8% for K-feldspar) as well as to the reduction of flocs settling time (from 1200 min to 30 min and 120 min in case of kaolinit and K-feldspar, respectively), that meant a high efficiency in their separation. The negative value of the zeta potential and flocs size measurements, at the optimum polymer dose, point to contribution from charge patch mechanism for the particles flocculation. A good efficiency of PCA5 in separation of paraffin oil (a minimum residual turbidity of 9.8%) has been also found.