Characterization and application of C–TiO2 doped cellulose acetate nanocomposite film for removal of Reactive Red-195

Recent Progress on Tailoring the Biomass-Derived Cellulose Hybrid Composite Photocatalysts

Biomass-derived cellulose hybrid composite materials are promising for application in the field of photocatalysis due to their excellent properties. The excellent properties between biomass-derived cellulose and photocatalyst materials was induced by biocompatibility and high hydrophilicity of the cellulose components. Biomass-derived cellulose exhibited huge amount of electron-rich hydroxyl group which could promote superior interaction with the photocatalyst. Hence, the original sources and types of cellulose, synthesizing methods, and fabrication cellulose composites together with applications are reviewed in this paper. Different types of biomasses such as biochar, activated carbon (AC), cellulose, chitosan, and chitin were discussed. Cellulose is categorized as plant cellulose, bacterial cellulose, algae cellulose, and tunicate cellulose. The extraction and purification steps of cellulose were explained in detail. Next, the common photocatalyst nanomaterials including titanium dioxide (TiO₂), zinc oxide (ZnO), graphitic carbon nitride (g-C₃N₄), and graphene, were introduced based on their distinct structures, advantages, and limitations in water treatment applications. The synthesizing method of TiO₂-based photocatalyst includes hydrothermal synthesis, sol-gel synthesis, and chemical vapor deposition synthesis. Different synthesizing methods contribute toward different TiO₂ forms in terms of structural phases and surface morphology. The fabrication and performance of cellulose composite catalysts give readers a better understanding of the incorporation of cellulose in the development of sustainable and robust photocatalysts. The modifications including metal doping, non-metal doping, and metal-organic frameworks (MOFs) showed improvements on the degradation performance of cellulose composite catalysts. The information and evidence on the fabrication techniques of biomass-derived cellulose hybrid photocatalyst and its recent application in the field of water treatment were reviewed thoroughly in this review paper.

Free-standing hybrid film for separation of dye pollutant with self-cleaning ability under visible light

The development of low cost and environmental-friendly materials has long been an ambition for effective removal of dye pollutants in complex water environments. In this study, a free-standing separation film of bacterial cellulose reinforced/functionalized by graphitic phase carbon nitride is developed by a facile suction filtration strategy, of which the former is precoated by polypyrrole, and the latter is pre-doped by oxygen to endow the as-obtained film an enhanced photocatalytic performance and self-cleaning ability. The as-obtained film exhibits a high tensile stress of 51.8 ± 1.1 MPa, and a high resistance to cold, heat, acid and alkali. For typical dyes of methylene blue and rhodamine B, a high dye rejection rate of 99.9% at 138 L/m²•h•bar feed flux is obtained by the as-obtained film. Even at a salt concentration higher than 5%, it still maintained high dye removal rates and achieves effective separation of dye and salt. Simultaneously, a high dye photocatalytic degradation of the composite films rates up to 98% in only 90 min, and a high self-cleaning ability demonstrated by recovery of flux after light treatment in cyclic tests. The density functional theory calculation validates the beneficial effects of improved light response range and separated photogenerated electron/holes for the effective degradation of dyes by oxygen-doped carbon nitride coupled with one-dimensional polypyrrole chains. Overall, this study proposes a new direction for the separation of dye pollutants with a high visible-light self-cleaning capacity by structural tailoring of bacterial cellulose with carbon nitride.