The effect of geometric and topologic differences in boundary element models on magnetocardiographic localization accuracy

The magnetocardiogram

The magnetic field produced by the heart's electrical activity is called the magnetocardiogram (MCG). The first 20 years of MCG research established most of the concepts, instrumentation, and computational algorithms in the field. Additional insights into fundamental mechanisms of biomagnetism were gained by studying isolated hearts or even isolated pieces of cardiac tissue. Much effort has gone into calculating the MCG using computer models, including solving the inverse problem of deducing the bioelectric sources from biomagnetic measurements. Recently, most magnetocardiographic research has focused on clinical applications, driven in part by new technologies to measure weak biomagnetic fields.

Clinical magnetocardiography: the unshielded bet-past, present, and future

Magnetocardiography (MCG), which is nowadays 60 years old, has not yet been fully accepted as a clinical tool. Nevertheless, a large body of research and several clinical trials have demonstrated its reliability in providing additional diagnostic electrophysiological information if compared with conventional non-invasive electrocardiographic methods. Since the beginning, one major objective difficulty has been the need to clean the weak cardiac magnetic signals from the much higher environmental noise, especially that of urban and hospital environments. The obvious solution to record the magnetocardiogram in highly performant magnetically shielded rooms has provided the ideal setup for decades of research demonstrating the diagnostic potential of this technology. However, only a few clinical institutions have had the resources to install and run routinely such highly expensive and technically demanding systems. Therefore, increasing attempts have been made to develop cheaper alternatives to improve the magnetic signal-to-noise ratio allowing MCG in unshielded hospital environments. In this article, the most relevant milestones in the MCG's journey are reviewed, addressing the possible reasons beyond the currently long-lasting difficulty to reach a clinical breakthrough and leveraging the authors' personal experience since the early 1980s attempting to finally bring MCG to the patient's bedside for many years thus far. Their nearly four decades of foundational experimental and clinical research between shielded and unshielded solutions are summarized and referenced, following the original vision that MCG had to be intended as an unrivaled method for contactless assessment of the cardiac electrophysiology and as an advanced method for non-invasive electroanatomical imaging, through multimodal integration with other non-fluoroscopic imaging techniques. Whereas all the above accounts for the past, with the available innovative sensors and more affordable active shielding technologies, the present demonstrates that several novel systems have been developed and tested in multicenter clinical trials adopting both shielded and unshielded MCG built-in hospital environments. The future of MCG will mostly be dependent on the results from the ongoing progress in novel sensor technology, which is relatively soon foreseen to provide multiple alternatives for the construction of more compact, affordable, portable, and even wearable devices for unshielded MCG inside hospital environments and perhaps also for ambulatory patients.

Unshielded magnetocardiography: Repeatability and reproducibility of automatically estimated ventricular repolarization parameters in 204 healthy subjects

BACKGROUND

Magnetocardiographic mapping (MCG) provides quantitative assessment of the magnetic field (MF) induced by cardiac ionic currents, is more sensitive to tangential currents, and measures vortex currents undetectable by ECG, with higher reported sensitivity of MCG ventricular repolarization (VR) parameters for earlier detection of acute myocardial ischemia. Aims of this study were to validate the feasibility of in-hospital unshielded MCG and to assess repeatability and reproducibility of quantitative VR parameters, considering also possible gender- and age-related variability.

METHODS

MCG of 204 healthy subjects [114 males-mean age 43.4 ± 17.3 and 90 females-mean age 40.2 ± 15.7] was retrospectively analyzed, with a patented proprietary software automatically estimating twelve VR parameters derived from the analysis of the dynamics of the T-wave MF extrema (five parameters) and from the inverse solution with the effective magnetic dipole model giving the effective magnetic vector components (seven parameters). MCG repeatability was calculated as coefficient of variation (CV) ±standard error of the mean (SEM). Reproducibility was assessed as intraclass correlation coefficient (ICC).

RESULTS

The repeatability of all MCG parameters was 16 ± 1.2 (%) (average CV ± SEM). Optimal (ICC > 0.7) reproducibility was found for 11/12 parameters (mean values) and in 8/12 parameters (single values). No significant gender-related difference was observed; six parameters showed a strong/moderate correlation with age.

CONCLUSION

Reliable MCG can be performed into an unshielded hospital ambulatory, with repeatability and reproducibility of quantitative assessment of VR adequate for clinical purposes. Wider clinical use is foreseen with the development of multichannel optical magnetometry.

Experimental and Computational Models for Simulating Sound Propagation Within the Lungs

An acoustic boundary element model is used to simulate sound propagation in the lung parenchyma and surrounding chest wall. It is validated theoretically and numerically and then compared with experimental studies on lung-chest phantom models that simulate the lung pathology of pneumothorax. Studies quantify the effect of the simulated lung pathology on the resulting acoustic field measured at the phantom chest surface. This work is relevant to the development of advanced auscultatory techniques for lung, vascular, and cardiac sounds within the torso that utilize multiple noninvasive sensors to create acoustic images of the sound generation and transmission to identify certain pathologies.

Boundary element model for simulating sound propagation and source localization within the lungs

An acoustic boundary element (BE) model is used to simulate sound propagation in the lung parenchyma. It is computationally validated and then compared with experimental studies on lung phantom models. Parametric studies quantify the effect of different model parameters on the resulting acoustic field within the lung phantoms. The BE model is then coupled with a source localization algorithm to predict the position of an acoustic source within the phantom. Experimental studies validate the BE-based source localization algorithm and show that the same algorithm does not perform as well if the BE simulation is replaced with a free field assumption that neglects reflections and standing wave patterns created within the finite-size lung phantom. The BE model and source localization procedure are then applied to actual lung geometry taken from the National Library of Medicine's Visible Human Project. These numerical studies are in agreement with the studies on simpler geometry in that use of a BE model in place of the free field assumption alters the predicted acoustic field and source localization results. This work is relevant to the development of advanced auscultatory techniques that utilize multiple noninvasive sensors to construct acoustic images of sound generation and transmission to identify pathologies.

Construction of patient-specific surface models from MR images: application to bioelectromagnetism

Patient-specific geometric models are needed in many engineering problems. This work reports a novel software tool developed to construct individualized triangulated surface models from MR images. The program consists of three main parts: segmentation, triangulation and registration. The software tool was developed under the UNIX operating system. The application area demonstrated in this work is bioelectromagnetism but the program can be used as well in other engineering problems. The tool has been successfully applied in numerous cases, both for the thorax and the head.

A 3-D model-based registration approach for the PET, MR and MCG cardiac data fusion

In this paper, a new approach is presented for the assessment of a 3-D anatomical and functional model of the heart including structural information from magnetic resonance imaging (MRI) and functional information from positron emission tomography (PET) and magnetocardiography (MCG). The method uses model-based co-registration of MR and PET images and marker-based registration for MRI and MCG. Model-based segmentation of MR anatomical images results in an individualized 3-D biventricular model of the heart including functional parameters from PET and MCG in an easily interpretable 3-D form.