The Synergistic Effect of a Mixed Surfactant (Tween 80 and SDBS) on Wettability Alteration of the Oil Wet Quartz Surface

Molecular Dynamics Simulations of the Short-Chain Fluorocarbon Surfactant PFHXA and the Anionic Surfactant SDS at the Air/Water Interface

The research and development of alternatives to long-chain fluorocarbon surfactants are desperately needed because they are extremely toxic, difficult to break down, seriously harm the environment, and limit the use of conventional aqueous film-forming foam fire extinguishing agents. In this study, mixed surfactant systems containing the short-chain fluorocarbon surfactant perfluorohexanoic acid (PFHXA) and the hydrocarbon surfactant sodium dodecyl sulfate (SDS) were investigated by molecular dynamics simulation to investigate the microscopic properties at the air/water interface at different molar ratios. Some representative parameters, such as surface tension, degree of order, density distribution, radial distribution function, number of hydrogen bonds, and solvent-accessible surface area, were calculated. Molecular dynamics simulations show that compared with a single type of surfactant, mixtures of surfactants provide superior performance in improving the interfacial properties of the gas-liquid interface. A dense monolayer film is formed by the strong synergistic impact of the two surfactants. Compared to the pure SDS system, the addition of PFHXA caused SDS to be more vertically oriented at the air/water interface with a reduced tilt angle, and a more ordered structure of the mixed surfactants was observed. Hydrogen bonding between SDS headgroups and water molecules is enhanced with the increasing PFHXA. The surface activity is arranged in the following order: PFHXA/SDS = 1:1 > PFHXA/SDS = 3:1 > PFHXA/SDS = 1:3. These results indicate that a degree of synergistic relationship exists between PFHXA and SDS at the air/water interface.

Experimental Investigation on Spontaneous Imbibition of Surfactant Mixtures in Low Permeability Reservoirs

Spontaneous imbibition of surfactants could efficiently enhance oil recovery in low permeability sandstone reservoirs. The majority of studies have considered the application of individual surfactants to alter wettability and reduce interfacial tension (IFT). However, a significant synergistic effect has been reported between different types of surfactants and between salts and surfactants. Therefore, this study systematically studied the capability of a binary surfactant mixture (anionic/nonionic) and a ternary surfactant mixture (anionic/nonionic/strong base-weak acid salt) in imbibition enhanced oil recovery (IEOR). The interfacial properties and the cores' wettability were explored by IFT and contact angle measurements, respectively. Subsequently, the imbibition performances of different types of surfactant solutions were discussed. The results suggested that the surfactants' potential to enhance oil recovery followed the order of ternary surfactant mixture > binary surfactant mixture > anionic > nonionic > amphoteric > polymer. The ternary surfactant mixture exhibited strong capacity to reverse the rock surface from oil-wet (125°) to strongly water-wet (3°), which was more significant than both binary surfactant mixtures and individual surfactants. In addition, the ternary surfactant mixture led to an ultralow IFT value of 0.0015 mN/m, achieving the highest imbibition efficiency (45% OOIP). This research puts forward some new ideas on the application of the synergistic effects of surfactants in IEOR from low-permeability sandstone reservoirs.

Application of α-MnO2 nanoparticles for residual oil mobilization through surfactant polymer flooding

Injection of surfactant and polymer slug is among the most effective chemical enhanced oil recovery processes. The only problem encountered with the surfactant polymer (SP) flooding is the loss of surface-active agents that reduce the efficiency of surfactants in the chemical slug. Various attempts to modify SP flooding have been made previously so that the surfactant loss due to adsorption could be reduced. Nanoparticles (NPs) are one of the most effective ways of reducing surfactant adsorption as surfactant particles are held in the liquid phase by nanoparticles, resulting in lower surfactant losses due to adsorption. However, the high cost of the NPs limits their use on the field scale. To encounter this problem, the present study focuses on the application of the manganese dioxide NPs, synthesized through a green route that is economically viable. These NPs are found to be cost-effective as compared to commercially available NPs as well as the synthesis of these NPs does not require the use of toxic chemicals. The 1000 ppm NPs effectively reduced the surfactant adsorption by 46%. The surface tension was lowered from 29.4 to 26.1 mN/m when 1000 ppm NPs were applied to 2500 ppm surfactant solution. Also, the nanoparticles were found to increase the viscosity of the chemical slug by increasing the solid particles present in the slug. The sand pack flooding experiments were carried out to assess the crude oil mobilization ability of the NPs assisted SP flooding. The oil recovery was found to increase from 5% of the original oil in place, resulting in ~ 75% of the crude oil recovery, which was only ~ 70% when NPs were not introduced into the system.

Characteristics of Viscoelastic-Surfactant-Induced Wettability Alteration in Porous Media

Wettability alteration is one of the most important mechanisms of surfactant flooding. In this work, the combined Amott/USBM (United States Bureau of Mines) method was applied to study the average wettability alteration of initially neutral cores after viscoelastic-surfactant (VES) filtration. The effects of static aging, dynamic aging, VES concentration, filtration flow rate, and pore radius on the alteration of a core’s average wettability were studied. The wettability-alteration trends measured by Amott and USBM were consistent, demonstrating that the overall hydrophilicity of the core was enhanced after VES filtration. The wettability alterations of the core brought about by dynamic aging were more significant than by static aging. The viscoelastic properties of the VES played an important role in altering the wettability. In addition, the ability of the VES to affect the core’s wettability was significantly enhanced when the VES concentration was increased, which was beneficial in increasing VES adsorption on the pore-wall surface, thus altering the overall wettability of the core. Increasing filtration flow rates can destroy those high-viscosity VES aggregates via the higher shear rate. A higher retention of VES makes the core more hydrophilic. The difference in the wettability of cores with different pore radius after VES filtration was not significant. The alteration of average wettability caused by VES in porous media provides a new vision for studying the EOR mechanism of VES.

Effect of Electrolytes on Solution and Interfacial Behaviors of Double Chain Cationic-Nonionic Surfactant Mixtures for Hydrophobic Surface Wetting and Oil/Water Emulsion Stability Applications

The solution behaviors of the binary mixture of double chain cationic surfactant didodecyldimethylammonium bromide (DDAB) with nonionic surfactants of varied head groups, EO-9 and EO-40, in the presence and absence of electrolytes were studied and found nonideal behavior. The different physicochemical properties such as Gibb's surface excess (Γ), minimum area per molecule (A_min), and interaction parameters at bulk (β^M) and interface (β^σ) were calculated. In the presence of nonionic surfactants, lowering of CMC, CVC, and surface tension at these two concentrations of DDAB were observed. The β^M and β^σ values indicate strong interaction between DDAB and EO-40 mixed system. Further, addition of electrolytes to the mixed systems show increased interaction and change of physicochemical properties because of the combination of electrical and salting out effects.

Influence of mineralogy and surfactant concentration on zeta potential in intact sandstone at high pressure

HYPOTHESIS

Zeta-potential in the presence of brine has been studied for its application within hydrocarbon reservoirs. These studies have shown that sandstone's zeta-potential remains negatively charged, non-zero, and levels-off at salinities > 0.4 mol.dm^-3, thus becoming independent of salinity when ionic strength is increased further. However, research conducted to date has not yet considered clay-rich (i.e. clay ≥ 5 wt%) sandstones.

EXPERIMENTS

Firstly, streaming potential measurements were conducted on Bandera Gray sandstones (clay-rich and clay-poor) with 0.6 and 2 mol.dm^-3 NaCl brine-saturated in pressurised environments (6.895 MPa overburden and 3.447 MPa back-pressure). Secondly, the streaming potential was determined at identical conditions for the effect of two surfactants, SDBS and CTAB, at concentrations of 0.01 and 0.1 wt% on the clay-poor sample in 0.6 mol.dm^-3 NaCl. Thirdly, a comparison of zeta potentials determined via electrophoretic and streaming potential was conducted. Accordingly, this work analyses the effects of mineralogy and surfactants within this process.

FINDINGS

Clay-rich sandstone possessed lower zeta-potentials than clay-poor sandstone at the two tested salinities. SDBS reduced zeta-potential and yielded higher repulsive forces rendering the rock more hydrophilic. Additionally, electrophoretic zeta-potentials were higher when compared to streaming zeta-potentials. Mechanisms for the observed phenomena are also provided.

Thermodynamics of Micellization, Interfacial Behavior and Wettability Alteration of Aqueous Solution of Nonionic Surfactants

The present work deals with the physiochemical properties of polyoxyethylene sorbitan fatty acid esters (polysorbates), which are commonly known under the trade name Tween. Thermodynamics of micellization and adsorption at air-water interface for these nonionic surfactants solutions have been studied over a broad range of temperature. As the temperature of the surfactant solutions increases, the surface tension decreases whereas the critical micelle concentration (CMC) of each surfactant solution initially decreases and then increases. The free Gibb free energies of the micelle formation Δ G m o $\Delta {\rm{G}}_{\rm{m}}^{\rm{o}}$ , and the surfactant adsorption Δ G ads o $\Delta {\rm{G}}_{{\rm{ads}}}^{\rm{o}}$ , are calculated for the CMC of each surfactant at different temperatures. The surface or expanding pressure (Πcmc), minimum area per molecule (Amin), maximum surface excess (Γmax) are also calculated. The interfacial tension (IFT) between the aqueous surfactant solutions and the crude oil are measured at different concentrations of the surfactants using a spinning drop tensiometer. The contact angles are determined on an oil wet quartz surface to investigate the wettability alteration in the presence of Tween surfactants with varying salinity. FTIR analysis of quartz at dry and oil wet state, crude oil and COBRS (crude oil-brine-rock-surfactant) combinations are performed to identify the associated functional groups and their mutual interactions.