Encapsulation and characterisation of grape seed proanthocyanidin extract using sodium alginate and different cellulose derivatives

Stability enhancement of proanthocyanidin-loaded liposomes via surface decoration with oxidized konjac glucomannan

The stability enhancement of proanthocyanidin-loaded liposomes (PC-Lip) via surface decoration with oxidized konjac glucomannan (OKGM) was investigated. The encapsulation efficiency and drug loading capacity of OKGM-coated PC-Lip (OKGM-PC-Lip) rose significantly. The average size and PDI of OKGM-PC-Lip increased, while the zeta potential decreased compared to those of PC-Lip. PC-Lip membrane fluidity reduced after coating with OKGM. The morphology of OKGM-PC-Lip showed that OKGM "halo layer" was formed on the liposome surface. Hydrogen bonding played an indispensable role in the combination between OKGM and PC-Lip, and the phase transition temperature of PC-Lip slightly increased after coating with OKGM. The retention rate of OKGM-PC-Lip was higher than that of PC-Lip at extreme pH. In vitro release, no significant difference in cumulative release was detected between OKGM-PC-Lip and PC-Lip at gastric stage, while the cumulative release rate of OKGM-PC-Lip was remarkably lower than that of PC-Lip at intestinal stage. The antioxidant activity of OKGM-PC-Lip was notably higher than that of PC-Lip. These results suggested that the resistance of PC-Lip to external influences was fruitfully enhanced after coating with OKGM. Compared with other polysaccharides, OKGM-coated liposomes may be more promising and advantageous in functional foods due to the polysaccharide's benefits to human health.

Performance of spray-dried Ziziphus jujuba extract using insoluble fraction of Persian gum-sodium alginate and whey protein: Microstructural and physicochemical attributes of micro- and nano-capsules

The study focused on the impact of the insoluble fraction of Persian gum-sodium alginate and a blend of the insoluble fraction of Persian gum-sodium alginate (IFPG-Al) with whey protein isolate (WPI) on sprayed Ziziphus jujuba extract (JE) powder. The addition of whey protein led to powders with higher moisture (10%), higher solubility (99.19%), and lower powder yield (27.82%). The powders fabricated with WPI depicted the best protection of polyphenolic compounds (3933.4 mg/L) and the highest encapsulation efficiency activity (74.84%). Additionally, they had a higher T g (62.63°C), which indicates more stability of the powders during shelf life. The sphericity of the majority of the particles was noticeable in powders, but multi-sided concavities were visible in the protein-containing particles. Based on the particle size's results, IFPG-Al/WPI capsules fabricated relatively smaller particles (2.54 μm). It can be acknowledged that the presence of protein in particles can bring fruitful results by preserving valuable bioactive compounds.

Facile fabrication of temperature/pH dual sensitive hydrogels based on cellulose and polysuccinimide through aqueous amino-succinimide reaction

A temperature/pH dual sensitive hydrogel with a semi-interpenetrating network (semi-IPN) structure was synthesized through an aqueous amino-succinimide reaction between water-soluble polysuccinimide and polyethyleneimine in the presence of thermosensitive cellulose derivatives. Single-factor experiments were carried out to optimize the preparation conditions of the semi-IPN hydrogel. The swelling behavior and cytotoxicity assay of the hydrogel were tested. Finally, taking 5- fluorouracil (5-Fu) as a model drug, the release performance of the 5-Fu-loaded hydrogel was investigated. The results indicated that the swelling ratio (SR) first decreased and then increased when the pH of the solutions ascended from 2 to 10. The SR decreased with the increase in temperature. In addition, the swelling behavior of the hydrogel was reversible and reproducible under different pH values and temperatures. The prepared hydrogels had good cytocompatibility. The release behavior of 5-Fu was most consistent with the Korsmeyer-Peppas model and followed the case II diffusion. The acidic environment was beneficial for the release of 5-Fu. The preparation process of the semi-IPN hydrogel is simple and the reaction can proceed quickly in water. The strategy introduced here has great potential for application in the preparation of drug carriers.

Effect of Callus Cell Immobilization on the Textural and Rheological Properties, Loading, and Releasing of Grape Seed Extract from Pectin Hydrogels

The purpose of the present study was to prepare pectin hydrogels with immobilized Lemna minor callus cells and to identify the effect of cell immobilization on the textural, rheological, and swelling properties; loading; and releasing of grape seed extract (GSE) from the hydrogels. Hardness, adhesiveness, elasticity, the strength of linkage, and complex viscosity decreased with increasing cell content in the hydrogels based on pectin with a degree of methyl esterification (DM) of 5.7% (TVC) and during incubation in gastrointestinal fluids. An increase in the rheological properties and fragility of pectin/callus hydrogels based on pectin with a DM of 33.0% (CP) was observed at a cell content of 0.4 g/mL. TVC-based pectin/callus beads increased their swelling in gastrointestinal fluids as cell content increased. TVC-based beads released GSE very slowly into simulated gastric and intestinal fluids, indicating controlled release. The GSE release rate in colonic fluid decreased with increasing cell content, which was associated with the accumulation of GSE in cells. CP-based beads released GSE completely in the intestinal fluid due to weak textural characteristics and rapid degradation within 10 min. Pectin/callus hydrogels have the ability to preserve GSE for a long time and may have great potential for the development of proanthocyanidin delivery systems due to their novel beneficial physicochemical and textural properties.

Encapsulation and Characterization of Proanthocyanidin Microcapsules by Sodium Alginate and Carboxymethyl Cellulose

Proanthocyanidins are important compounds known for their antioxidant and radical scavenging properties, but they are highly sensitive to light, heat, oxygen, and pH. In our study, proanthocyanidin was encapsulated using sodium alginate and carboxymethyl cellulose to enhance controlled release, pH stability, metal ion tolerance, temperature resistance, time release, the microencapsulation of food additives stability, antioxidant capacity analysis, and the storage period tolerance of proanthocyanidin. Fourier transforms infrared (FTIR) analysis and full-wavelength UV scanning indicated the successful immobilization of proanthocyanidins into the polymeric microcapsules. The flowability and mechanical properties of the microcapsules were enhanced. Moreover, proanthocyanidin microcapsules exhibited higher thermal, pH, metal ion, time, and microencapsulation food additive stability. In addition, due to their high antioxidant properties, the proanthocyanidin microcapsules retained a greater amount of proanthocyanidin content during the gastric phase, and the proanthocyanidin was subsequently released in the intestinal phase for absorption. Thus, the study provided a systematic understanding of the antioxidant capabilities and stability of proanthocyanidin microcapsules, which is beneficial for developing preservation methods for food additives.

Microcapsules and Nanoliposomes Based Strategies to Improve the Stability of Blueberry Anthocyanins

Blueberry anthocyanins are water-soluble natural pigments that can be used as both natural antioxidants and natural colorants. However, their structural instability greatly limits their application in the food, pharmaceutical, and cosmetic industries. In this study, blueberry anthocyanin microcapsules (BAM) and blueberry anthocyanin liposomes (BAL) were fabricated based on blueberry anthocyanins. Film dispersion methods were used to prepare the BAL. Their preparation processes were optimized and compared to improve the stability of the blueberry anthocyanins following exposure to light and high temperatures. The BAM were prepared through complex phase emulsification. The blueberry anthocyanins were protected by the shell materials composed of sodium alginate after being formed into BAM. Under the optimal conditions, the embedding rate of BAM and BAL can reach as high as 96.14% and 81.26%, respectively. In addition, the particle size, zeta potential, microtopography, and structure feature information of the BAM and BAL were compared. The average particle sizes of the BAM and BAL were 9.78 μm and 290.2 nm, respectively, measured using a laser particle size analyzer, and the zeta potentials of the BAM and BAL were 34.46 mV and 43.0 mV, respectively. In addition, the optimal preparation processes were determined through single-factor and response surface optimization experiments. The most important factors in the single-factor experiment for the preparation of microcapsules and liposomes were the content of CaCl2 and the amount of anthocyanin. The preservation rates in the light and dark were also compared, and the thermal stabilities of the BAM and BAL were characterized through differential thermal scanning. The results showed that both the BAM and BAL maintained the stability of blueberry anthocyanins, and no significant difference was found between the indices used to evaluate their stability. The results of this study provide theoretical support for the development of effective systems to maintain the stability of anthocyanins, thereby improving their bioavailability after ingestion by humans.

Encapsulation of Rosemary Extracts using High Voltage Electrical Discharge in Calcium Alginate/Zein/Hydroxypropyl Methylcellulose Microparticles

The increased demand for functional food with added health benefits is directing industrial procedures toward more sustainable production of naturally added bioactive compounds. The objective of this research was to investigate the potential of bioactive compounds from rosemary extract obtained using high-voltage electrical discharge as a green extraction method, for microencapsulation as a protective method for future application in functional food. Four types of microparticles were made via the ionic gelation method using alginate (Alg), zein (Z), and hydroxypropyl methylcellulose (HPMC) biopolymers and were analyzed considering the physicochemical properties. The diameter of dry microparticles ranged from 651.29 to 1087.37 μm. The shape and morphology analysis of microparticles showed that the obtained microparticles were quite spherical with a granular surface. The high encapsulation efficiency was obtained with a loading capacity of polyphenols up to 11.31 ± 1.47 mg GAE/g (Alg/Z microparticles). The microencapsulation method showed protective effects for rosemary polyphenols against pH changes during digestion. Specifically, the addition of both zein and HPMC to calcium-alginate resulted in microparticles with a prolonged release for better availability of polyphenols in the intestine. This research background indicates that the release of rosemary extract is highly dependent on the initial biopolymer composition with high potential for further functional food applications.

Ca-Alginate Hydrogel with Immobilized Callus Cells as a New Delivery System of Grape Seed Extract

The development of new delivery systems for polyphenols is necessary to maintain their antioxidant activity and targeted delivery. The purpose of this investigation was to obtain alginate hydrogels with immobilized callus cells, in order to study the interaction between the physicochemical properties of hydrogels, texture, swelling behaviour, and grape seed extract (GSE) release in vitro. The inclusion of duckweed (LMC) and campion (SVC) callus cells in hydrogels led to a decrease in their porosity, gel strength, adhesiveness, and thermal stability, and an increase in the encapsulation efficiency compared with alginate hydrogel. The incorporation of LMC cells (0.17 g/mL), which were smaller, resulted in the formation of a stronger gel. The Fourier transform infrared analyses indicated the entrapment of GSE in the alginate hydrogel. Alginate/callus hydrogels had reduced swelling and GSE release in the simulated intestinal (SIF) and colonic (SCF) fluids due to their less porous structure and the retention of GSE in cells. Alginate/callus hydrogels gradually released GSE in SIF and SCF. The faster GSE release in SIF and SCF was associated with reduced gel strength and increased swelling of the hydrogels. LMC-1.0Alginate hydrogels with lower swelling, higher initial gel strength, and thermal stability released GSE more slowly in SIF and SCF. The GSE release was dependent on the content of SVC cells in 1.0% alginate hydrogels. The data obtained show that the addition of callus cells to the hydrogel provides them with physicochemical and textural properties that are useful for the development of drug delivery systems in the colon.

Delivery system for grape seed extract based on biodegradable pectin-Zn-alginate gel particles

Pectin-Zn-alginate gel particles from callus culture pectin with increased linearity and decreased rhamnogalacturonan I branching and degree of methylesterification had a higher gel strength and encapsulation capacity. An increase of the alginate concentration led to an increase in the particle gel strength. The grape seed extract (GSE) loaded and empty particles swelled slightly in the simulated gastric fluid (SGF) and gradually in the intestinal (SIF) fluid. The swelling degrees of the GSE-loaded and empty particles in the simulated colonic fluids (SCF) were decreased in the range SCF-7.0 (pH 7.0 + pectinase) > SCF-5.3 (pH 5.3 + pectinase) > SCF-2.3 (pH 2.3 + pectinase). The FTIR spectra indicated that GSE was embedded in the composite particles. Negligible leakage of GSE in SGF was shown. The increase in GSE release in SIF was due to the decrease in particle gel strength and increased swelling degree. The GSE release in fluids simulating the colon inflammation (SCF-2.3 and SCF-5.3) was similar, and it was lower than that in the SCF-7.0 simulating a healthy colon due to the increased gel strength. The percentage release of GSE increased slightly after exposure to different pH. Pectin-Zn-alginate hydrogel systems may be promising candidates for colon-targeted GSE delivery systems.

Investigation of construction and characterization of carboxymethyl chitosan - sodium alginate nanoparticles to stabilize Pickering emulsion hydrogels for curcumin encapsulation and accelerating wound healing

Limitations in compatibility and effectiveness in delivering bioactive compounds often make it prohibitively difficult to apply Pickering emulsions in wound dressing. In this research, we prepared Pickering emulsion composite hydrogels based on carboxymethyl chitosan - sodium alginate (CMCS-SA) nanoparticles (NPs) stabilized Pickering emulsions, poloxamer 407 (PLX), and curcumin (CUR). CMCS-SA NPs were prepared and used to stabilize Pickering emulsion. The stability of Pickering emulsion improved with the increase of the concentration of NPs, and was highly sensitive to ionic strength change. This Pickering emulsion remained stable at various temperatures. After curcumin were introduced into the emulsion, 0.6% CMCS-SA NPs Pickering emulsion showed controlled release of curcumin in vitro. The CMCS-SA-PLX-CUR hydrogels also exhibited smooth surface and dense structure. This composite hydrogels has antibacterial properties against Escherichia coli and Staphylococcus aureus. Moreover, the CMCS-SA-PLX-CUR hydrogels improved wound healing and increased expression of Ki67 and CD31. RT-qPCR results indicated that the mRNA levels of α-SMA and TGF-β1 in the CMCS-SA-PLX-CUR group were downregulated, while the mRNA levels of TGF-β3 increased. The present study suggests that the potentials of CMCS-SA-PLX-CUR hydrogels are promising in protecting bioactive components and wound care management.