Effect of microstructure of low carbon steels on ultrasonic attenuation

Detection of Microstructural Changes in Metastable AISI 347, HSS Z-M4 and Tool Steel Ferrotitanit WFN by Mechanical Loss Coefficient at Ultrasonic Frequencies

Ultrasonic processes such as ultrasonic welding or ultrasonic fatigue testing use power ultrasound to stimulate materials with amplitudes in the range of 1-100 µm. The ultrasonic welding process is sensitive to any changes in the system or even the environment that may result in lower joint quality. The welding tools, so called sonotrodes, have to be accurately designed to endure high mechanical and thermal loads while inducing a sufficient amount of welding energy into the joining zone by oscillation with the Eigenfrequency of the whole system. Such sonotrodes are often made of thermally treated metals where the heat treatment is accompanied by microstructural changes. During ultrasonic stimulation, the material may further change its properties and microstructure due to cyclic loading. Both are expected to be recognized and identified by loss coefficients. Therefore, the loss coefficient was determined by modal analysis of rods and fatigue specimen made of different materials to correlate microstructural changes to attenuation. The determined loss coefficients indicated microstructural changes in all materials investigated, confirming results from previous investigations that showed an increasing attenuation due to cyclic loading for AISI 347. For the sonotrode materials Z-M4 PM and Ferrotitanit WFN, the loss coefficients decreased due to thermal treatments. Technically most relevant, changes in elastic modulus due to thermal treatments were quantitatively related to frequency changes, which can significantly simplify future sonotrode development.

A Comprehensive Report on Ultrasonic Attenuation of Engineering Materials, Including Metals, Ceramics, Polymers, Fiber-Reinforced Composites, Wood, and Rocks

In this paper, ultrasonic attenuation of engineering materials is evaluated comprehensively, covering metals, ceramics, polymers, fiber-reinforced composites, wood, and rocks. After verifying two reliable experimental methods, 336 measurements are conducted and their results are tabulated. Attenuation behavior is determined over broadband spectra, extending up to 15 MHz in low attenuating materials. The attenuation spectra are characterized in combination with four power law terms, with many showing linear frequency dependence, with or without Rayleigh scattering. Dislocation damping effects are re-evaluated and a new mechanism is proposed to explain some of the linear frequency dependencies. Additionally, quadratic and cubic dependencies due to Datta–Kinra scattering and Biwa scattering, respectively, are used for some materials to construct model relations. From many test results, some previously hidden behaviors emerged upon data evaluation. Effects of cold working, tempering, and annealing are complex and sometimes contradictory. Comparison to available literature was attempted for some, but most often prior data were unavailable. This collection of new attenuation data will be of value in materials selection and in designing structural health monitoring and non-destructive inspection protocols.