Fabrication of Ag-doped ZnO by mechanochemical combustion method and their application into photocatalytic Famotidine degradation

Highly Transmittance, Mechanical, Thermally Stable Silver Nanowires Network Using ZnO Nanoparticles

This research addresses challenges with silver nanowires (Ag NWs) as transparent conductive electrodes (TCEs) and heaters in commercial devices. Here, zinc oxide nanoparticles (ZnO NPs) are first reported as a protective layer for Ag NWs. Multi-physics simulations confirm enhanced thermal stability due to improved heat dissipation, temperature distribution, and thermal conductivity from ZnO. When Ag NWs are surrounded by air, heat transfers mainly through convection and radiation because of air's low conduction coefficient. Encasing Ag NWs in ZnO enhances heat transfer to the ZnO surface, accelerating cooling and dissipating more heat into the atmosphere via convection. The results show composite's efficiency in the Joule effect, maintaining a consistent temperature of 78 °C for 700 s after 500 bending cycles, a significant improvement over Ag NWs operating for only 5 s at 80 °C. Additionally, the composite film exhibited exceptional performance, including a sheet resistance of 9.8 Ω sq-1 and an optical transmittance of 96.96 %, outperforming Ag NWs, which have a sheet resistance of 12 Ω sq-1 and a transmittance of 94.11%. The combination of enhanced electrical, thermal, and mechanical stability, along with impressive optical properties, makes Ag NWs/ZnO NPs a promising candidate for transparent conductive electrode materials in various applications.

Visible-Light-Driven Mentha spicata L.-Mediated Ag-Doped Bi2Zr2O7 Nanocomposite for Enhanced Degradation of Organic Pollutants, Electrochemical Sensing, and Antibacterial Applications

Novel visible-light-driven Ag (X)-doped Bi2Zr2O7 (BZO) nanocomposites in pudina (P) extract (Mentha spicata L.), X-1, 3, 5, 7, and 9 mol %, were synthesized by the one-pot greener solution combustion method. The as-synthesized nanocomposite materials were characterized by using various spectral [X-ray diffraction (XRD), Fourier transform infrared, UV-visible, UV- diffuse reflectance spectra, X-ray photoelectron spectroscopy], electrochemical (cyclic voltammetry, electrochemical impedance spectroscopy), and analytical (scanning electron microscopy-energy-dispersive X-ray spectroscopy, transmission electron microscopy, Brunauer-Emmett-Teller) techniques. The average particle size of the nanocomposite material was found to be between 14.8 and 39.2 nm by XRD. The well-characterized Ag-doped BZOP nanocomposite materials exhibited enhanced photocatalytic degradation activity toward hazardous dyes such as methylene blue (MB) and rose bengal (RB) under visible light irradiation ranges between 400 and 800 nm due to their low energy band gap. As a result, 7 mol % of Ag-doped BZOP nanocomposite material exhibited excellent photodegradation activity against MB (D.E. = 98.7%) and RB (D.E. = 99.3%) as compared to other Ag-doped BZOP nanocomposite materials and pure BZOP nanocomposite, respectively, due to enhanced semiconducting and optical behaviors, high binding energy, and mechanical and thermal stabilities. The Ag-doped BZOP nanocomposite material-based electrochemical sensor showed good sensing ability toward the determination of lead nitrate and dextrose with the lowest limit of detection (LOD) of 18 μM and 12 μM, respectively. Furthermore, as a result of the initial antibacterial screening study, the Ag-doped BZOP nanocomposite material was found to be more effective against Gram-negative bacteria (Escherichia coli) as compared to Gram-positive (Staphylococcus aureus) bacteria. The scavenger study reveals that radicals such as O2•- and •OH are responsible for MB and RB mineralization. TOC removal percentages were found to be 96.8 and 98.5% for MB and RB dyes, and experimental data reveal that the Ag-doped BZOP enhances the radical (O2•- and •OH) formation and MB and RB degradation under visible-light irradiation.

Emerging aspects of metal ions-doped zinc oxide photocatalysts in degradation of organic dyes and pharmaceutical pollutants - A review

In recent periods, a broad assortment of continual organic contaminants has been released into our natural water resources. Indeed, it is exceedingly poisonous and perilous to living things; thus, the elimination of these organic pollutants before release into the water bodies is vital. A variety of techniques have been utilized to remove these organic pollutants with advanced oxidation photocatalytic methods with zinc oxide (ZnO) nanoparticles being commonly used as a capable catalyst for contaminated water treatment. Nevertheless, its broad energy gap, which can be only stimulated under an ultraviolet (UV) light source, and high recombination pairs of electrons and holes limit their photocatalytic behaviors. However, numerous methods have been suggested to decrease its energy gap for visible regions. Including, the doping ZnO with metal ions (dopant) can be considered as an effectual route not only the reason for a movement of the absorption edges toward the higher (visible light) region but also to lower the electron-hole pair (e--h+) recombination. This review concentrated on the impact of dissimilar types of metal ions (dopants) on the advancement in the degradation performance of ZnO. So, this work demonstrates a vital review of contemporary attainments in the alteration of ZnO nanoparticles for organic pollutants eliminations. Besides, the effect of doping ions including transition metals, rare earth metals, and metal ions (substitutional and interstitial) concerning numerous types of altered ZnO are summarized. The photodegradation mechanisms for pristine and metal-modified ZnO nanoparticles are also conferred.

Natural Sunlight Driven Photocatalytic Removal of Toxic Textile Dyes in Water Using B-Doped ZnO/TiO2 Nanocomposites

A novel B-doped ZnO/TiO2 (B–ZnO/TiO2) nanocomposite photocatalyst was prepared using a mechanochemical–calcination method. For the characterization of the synthesized B–ZnO/TiO2 photocatalyst, XRD, FESEM-EDS, FTIR, UV-Vis DRS, BET, PL, and XPS techniques were used. The bandgap energy of B–ZnO/TiO2 was reduced, resulting in enhanced visible-light absorption. Significant PL quenching confirmed the reduction in the electron–hole recombination rate. Furthermore, reduced crystallite size and a larger surface area were obtained. Hence, the B–ZnO/TiO2 photocatalyst exhibited better photocatalytic activity than commercial TiO2, ZnO, B–ZnO, and ZnO/TiO2 in the removal of methylene blue (MB) dye under natural sunlight irradiation. The effects of various parameters, such as initial concentration, photocatalyst amount, solution pH, and irradiation time, were studied. Under optimal conditions (MB concentration of 15 mg/L, pH 11, B–ZnO/TiO2 amount of 30 mg, and 15 min of operation), a maximum MB removal efficiency of ~95% was obtained. A plausible photocatalytic degradation mechanism of MB with B–ZnO/TiO2 was estimated from the scavenger test, and it was observed that the •O2− and •OH radicals were potential active species for the MB degradation. Cyclic experiments indicated the high stability and reusability of B–ZnO/TiO2, which confirmed that it can be an economical and environmentally friendly photocatalyst.

Synthesis of N-Doped ZnO Nanocomposites for Sunlight Photocatalytic Degradation of Textile Dye Pollutants

Undoped and N-doped ZnO nanocomposites are produced by a simple and low-cost mechanochemical method. The characterizations of all nanocomposites are examined by X-ray diffraction (XRD), Fourier transform-infrared (FT-IR), scanning electron microscopy (SEM) and UV-Vis-NIR spectroscopy. The XRD measurements show that the crystal sizes of undoped and N-doped ZnO nanocomposites are ~29 and ~28 nm, respectively. The UV-Vis-NIR spectroscopy results illustrate that the transmittance of the 7 wt% N/ZnO in the visible and infrared region is a bit higher than the undoped ZnO. The photocatalytic activity of undoped and N-doped ZnO nanocomposites is investigated for the degradation of Methylene Blue (MB) and Rhodamine B (RhB) aqueous solution with direct sunlight irradiation. The photocatalytic degradation percentages with 7 wt% N/ZnO for 5 and 10 mg/L MB dye solution are found to be 93.70% and 98.11%, respectively, whereas 78.40% and 89.15% degradation percentages are found with undoped ZnO, after 3 h sunlight irradiation. Under the same conditions, the photocatalytic degradation value of RhB dye (10 mg/L) solution is measured to be 86.21% for 7 wt% N/ZnO and 64.75% for undoped ZnO. The N-doped ZnO nanocomposites are found to exhibit enhanced photocatalytic performance for both dyes’ degradation under sunlight irradiation in comparison with the undoped ZnO. Therefore, the photocatalytic degradation treatment of wastewater including dye pollutants with sunlight is an easy and simple technique, and cost-effective.

The investigation of Amido black 10B adsorption-photocatalytic degradation using the synergistic effect of Cr-doped ZnO/CDs nanocomposite under solar light

In this work, the modification of ZnO nanoparticles with green synthesized carbon dots and Cr yielded a nanocomposite named Cr-doped ZnO/CDs. Further, 0.48 g/L of this nanocomposite was able to remove (95 ± 1) % of 25 mg/L Amido black 10B (AB10B) from a solution, by adsorption process less than 5 min. The photocatalytic property of Cr-doped ZnO/CDs was able to improve the removal efficiency of AB10B to 99% during irradiation of sunlight within 15 min. The maximum adsorbent capacity of Cr-doped ZnO/CDs nanocomposite was 152.4 mg/g. Unmodified ZnO nanoparticles (0.48 g/L) were able to remove only 30% of the dye within 60 min of irradiation. Its modification showed coupling the absorption and photocatalytic process dramatically increased the dye removal efficiency. Adsorption isotherm investigation indicated that the experimental data were fitted satisfactorily by the Langmuir model. This method is an economical method because the Cr-doped ZnO/CDs synthesis was easy and inexpensive, the dye removal time was very short, and infinite sunlight is required to remove the dye with high efficiency. Graphical abstract.

Synthesis of CuO/ZnO Nanocomposites and Their Application in Photodegradation of Toxic Textile Dye

CuO/ZnO composites are synthesized using a simple mechanochemical combustion method. X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), and Fourier transform infrared (FTIR) are used to characterize the prepared oxides. X-ray diffraction reveals that the prepared CuO/ZnO exhibit a wurtzite ZnO crystal structure and the composites are composed of CuO and ZnO. The strong peaks of the Cu, Zn, and O elements are exhibited in the EDX spectrum. The FTIR spectra appear at around 3385 cm−1 and 1637 cm−1, caused by O–H stretching, and 400 cm−1 to 590 cm−1, ascribable to Zn–O stretching. The photocatalytic performances of CuO/ZnO nanocomposites are investigated for the degradation of methylene blue (MB) aqueous solution in direct solar irradiation. The degradation value of MB with 5 wt % CuO/ZnO is measured to be 98%, after 2 h of solar irradiation. The reactive •O2− and •OH radicals play important roles in the photodegradation of MB. Mineralization of MB is around 91% under sunlight irradiation within 7 h. The photodegradation treatment for the textile wastewater using sunlight is an easy technique—simply handled, and economical. Therefore, the solar photodegradation technique may be a very effective method for the treatment of wastewater instead of photodegradation with the artificial and expensive Hg-Xe lamp.