A potential high-throughput method for the determination of lipase activity by potentiometric flow injection titrations

Potentiometric FIA titrations were performed to determine enzyme activities of lipase type B from Candida antarctica, CAL-B. Two substrates, triacetin and tributyrin were hydrolyzed in phosphate buffer solutions, and the concentration change of the base component of the buffer was titrated in a carrier solution containing hydrochloric acid and potassium chloride. The system was calibrated with butyric acid and acetic acid, respectively. FIA titration peaks were evaluated with respect to peak height and peak area. Butyric acid and acetic acid could be titrated in the buffer solution from 3x10(-3) mol L(-1) to 0.1 mol L(-1). The detection limit of enzyme activity was determined to be 0.07 U mL(-1) (15 min reaction time) and the minimum activity was calculated to be 0.035 units corresponding to 35 nmol min(-1). The specific activities of lipase B for the hydrolysis of tributyrin and triacetin were determined as 16+/-2 U mg(-1) and 2+/-0.2 U mg(-1) (per mg commercial lipase preparation), respectively.

FIA acid–base titrations with a new flow-through pH detector

A pH-sensitive detector for flow-through potentiometry based on a graphite/quinhydrone composite electrode was applied for flow-injection analysis (FIA) titrations. Hydrochloric acid and acetic acid were titrated by injection of samples into a sodium hydroxide carrier solution. System conditions were optimised by variation of flow rate, injection volume and titrant concentration. The parameters sampling frequency, residence time and dispersion coefficient were determined. The evaluation of peak width (time between the two inflection points on each side of the peak), peak area and slope of the raising edge of the peak lead were studied with respect to their use for calibration. Hydrochloric acid and acetic acid could be titrated down to a concentration of 2 x 10(-4) mol L(-1) using 150-microL injection volumes, which is almost ten times lower than can be achieved using colour indicators and a spectrophotometric detection.