An intercomparison study of the determination of glyphosate, chlormequat and mepiquat residues in wheat

Chromatographic Methods for the Determination of Glyphosate in Cereals Together with a Discussion of Its Occurrence, Accumulation, Fate, Degradation, and Regulatory Status

The European Union's recent decision to renew the authorization for the use of glyphosate until 15 December 2033 has stimulated scientific discussion all around the world regarding its toxicity or otherwise for humans. Glyphosate is a chemical of which millions of tons have been used in the last 50 years worldwide to dry out weeds in cultivated fields and greenhouses and on roadsides. Concern has been raised in many areas about its possible presence in the food chain and its consequent adverse effects on health. Both aspects that argue in favor of toxicity and those that instead may indicate limited toxicity of glyphosate are discussed here. The widespread debate that has been generated requires further investigations and field measurements to understand glyphosate's fate once dispersed in the environment and its concentration in the food chain. Hence, there is a need for validated analytical methods that are available to analysts in the field. In the present review, methods for the analytical determination of glyphosate and its main metabolite, AMPA, are discussed, with a specific focus on chromatographic techniques applied to cereal products. The experimental procedures are explained in detail, including the cleanup, derivatization, and instrumental conditions, to give the laboratories involved enough information to proceed with the implementation of this line of analysis. The prevalent chromatographic methods used are LC-MS/MS, GC-MS/SIM, and GC-MS/MS, but sufficient indications are also given to those laboratories that wish to use the better performing high-resolution MS or the simpler HPLC-FLD, HPLC-UV, GC-NPD, and GC-FPD techniques for screening purposes. The concentrations of glyphosate from the literature measured in wheat, corn, barley, rye, oats, soybean, and cereal-based foods are reported, together with its regulatory status in various parts of the world and its accumulation mechanism. As for its accumulation in cereals, the available data show that glyphosate tends to accumulate more in wholemeal flours than in refined ones, that its concentration in the product strictly depends on the treatment period (the closer it is to the time of harvesting, the higher the concentration), and that in cold climates, the herbicide tends to persist in the soil for a long time.

Detection of glyphosate and its metabolites in food of animal origin based on ion-chromatography-high resolution mass spectrometry (IC-HRMS)

Glyphosate and glufosinate are broad spectrum herbicides, widely used in agriculture and in inhabited or industrialised areas, and aminomethylphosphonic acid is a degradation product of glyphosate. In 2015, the International Agency for Research on Cancer reported that glyphosate is a probable carcinogenic. In 2017, however, a scientific opinion of the European Chemicals Agency concluded that glyphosate is not proven to be carcinogenic, mutagenic or to have negative effects on reproduction. Nevertheless, aminomethylphosphonic acid was not considered. Due to their chemical-physical characteristics, these molecules present difficulties that have not yet allowed routine monitoring to be carried out. For these reasons, we developed and validated a simple and versatile liquid extraction, before IC-HRMS analysis, of three different complex matrices: honey, bass fish and bovine muscle. Among the satisfactory validation parameters, the LOQs in the range of 4.30-9.26 ng g-1 demonstrated high method sensitivity, compared to the few works present in literature. Finally, the method was applied to real commercial samples, which showed no traces of the selected pesticides.

Development and Validation of Ion Chromatography-Tandem Mass Spectrometry-Based Method for the Multiresidue Determination of Polar Ionic Pesticides in Food

An extraction method using acidified methanol based on the quick polar pesticide (QuPPe) method using suppressed ion chromatography coupled to mass spectrometry was developed and validated for the direct analysis of polar pesticides, without the need for derivatization or ion pairing, in cereals and grapes. The method was robust, and results for glyphosate, aminomethyl phosphonic acid (AMPA), N-acetyl-AMPA, glufosinate, 3-methylphosphinicopropionic acid (3-MPPA), N-acetyl glufosinate, ethephon, chlorate, perchlorate, fosetyl aluminum, and phosphonic acid at three concentration levels (typically 0.01, 0.05, and 0.1 mg/kg) were compliant with SANTE/11945/2015 guideline method performance criteria. Cereal-based infant food proved to be a more challenging matrix and validated only for glyphosate, chlorate, and perchlorate at 0.005, 0.01, and 0.05 mg/kg. The developed method enables the multiresidue analysis of 12 ionic pesticides and relevant metabolites in a single analysis. Until now, the analysis of these compounds required several different single-residue methods using different chromatographic conditions. This multiresidue approach offers the possibility of more cost-effective and more efficient monitoring of polar ionic pesticides and contaminants that are of concern to food regulation bodies and consumers.

Analysis of glyphosate and aminomethylphosphonic acid in leaves from Coffea arabica using high performance liquid chromatography with quadrupole mass spectrometry detection

Glyphosate is a commonly applied herbicide in coffee plantations. Because of its non-selective mode of action it can damage the crop exposed through spray drift. Therefore, it is of interest to study glyphosate fate in coffee plants. The aim of this study was to develop an analytical method for accurate and precise quantification of glyphosate and its main metabolite aminomethylphosphonic acid (AMPA) at trace levels in coffee leaves using liquid chromatography with single-quadrupole mass spectrometry detection. The method is based on a two-step solid phase extraction (SPE) with an intermediate derivatization reaction using 9-fluorenylmethylchloroformate (FMOC). An isotope dilution method was used to account for matrix effects and to enhance the confidence in analyte identification. The limit of quantification (LOQ) for glyphosate and AMPA in coffee leaves was 41 and 111 μg kg(-1) dry weight, respectively. For the method optimization a design of experiments (DOE) approach was used. The sample clean-up procedure can be simplified for the analysis of less challenging matrices, for laboratories having a tandem mass spectrometry detector and for cases in which quantification limits above 0.1 mg kg(-1) are acceptable, which is often the case for glyphosate. The method is robust, possesses high identification confidence, while being suitable for most commercial and academic laboratories. All leaf samples from five coffee fields analyzed (n=21) contained glyphosate, while AMPA was absent. The simplified clean-up procedure was successfully validated for coffee leaves, rice, black beans and river water.

Study of liquid chromatography/electrospray ionization mass spectrometry matrix effect on the example of glyphosate analysis from cereals

Glyphosate is one of the most common pesticides used in the pre-harvest treatment of cereals. This paper examines the matrix effect of glyphosate liquid chromatography/electrospray ionization mass spectrometric (LC/ESI-MS) analysis in wheat and rye. The matrix effect (ionization suppression) was found to be dependent on sample particle size taken for the extraction. If samples are ground to very small particles severe ionization suppression occurs. For lower glyphosate contents (<1 mg/kg) the signal may even be suppressed by more than 90%. The matrix effect was found to be dependent on the matrix - rye showed significantly stronger ionization suppression than wheat, although these matrices are not very different. The matrix effect also depends on the concentration of glyphosate in the post-extraction spiked samples. It is demonstrated that the isotope-labelled standard (13)C(2)-glyphosate undergoes different ionization suppression than glyphosate and is therefore not efficient in compensating for matrix effect. At the same time the extrapolative dilution approach allows to efficiently compensate for matrix effect.

Current mass spectrometry strategies for the analysis of pesticides and their metabolites in food and water matrices

Analysis of pesticides and their metabolites in food and water matrices continues to be an active research area closely related to food safety and environmental issues. This review discusses the most widely applied mass spectrometric (MS) approaches to pesticide residues analysis over the last few years. The main techniques for sample preparation remain solvent extraction and solid-phase extraction. The QuEChERS (Quick, Easy, Cheap, Effective, Rugged, Safe) approach is being increasingly used for the development of multi-class pesticide residues methods in various sample matrices. MS detectors-triple quadrupole (QqQ), ion-trap (IT), quadrupole linear ion trap (QqLIT), time-of-flight (TOF), and quadrupole time-of-flight (QqTOF)-have been established as powerful analytical tools sharing a primary role in the detection/quantification and/or identification/confirmation of pesticides and their metabolites. Recent developments in analytical instrumentation have enabled coupling of ultra-performance liquid chromatography (UPLC) and fast gas chromatography (GC) with MS detectors, and faster analysis for a greater number of pesticides. The newly developed "ambient-ionization" MS techniques (e.g., desorption electrospray ionization, DESI, and direct analysis in real time, DART) hyphenated with high-resolution MS platforms without liquid chromatography separation, and sometimes with minimum pre-treatment, have shown potential for pesticide residue screening. The recently introduced Orbitrap mass spectrometers can provide high resolving power and mass accuracy, to tackle complex analytical problems involved in pesticide residue analysis.

Fate and transport of chlormequat in subsurface environments

BACKGROUND, AIM AND SCOPE

Chlormequat (Cq) is a plant growth regulator used throughout the world. Despite indications of possible effects of Cq on mammalian health and fertility, little is known about its fate and transport in subsurface environments. The aim of this study was to determine the fate of Cq in three Danish subsurface environments, in particular with respect to retardation of Cq in the A and B horizons and the risk of leaching to the aquatic environment. The study combines laboratory fate studies of Cq sorption and dissipation with field scale monitoring of the concentration of Cq in the subsurface environment, including artificial drains.

MATERIALS AND METHODS

For the laboratory studies, soil was sampled from the A and B horizons at three Danish field research stations-two clayey till sites and one coarse sandy site. Adsorption and desorption were described by means of the distribution coefficient (K (d)) and the Freundlich adsorption coefficient (K (F,ads)). The dissipation rate was estimated using soil sampled from the A horizon at the three sites. Half life (DT(50)) was calculated by approximation to first-order kinetics. A total of 282 water samples were collected at the sites under the field monitoring study- groundwater from shallow monitoring screens located 1.5-4.5 m b.g.s. at all three sites as well as drainage water from the two clayey sites and porewater from suction cups at the sandy site, in both cases from 1 m b.g.s. The samples were analysed using LC-MS/MS. The field monitoring study was supported by hydrological modelling, which provided an overall water balance and a description of soil water dynamics in the vadose zone.

RESULTS

The DT(50) of Cq from the A horizon ranged from 21 to 61 days. The Cq concentration-dependant distribution coefficient (K (d)) ranged from 2 to 566 cm(3)/g (median 18 cm(3)/g), and was lowest in the sandy soil (both the A and B horizons). The K (F,ads) ranged from 3 to 23 (microg(1 - 1/n ) (cm(3))(1/n) g(-1)) with the exponent (1/n) ranging from 0.44 to 0.87, and was lowest in the soil from the sandy site. Desorption of Cq was very low for the soil types investigated (<10%w). Cq in concentrations exceeding the detection limit (0.01 microg/L) was only found in two of the 282 water samples, the highest concentration being 0.017 microg/L.

DISCUSSION

That sorption was highest in the clayey till soils is attributable to the composition of the soil, the soil clay and iron content being the main determinant of Cq sorption in both the A and B horizons of the subsurface environment. Cq was not detected in concentrations exceeding the detection limit in either the groundwater or the porewater at the sandy site. The only two samples in which Cq was detected were drainage water samples from the two clayey till sites. The presence of Cq here was probably attributable to the hydrogeological setting as water flow at the two clayey till sites is dominated by macropore flow and less by the flow in the low permeability matrix. In contrast, water flow at the sandy site is dominated by matrix flow in the high permeability matrix, with negligible macropore flow. Given the characteristics of these field sites, Cq adsorption and desorption can be expected to be controlled by the clay composition and content and the iron content. Combining these observations with the findings of the sorption and dissipation studies indicates that the key determinant of Cq retardation and fate in the soil is sorption characteristics and bioavailability.

CONCLUSIONS

The leaching risk of Cq was negligible at the clayey till and sandy sites investigated. The adsorption and desorption experiments indicated that absorption of Cq was high at all three sites, in particular at the clayey till sites, and that desorption was generally very limited. The study indicates that leaching of Cq to the groundwater is hindered by sorption and dissipation. The detection of Cq in drainage water at the clayey till sites and the evidence for rapid transport through macropores indicate that heavy precipitation events may cause pulses of Cq.

RECOMMENDATIONS AND PERSPECTIVES

The present study is the first to indicate that the risk of Cq leaching to the groundwater and surface water is low. Prior to any generalisation of the present results, the fate of Cq needs to be studied in other soil types, application regimes and climatic conditions to determine the Cq retardation capacity of the soils. The study identifies bioavailability and heavy precipitation events as important factors when assessing the risk of Cq contamination of the aquatic environment. The possible effects of future climate change need to be considered when assessing whether or not Cq poses an environmental risk.