3D finite element models from serial section histology of skeletal muscle tissue - The role of micro-architecture on mechanical behaviour

In this contribution we create three-dimensional (3D) finite element models from a series of histological sections of porcine skeletal muscle tissue. Image registration is performed on the stained sections by affinely aligning them using auxiliary markers, followed by image segmentation to determine muscle fibres and the extracellular matrix in each section, with particular regard to the continuity of the fibres through the stack. With this information, 3D virtual tissue samples are reconstructed, discretised, and associated with appropriate non-linear elastic anisotropic material models. While the gross anatomy is directly obtained from the images, the local directions of anisotropy were determined by the use of an analogy with steady state diffusion. The influence of the number of histological sections considered for reconstruction on the numerically simulated mechanical response of the virtual tissue samples is then studied. The results show that muscle tissue is fairly heterogeneous along the fascicles, and that transverse isotropy is inadequate in describing their material symmetry at the typical length scale of a fascicle. Numerical simulations of different load cases suggest that ignoring the undulations of fibres and their non-uniform cross-sections only moderately affects the passive response of the tissue in tensile and compressive modes, but can become crucial when predicting the response to generic loads and activation.

Understanding the Role of ECM Protein Composition and Geometric Micropatterning for Engineering Human Skeletal Muscle

Skeletal muscle lost through trauma or disease has proven difficult to regenerate due to the challenge of differentiating human myoblasts into aligned, contractile tissue. To address this, we investigated microenvironmental cues that drive myoblast differentiation into aligned myotubes for potential applications in skeletal muscle repair, organ-on-chip disease models and actuators for soft robotics. We used a 2D in vitro system to systematically evaluate the role of extracellular matrix (ECM) protein composition and geometric patterning for controlling the formation of highly aligned myotubes. Specifically, we analyzed myotubes differentiated from murine C2C12 cells and human skeletal muscle derived cells (SkMDCs) on micropatterned lines of laminin compared to fibronectin, collagen type I, and collagen type IV. Results showed that laminin supported significantly greater myotube formation from both cells types, resulting in greater than twofold increase in myotube area on these surfaces compared to the other ECM proteins. Species specific differences revealed that human SkMDCs uniaxially aligned over a wide range of micropatterned line dimensions, while C2C12s required specific line widths and spacings to do the same. Future work will incorporate these results to engineer aligned human skeletal muscle tissue in 2D for in vitro applications in disease modeling, drug discovery and toxicity screening.

Structure and function of the skeletal muscle extracellular matrix

The skeletal muscle extracellular matrix (ECM) plays an important role in muscle fiber force transmission, maintenance, and repair. In both injured and diseased states, ECM adapts dramatically, a property that has clinical manifestations and alters muscle function. Here we review the structure, composition, and mechanical properties of skeletal muscle ECM; describe the cells that contribute to the maintenance of the ECM; and, finally, overview changes that occur with pathology. New scanning electron micrographs of ECM structure are also presented with hypotheses about ECM structure–function relationships. Detailed structure–function relationships of the ECM have yet to be defined and, as a result, we propose areas for future study.