Development of a Numerical Pump Testing Framework

Improving Trendelenburg position effectiveness by varying cardiopulmonary bypass flow

INTRODUCTION

Trendelenburg position (TP) is used to transport gaseous emboli away from the cerebral region during cardiac surgery. However, TP effectiveness has not been fully considered when combined with varying the cardiopulmonary bypass (CPB) flow. This study simulated the supine and TP at different pump flows and assessed the trapped emboli and embolic load entering the aortic arch branch arteries (AABA).

METHODS

A computational fluid dynamics (CFD) approach used a centrally cannulated adult patient-specific aorta model replicating a CPB circuit. Air emboli of 0.1 mm, 0.5 mm, and 1.0 mm (n = 700 each) were injected into the aorta placed in the supine position (0°) and the TP (-20°) at 2 L/min and 5 L/min. The number of emboli entering the AABA were compared. An aortic phantom flow experiment was performed to validate air bubble behaviour.

RESULTS

TP at 5 L/min had the lowest 0.1 mm mean (±SD) embolic load compared to the supine 2 L/min (55.3 ± 30.8 vs 64.3 ± 35.4). For both the supine and TP, the lower flow of 2 L/min had the highest number of simulated trapped emboli in higher elevated regions than at 5 L/min (541 ± 185 and 548 ± 191 vs 520 ± 159 and 512 ± 174), respectively. The flow experiment demonstrated that 2 L/min promoted bubble coalescence and high amounts of trapped emboli and 5 L/min transported air emboli away from the AABA.

CONCLUSIONS

TP effectiveness was improved by using CPB flow to manage air emboli. These results provide insights for predicting emboli behaviour and improving emboli de-airing procedures.

Analysis of Cleveland Clinic continuous-flow total artificial heart performance using the Virtual Mock Loop: Comparison with an in vivo study

The Virtual Mock Loop (VML) is a mathematical model designed to simulate mechanism of the human cardiovascular system interacting with mechanical circulatory support devices. Here, we aimed to mimic the hemodynamic performance of Cleveland Clinic's self-regulating continuous-flow total artificial heart (CFTAH) via VML and evaluate the accuracy of the VML compared with an in vivo acute animal study. The VML reproduced 124 hemodynamic conditions from three acute in vivo experiments in calves. Systemic/pulmonary vascular resistances, pump rotational speed, pulsatility, and pulse rate were set for the VML from in vivo data. We compared outputs (pump flow, left and right pump pressure rises, and atrial pressure difference) between the two systems. The pump performance curves all fell in the designed range. There was a strong correlation between the VML and the in vivo study in the left pump flow (r2 = 0.84) and pressure rise (r2 = 0.80), and a moderate correlation in right pressure rise (r2 = 0.52) and atrial pressure difference (r2 = 0.59). Although there is room for improvement in simulating right-sided pump performance of self-regulating CFTAH, the VML acceptably simulated the hemodynamics observed in an in vivo study. These results indicate that pump flow and pressure rise can be estimated from vascular resistances and pump settings.

Competing Flow Between Partial Circulatory Support and Native Cardiac Output: A Clinical Computational Fluid Dynamics Study

Partial circulatory support is a promising concept for the treatment of heart failure patients. A better understanding of induced hemodynamic changes is essential for optimizing treatment efficacy. Computational fluid dynamics (CFD) is an alternative method to gain insight into flow phenomena difficult to obtain in vivo. In 10 patients implanted with a Circulite Synergy Micro-pump (HeartWare, Framingham, Massachusetts) (a continuous flow partial circulatory assist device connecting the left atrium to the right subclavian artery), transient CFD simulations were performed. Patients were divided into two groups depending on their cardiac output (CO; high CO group: 5.5 ± 1.1 L/min, low CO group: 1.7 ± 0.7 L/min). The partial assist device provided a supporting flow of 1.5 ± 0.8 L/min. Support was highest at diastole and decreased during systole because of a collision of the blood flows from the partial assist device and the CO. Reversed flow counteracting the flow of the device was significantly higher for the high CO group (mean flow in peak systole: -2.18 ± 1.08 vs. 0.23 ± 0.59 L/min; p = 0.002) showing an inverse correlation between CO and amount of reversed flow during peak systole (R = -0.7; p < 0.02). The flow collision lead to higher total pressures at the point of collision and consequently in the Circulite outflow graft. The CFD simulations allow quantifying hemodynamic alterations in patients with partial support consisting of a flow collision, thereby reducing effectiveness of the circulatory support. Partial support in heart failure patients alternates their hemodynamics not only in providing support for the circulation but also inducing unfavorable changes in flow patterns.

Hemodynamic analysis of outflow grafting positions of a ventricular assist device using closed-loop multiscale CFD simulations: Preliminary results

Subclavian arteries are a possible alternate location for left ventricular assist device (LVAD) outflow grafts due to easier surgical access and application in high risk patients. As vascular blood flow mechanics strongly influence the clinical outcome, insights into the hemodynamics during LVAD support can be used to evaluate different grafting locations. In this study, the feasibility of left and right subclavian artery (SA) grafting was investigated for the HeartWare HVAD with a numerical multiscale model. A 3-D CFD model of the aortic arch was coupled to a lumped parameter model of the cardiovascular system under LVAD support. Grafts in the left and right SA were placed at three different anastomoses angles (90°, 60° and 30°). Additionally, standard grafting of the ascending and descending aorta was modelled. Full support LVAD (5l/min) and partial support LVAD (3l/min) in co-pulsation and counter-pulsation mode were analysed. The grafting positions were investigated regarding coronary and cerebral perfusion. Furthermore, the influence of the anastomosis angle on wall shear stress (WSS) was evaluated. Grafting of left or right subclavian arteries has similar hemodynamic performance in comparison to standard cannula positions. Angularity change of the graft anastomosis from 90° to 30° slightly increases the coronary and cerebral blood flow by 6-9% while significantly reduces the WSS by 35%. Cannulation of the SA is a feasible anastomosis location for the HVAD in the investigated vessel geometry.