Quality by design approach for development and validation of a RP-HPLC method for simultaneous estimation of xipamide and valsartan in human plasma

A new rapid, simple, and sensitive RP-HPLC method was carried out through applying Quality by Design approach for determination of xipamide and valsartan in Human plasma. Fractional factorial design was used for screening of four independent factors: pH, flow rate, detection wavelength, and % of MeOH. Analysis of variance (ANOVA) confirmed that flow rate and % of MeOH were only significant. Chromatographic conditions optimization was carried out through using central composite design. Method analysis was performed using BDS Hypersil C8 column (250 × 4.6 mm, 5 μm) and an isocratic mobile phase of MeOH and 0.05 M KH2PO4 buffer pH 3 (64.5:35.5, v/v) at 1.2 mL/min flow rate with UV detection at 240 nm and 10 μL injection volume. According to FDA guidelines, the method was then validated for the determination of the two drugs clinically in human plasma in respect of future pharmacokinetic and bioequivalence simulation studies. The standard curve was linear in the concentration range of 5-100 µg/mL for both drugs, with a determination coefficient (R2) of 0.999. Also, the average recoveries lied within the range from 99.89 to 100.03%. The proposed method showed good predictability and robustness.

A vinylpyrrolidone-based thin film microextraction in combination with direct solid-state spectrofluorimetry for determination of sartans in human plasma

A vinylpyrrolidone-ethylene glycol dimethacrylate-acrylic acid thin film was prepared on a polypropylene guard and its formulation was optimized for application in thin film microextraction followed by direct solid-state spectrofluorimetry method. The surface morphology, fluorescence property and extraction performance of the thin film were investigated systematically. The intra- and inter-batch reproducibilities of thin film fabrication were obtained 2.3 and 4.2%, respectively. The lifetime of each prepared thin film was 30 times with a relative standard deviation of less than 1.4%. The developed method was optimized for extraction of some sartans as angiotensin II receptors antagonist (including losartan, valsartan, and olmesartan) which have been used to control hypertension as the main causes of cardiovascular disease. The optimum extraction conditions achieved at 2- (for losartan) and 4- (for valsartan and olmesartan) sample pH, 500-rpm rotation rate and 30-min extraction time for all three analytes. At the optimum conditions, analyses of losartan, valsartan, and olmesartan were validated in the human plasma matrix. Broad linearity ranges with determination coefficients of more than 0.999 were achieved for each calibration curve. Limit of detection of the method was 0.5 ng mL^-1 for all three analytes. The intra- and inter-day accuracies and precisions of the developed method were evaluated in spiked plasma samples at three concentration levels of each analyte with high recoveries of 95-101% and relative standard deviations less than 6%. This method provides a simple, sensitive, fast, and high-throughput analysis method with the possibility of effective extraction of at least 40 samples simultaneously without the necessity of protein precipitating, desorption, and solvent evaporation steps.

Four Derivative Spectrophotometric Methods for the Simultaneous Determination of Carmoisine and Ponceau 4R in Drinks and Comparison with High Performance Liquid Chromatography

Four simple, rapid, and accurate spectrophotometric methods were developed for the simultaneous determination of two food colorants, Carmoisine (E122) and Ponceau 4R (E124), in their binary mixtures and soft drinks. The first method is based on recording the first derivative curves and determining each component using the zero-crossing technique. The second method uses the first derivative of ratio spectra. The ratio spectra are obtained by dividing the absorption spectra of the binary mixture by that of one of the components. The third method, derivative differential procedure, is based on the measurement of difference absorptivities derivatized in first order of solution of drink samples in 0,1 N NaOH relative to that of an equimolar solution in 0,1 N HCl at wavelengths of 366 and 451 nm for Carmoisine and Ponceau 4R, respectively. The last method, based on the compensation method is presented for derivative spectrophotometric determination of E122 and E124 mixtures with overlapping spectra. By using ratios of the derivative maxima, the exact compensation of either component in the mixture can be achieved, followed by its determination. These proposed methods have been successfully applied to the binary mixtures and soft drinks and the results were statistically compared with the reference HPLC method (NMKL 130).

Analysis of Sartans: a review

The risk of cardiovascular diseases is closely related to hypertension, high cholesterol levels, and diabetes. When these risk factors appear together they are referred to as a metabolic syndrome. In the treatment of cardiovascular diseases, a combination of antihypertensive, hypolipemiant, and antidiabetic drugs is often applied. Diuretics (chlortalidone, hydrochlorothiazide, etc.) and angiotensin II receptors antagonist (sartans) are used to control hypertension, whereas statins (fluvastatin, simvastatin, etc.) are used to reduce cholesterol levels. This review is concerned with methods for the analysis of sartans in various matrices, such as pharmaceutical formulations, environmental and biological samples, and discusses the current status of stability studies of sartans . It also presents analytical methods for the simultaneous determination of sartans, diuretics, and statins.

Three different methods for determination of binary mixture of Amlodipine and Atorvastatin using dual wavelength spectrophotometry

Three simple, specific, accurate and precise spectrophotometric methods depending on the proper selection of two wavelengths are developed for the simultaneous determination of Amlodipine besylate (AML) and Atorvastatin calcium (ATV) in tablet dosage forms. The first method is the new Ratio Difference method, the second method is the Bivariate method and the third one is the Absorbance Ratio method. The calibration curve is linear over the concentration range of 4-40 and 8-32 μg/mL for AML and ATV, respectively. These methods are tested by analyzing synthetic mixtures of the above drugs and they are applied to commercial pharmaceutical preparation of the subjected drugs. Methods are validated according to the ICH guidelines and accuracy, precision, repeatability and robustness are found to be within the acceptable limit. The mathematical explanation of the procedures is illustrated.

Combining the isoabsorptive point in the ratio spectrum and the smart ratio difference methods for a single step determination of compounds with overlapped spectra

A new method significantly advantageous over the conventional spectrophotometric methods regarding simplicity, minimal data processing and applicability was developed. The new method is based on the fact that isoabsorptive points whenever present in an absorption spectrum will be retained even after division by a one component as a divisor in the ratio spectrum, in addition to a smart modification of the conventional ratio derivative and ratio subtraction methods. This modified method though simpler, enabled wider range of applications. The proposed method was applied for the analysis of brimonidine and timolol in laboratory prepared mixtures with mean percentage recoveries 100.64 ± 1.10 and 100.96 ± 1.16, respectively, and in their pharmaceutical formulation with mean percentage recoveries 100.88 ± 0.34 and 100.84 ± 0.72, respectively. The suggested method was validated according to USP guidelines and can be applied for routine analysis in quality control laboratories.

A smart simple spectrophotometric method for simultaneous determination of binary mixtures

A new simple spectrophotometric method was developed for the simultaneous determination of drugs with interfering spectra in binary mixtures without previous separation. The new method is based on a simple modification for the ratio subtraction method. This modification enabled wider range of application. The proposed ratio difference method was applied for the determination of brimonidine and timolol in laboratory prepared mixtures with mean percentage recoveries 100.40±2.29 and 101.23±1.30 respectively, and in their pharmaceutical formulation with mean percentage recoveries 101.08±0.44 and 100.66±0.52 respectively. The suggested ratio difference method was validated according to USP guidelines and can be applied for routine quality control testing.

Simultaneous determination of retinoic acid and hydroquinone in skin ointment using spectrophotometric technique (ratio difference method)

An innovative spectrophotometric method was developed for simultaneous determination of compounds with interfering spectra in binary mixtures without previous separation, showing significant advantages over the conventional methods regarding minimal data manipulation and applicability. The proposed method was applied for the determination of retinoic acid and hydroquinone in laboratory-prepared mixtures with mean percentage recoveries 100.13 ± 0.31 and 99.99 ± 0.04, respectively, and in their pharmaceutical formulation with mean percentage recoveries 100.13 ± 0.86 and 100.07 ± 0.58, respectively. The method was validated according to USP guidelines and can be applied for routine quality control testing.

Simultaneous determination of amlodipine and valsartan

A spectrophotometric method was developed for simultaneous determination of amlodipine (Aml) and valsartan (Val) without previous separation. In this method amlodipine in methanolic solution was determined using zero order UV spectrophotometry by measuring its absorbency at 360.5 nm without any interference from valsartan.

Valsartan spectrum in zero order is totally overlapped with that of amlodipine. First, second and third derivative could not resolve the overlapped peaks.

The first derivative of the ratio spectra technique was applied for the measurement of valsartan. The ratio spectrum was obtained by dividing the absorption spectrum of the mixture by that of amlodipine, so that the concentration of valsartan could be determined from the first derivative of the ratio spectrum at 290 nm. Quantification limits of amlodipine and valsartan were 10–80 μg/ml and 20–180 μg/ml respectively. The method was successfully applied for the quantitative determination of both drugs in bulk powder and pharmaceutical formulation.

Stability-indicating spectrophotometric methods for determination of tazarotene in the presence of its alkaline degradation product by derivative spectrophotometric techniques

The stability of tazarotene (TZ) was investigated and two stability-indicating methods-namely, first derivative and a derivative ratio spectrophotometric method-were used to determine tazarotene in the presence of its alkaline degradation product (HD) using methanol as a solvent. A linear relationship was obtained in the range 1-10 µg ml⁻¹ for both methods. By applying the proposed methods, it was possible to determine tazarotene in its pure powdered from with accuracy 99.35 ± 1.410 (n = 10) for the first derivative method and 99.45 ± 1.053 (n = 10) for the derivative ratio method. First derivative and derivative ratio methods were used for the analysis of laboratory-prepared mixtures containing different ratios of tazarotene and its degradation product and they were valid in the presence of up to 70% and 80% degradation product, respectively. The proposed methods were validated and found to be suitable as stability-indicating assay methods for tazarotene in pharmaceutical formulations.

Biovalidation of an SPE-HPLC-UV-fluorescence method for the determination of Valsartan and its metabolite valeryl-4-hydroxy-valsartan in human plasma

A simple and fast method for the simultaneous determination of the antihypertensive drug Valsartan and its metabolite in human plasma has been validated. The proposed method deals with SPE, followed by an HPLC separation coupled with fluorimetric and photometric detection. The optimization of the SPE-HPLC method was achieved by an experimental design. The separation was performed on an RP C18 Atlantis 100 mmx3.9 mm column. The mobile phase consisted of a mixture of ACN 0.025% TFA and phosphate buffer (5 mM, pH = 2.5) 0.025% TFA and was delivered in gradient mode at a flow rate of 1.30 mL/min. The eluent was monitored with a fluorescence detector at 234 and 378 nm excitation and emission wavelengths, respectively, and at 254 nm using a photometric detector. The full analytical validation was performed according to the Food and Drug Administration (FDA) 'guidance for industry: bioanalytical method validation' and the recoveries obtained for Valsartan and its metabolite ranged from 94.6 to 108.8%. The validated method was successfully applied to 12 plasma samples obtained from patients under antihypertensive treatment with Valsartan.

Determination of hydrochlorothiazide and irbesartan in pharmaceuticals by fourth-order UV derivative spectrophotometry

The fourth-order derivative spectrum from the alcoholic sample is used. HCT can be determined by a specific peak-trough, of low intensity, at 330-340 nm. For IST evaluation, a peak-trough around 250-310 nm is available, common to both products, whose amplitude increases linearly only for low concentration values, while it decreases at higher values. The most difficult aspect of the analysis lies in how to find the optimal concentration range, so that both signals can be evaluated simultaneously. The best results were achieved by using a linear regression for HCT and a regression plane for IST.

Recent Developments of Derivative Spectrophotometry and Their Analytical Applications

Articles about the development of derivative spectrophotometric methods and analytical applications of derivative spectrophotometry (DS) published in the last nine years (since 1994) are reviewed.

Simultaneous determination of irbesartan and hydrochlorothiazide in human plasma by liquid chromatography

A simple, selective, sensitive and precise high-performance liquid chromatographic plasma assay for the antihypertensive drugs, irbesartan and hydrochlorothiazide is described. Good chromatographic separation was achieved using a Supelcocil C(18) (5 micrometer 15 cmx4.6 mm) column and a mobile phase consisting of 10 mM potassium dihydrogen phosphate:methanol:acetonitrile (5:80:15 v/v/v) (pH:2.5) while at a flow-rate of 1.0 ml min(-1). Irbesartan and hydrochlorothiazide were detected at 275 nm and were eluted 5.8 and 7.8 min, respectively, after injection. No endogenous substances were found to interfere. The method utilizes protein precipitation with acetonitrile as the only sample preparation involved prior to reversed-phase high-performance liquid chromatography. No internal standard was required. Linearity range for irbesartan and hydrochlorothiazide was 10.0-60.0 microgram ml(-1) and 4.0-20.0 microgram ml(-1), respectively. The determination of intra- and inter-day precision (RSD) was less than 2.5 and 3.5%, at all concentration levels, while the inter- and intra-day accuracy (% difference) was less than 4.9-6.2%. This method is being used in a therapeutic drug monitoring service to quantitate these therapeutic agents in patients for pharmacokinetic studies.