Contamination of the marine environment by Antarctic research stations: Monitoring marine pollution at Casey station from 1997 to 2015

The contamination of the marine environment surrounding coastal Antarctic research stations remains insufficiently understood in terms of its extent, persistence, and characteristics. We investigated the presence of contaminants in marine sediments near Casey Station, located in the Windmill Islands of East Antarctica, during the period spanning from 1997 to 2015. Metals, hydrocarbons, PBDEs, PCBs, and nutrients were measured in sediments at anthropogenically disturbed sites, including the wastewater outfall, the wharf area, two former waste disposal sites, and various control locations. Sampling was carried out at three spatial scales: Locations, which were generally kilometres apart and formed the primary scale for comparison; Sites, which were 100 meters apart within each location; and Plots, which were 10 meters apart within each site. Consistently higher concentrations of most contaminants, and in some cases nutrients, were observed at disturbed locations. Some locations also exhibited an increase in contaminant concentrations over time. The spatial distribution of sediment properties (such as grain size and organic matter) and contaminants displayed intricate patterns of variation. Variation in grain size depended on the size category, with fine grains (e.g., <63 μm) showing the greatest variation at the Location scale, while coarse grains exhibited minimal variation at this scale. Contaminant levels demonstrated significant differences between Locations, accounting for approximately 55% of the overall variation for metals, while the variation within the 10-meter scale generally exceeded that within the 100-meter scale. Residual variation among replicate samples was also very high, demonstrating the need for adequate replication in studies of sediments and contaminants around stations. Some contaminants exceeded international guidelines for sediment quality, including metals, hydrocarbons, and PCBs. We conclude that Antarctic research stations such as Casey are likely to pose a moderate level of long-term ecological risk to local marine ecosystems through marine pollution. However, contamination is expected to be confined to areas in close proximity to the stations, although its extent and concentration are anticipated to increase with time. Raising awareness of the contamination risks associated with Antarctic stations and implementing monitoring programs for marine environments adjacent to these stations can contribute to informed decision-making and the improvement of environmental management practices in Antarctica.

Simultaneous removal of trace elements from contaminated waters by living Ulva lactuca

This work shows the capabilities of living seaweed, Ulva lactuca, to remove As, Cd, Pb, Cu, Cr, Hg, Mn and Ni from contaminated waters. Experiments were performed with three algal doses (1.5, 3.0 and 6.0 g L^-1, FW), two ionic strengths (salinity 15 and 35), and trace element concentrations corresponding to the maximum allowed values in wastewaters. The highest removals were obtained with the algal dose of 6 g L^-1, with efficiencies varying between 48% for As and 98% for Hg, after 24 to 72 h. Salinity showed no effect on the removal efficiency. Overall, Elovich model was the best in describing the kinetics of the process, except for Hg, where pseudo-second-order model performed better. The use of extractions with EDTA (0.001, 0.01 to 0.1 mol L^-1) has clarified that most of the Hg (≈98%) and Cr (≈80%) crossed the macroalgae walls, while Ni, Cd and As were retained at the surface (between 60 and 80%). These results support the hypothesis that macroalgae-based technologies may be a viable, cost-effective, and greener option to reduce the rejection of priority hazardous substances in contaminated waters.

Cyclic fractionation process for Saccharina latissima using aqueous chelator and ion exchange resin

A new approach to process Saccharina latissima algal biomass was developed using sodium citrate and a polyvalent cation-specific resin to sequentially extract the alginate into several usable fractions. The fractionation was performed in a cyclic manner, utilizing a stepwise removal of the native polyvalent ions present in the algae to isolate fractions of alginate with different solubility in the presence of these ions. Sodium citrate was used in different concentrations in the extraction solution to remove polyvalent cations to adjust the alginate liberation while AMBERLITE IRC718 resin was added to further remove these ions and regenerate the extraction solution. Alginate was recovered by acid precipitation and analyzed for its uronic acid composition and molecular weight, and the carbohydrate compositions of the insoluble and soluble parts of the algal biomass residue were determined. Finally, the fractionation method was assessed with a life cycle analysis to determine the energy and water efficiency as well as the greenhouse gas emissions and the results were compared to conventional alkaline extraction. The results indicate that the energy and water use as well as the emissions are considerably lower for the cyclic extraction in comparison with the conventional methods.

Removal of Hardness of Earth Alkaline Metals from Aqueous Solutions by Ion Exchange Method

An ion exchange process was introduced as an approach for softening of artificial hard water solutions. A strong acid cation exchange resin, Amberlite IR 120 [Na+], was used to reduce the hardness of water with the matrix of styrene-divinylbenzene copolymer having functional group as sulfonate. The ion exchange behavior of the ions of calcium and magnesium in synthetic solutions of hard water was investigated with the variables depending on pH, stirrer speed of the solutions and amount of the resin as a function of contact time between resin phase and hard water solution. The maximum ion exchange capacity was found to be 68 mg/g for Ca(II) and 12 mg/g for Mg(II) at pH 3.0. The method is a simple and efficient one to remove calcium and magnesium hardness from hard water solutions with the resin having more selectivity for calcium.