Relationships between bone mass and micro-architecture at the mandible and iliac bone in edentulous subjects: a dual X-ray absorptiometry, computerised tomography and microcomputed tomography study

Computed Tomography Provides Improved Quantification of Trabecular Lumbar Spine Bone Loss Compared to Dual-Energy X-Ray Absorptiometry in Ovariectomized Sheep

Early detection of osteoporosis using advanced imaging is imperative to the successful treatment and prevention of high morbidity fractures in aging patients. In this preclinical study, we aimed to compare dual-energy X-ray absorptiometry (DXA) and quantitative computed tomography (QCT) to quantify bone mineral density (BMD) changes in the sheep lumbar spine. We also aimed to determine the relationship of BMD to microarchitecture in the same animals as an estimate of imaging modality precision. Osteoporosis was induced in 10 ewes via laparoscopic ovariectomy and administration of high-dose corticosteroids. We performed DXA and QCT imaging to measure areal BMD (aBMD) and trabecular volumetric BMD (Tb.vBMD)/cortical vBMD (Ct.vBMD), respectively, at baseline (before ovariectomy) and at 3, 6, 9, and 12 months after ovariectomy. Iliac crest bone biopsies were collected at each time point for micro-computed tomography (microCT) analysis; bone volume fraction (BV/TV), trabecular number (Tb.N), thickness (Tb.Th), and spacing (Tb.Sp) were reported. aBMD and Tb.vBMD both decreased significantly by 3 and 6 months (p < 0.05) compared with baseline, whereas no changes to Ct.vBMD were observed. Combined (Tb. and Ct.) vBMD was significantly correlated with aBMD at all time points (all p < 0.05). Additionally, greater significant correlations were found between BV/TV and Tb.vBMD at all five time points (R 2 = 0.54, 0.57, 0.66, 0.46, and 0.56, respectively) than with aBMD values (R 2 = 0.23, 0.55, 0.41, 0.20, and 0.19, respectively). The higher correlation of microCT values with QCT than with DXA indicates that QCT provides additional detailed information regarding bone mineral density changes in preclinical settings. Because trabecular bone is susceptible to rapid density loss and structural changes during osteoporosis, QCT can capture these subtle changes more precisely than DXA in a large animal preclinical model. © 2023 The Authors. JBMR Plus published by Wiley Periodicals LLC on behalf of American Society for Bone and Mineral Research.

Regional differences in microarchitecture and mineralization of the atrophic edentulous mandible: A microcomputed tomography study

OBJECTIVE

The aim of the present study was to assess mineralization and trabecular microarchitecture in atrophic edentulous mandibles and to identify regional differences and relations with the extent of resorption.

METHODS

Cortical and trabecular bone volumes in anterior, premolar and molar regions of 10 edentulous cadaveric mandibles (5 males and 5 females; mean age ± SD: 85.4 ± 8.3 years) were assessed by microcomputed tomography. Mandibular height and Cawood & Howell classes were recorded. Concerning trabecular volumes, bone mineral density (BMD), bone volume fraction, trabecular tissue volume fraction, connectivity density, trabecular number, trabecular thickness, trabecular separation, degree of anisotropy, and structural model index were measured; concerning cortical volumes porosity, BMD and cortical thickness were measured.

RESULTS

In molar regions, the bone volume fraction and trabecular number were lower, whereas trabecular separation, degree of anisotropy and cortical BMD were higher compared to anterior regions. In premolar regions, mandibular height correlated negatively with trabecular number (Spearman's correlation r = 0.73, p = 0.017) and connectivity density (Spearman's correlation r = 0.82, p = 0.004), and correlated positively with trabecular separation (Spearman's correlation r = - 0.65, p = 0.04). Cortical BMD was higher at bucco-inferior cortex of molar and inferior border of premolar region and lower at anterior cranial buccal and lingual surface.

CONCLUSIONS

In the premolar region, increased resorption coincides with local impairment of trabecular bone quality. Cortical bone BMD is higher in areas with highest strains and lower in areas with most mandibular resorption. Trabecular bone volume and quality is superior in the anterior region of the edentulous mandible, which might explain improved primary stability of dental implants in this region.

Dual-energy X-ray Absorptiometry Does Not Represent Bone Structure in Patients with Osteoporosis: A Comparison of Lumbar Dual-Energy X-Ray Absorptiometry with Vertebral Biopsies

STUDY DESIGN

Prospective cross-sectional exploratory study.

OBJECTIVE

To evaluate the correlation between in vivo lumbar dual-energy x-ray absorptiometry (DXA) and parameters of bone architecture in micro-computed tomography (micro-CT) in patients with osteoporosis.

SUMMARY OF BACKGROUND DATA

DXA is the current diagnostic standard for evaluating osteoporosis. However, there are various concerns regarding its validity, especially in the spine. No study has so far investigated whether in vivo DXA correlates with the actual lumbar bone architecture.

METHODS

Lumbar DXA scans were compared with micro-CT analysis of vertebral biopsies in patients with osteoporotic vertebral fractures (fracture group) and those without (control group). Preoperatively, all patients underwent a DXA scan (L1-L4). Intraoperative biopsies from nonfractured vertebrae (preferably L3) were analyzed by micro-CT regarding bone quantity and quality. The groups were compared regarding differences in DXA and micro-CT results. In each group, a correlation analysis was performed between DXA and micro-CT.

RESULTS

The study included 66 patients (33 per group). Preoperative DXA results were worse in the fracture group than the control group (areal bone mineral density [aBMD] 0.95 vs. 1.31, T-score -1.97 vs. 0.92, each P < 0.001). Micro-CT analysis confirmed differences regarding quantitative parameters (bone/total volume: 0.09 vs. 0.12, P < 0.001) and qualitative parameters (connectivity index: 15.73 vs. 26.67, P < 0.001; structure model index: 2.66 vs. 2.27, P < 0.001; trabecular number: 2.11 vs. 2.28, P = 0.014) of bone architecture between both groups. The DXA results did not correlate with micro-CT parameters in the fracture group. In the control group, correlations were found for some parameters (bone/total volume vs. aBMD: r = 0.51, P = 0.005; trabecular number vs. aBMD: r = 0.56, P = 0.001).

CONCLUSION

These data constitute the first comparison of DXA measurements with microstructural analysis of vertebral biopsies in patients with osteoporosis. Our results indicate that lumbar DXA neither qualitatively nor quantitatively represents microstructural bone architecture and is therefore not a reliable tool for the evaluation of bone quality in the spine.Level of Evidence: 3.

Microcomputed tomography (microCT) and histology of the mandibular canal in human and laboratory animals

The inferior alveolar nerve (IAN) is a sensitive branch of the trigeminal nerve. It has an intra-bone path in the mandible, inside the mandibular canal, where it is accompanied by lymph, venous and arterial vessels. We have studied the mandibular canal in human mandibles and in some laboratory animals (mice, rats, rabbits and cats). Microcomputed tomography evidenced that the walls of the canal are made with thin plates of trabecular bone with numerous fenestrations. This aspect is evidenced in dentate subjects and become more evident in edentulous subjects with atrophy of the alveolar bone. In rats and mice, the wall of the canal is also clearly composed of trabecular plates coming from the surrounding alveolar bone of the mandible. In the rabbit, similar findings are also observed but the trajectory of the canal is more difficult to identify. In the cat, the floor of the canal is composed of the cortical bone from the basilar cortex of the mandible and the roof has a trabecular nature. Vascular injections of gelatin-barium evidenced the arterial trajectories inside the bone in rats and humans. Undecalcified bone sections in human evidenced the histological aspect of the IAN and its connective sheets. Some nervous bundles can be observed outside the epineurium. Bone remodeling is observed on the wall of the mandibular canal. These descriptive findings have a clinical relevance in dental implantology or mandibular surgery.

Resorption of the mandibular residual ridge: A micro-CT and histomorphometrical analysis

OBJECTIVES

The aim of this study was to investigate whether the extent of mandibular resorption and gender is related to the bone turnover and microarchitecture of the edentulous mandible.

PARTICIPANTS AND METHODS

A mandibular bone sample was obtained at canine position from 36 edentulous participants (50% women; mean age: 65 years) during dental implant surgery. All female participants were postmenopausal. Mandibular height, duration of edentulous state and resorption pattern (Cawood classification) were recorded. Microcomputed tomography was used to determine bone mineral density, bone volume fraction, trabecular connectivity density, trabecular number, trabecular thickness and trabecular separation. Histomorphometric analysis was used to assess bone turnover: osteoid area and surface were measured as a parameter for bone formation and osteoclast numbers were determined as a parameter for bone resorption. Correlations between micro-CT, histomorphometrical parameters and clinical data were analysed with correlation coefficients and parametric and non-parametric tests.

RESULTS

Lower mandibular height was strongly associated with higher bone mineral density in trabecular bone. Women showed higher osteoclast numbers in trabecular bone than men. In trabecular bone of women, bone volume was significantly related to osteoclast numbers, osteoid surface and osteoid area.

CONCLUSIONS

The higher trabecular bone mineral density found in the edentulous mandible could either indicate a restructuring process of the resorbed mandible or suggests that the inferior region of the mandible is more highly mineralised. In women, higher bone turnover is associated with lower bone volume, suggesting an effect of postmenopausal oestrogen deficiency on bone turnover in the edentulous mandible.

IDIOS: An innovative index for evaluating dental imaging-based osteoporosis screening indices

Purpose

The goal of this study was to develop a new index as an objective reference for evaluating current and newly developed indices used for osteoporosis screening based on dental images. Its name; IDIOS, stands for Index of Dental-imaging Indices of Osteoporosis Screening.

Materials and Methods

A comprehensive PubMed search was conducted to retrieve studies on dental imaging-based indices for osteoporosis screening. The results of the eligible studies, along with other relevant criteria, were used to develop IDIOS, which has scores ranging from 0 (0%) to 15 (100%). The indices presented in the studies we included were then evaluated using IDIOS.

Results

The 104 studies that were included utilized 24, 4, and 9 indices derived from panoramic, periapical, and computed tomographic/cone-beam computed tomographic techniques, respectively. The IDIOS scores for these indices ranged from 0 (0%) to 11.75 (78.32%).

Conclusion

IDIOS is a valuable reference index that facilitates the evaluation of other dental imaging-based osteoporosis screening indices. Furthermore, IDIOS can be utilized to evaluate the accuracy of newly developed indices.

Agreement between Histomorphometry and Microcomputed Tomography to Assess Bone Microarchitecture of Dental Implant Sites

BACKGROUND

Histomorphometry and microcomputed tomography (microCT) have been used in implant studies but need better understanding before being used as equivalent methods.

PURPOSE

The purpose of this study was to investigate the agreement between 2D (histomorphometry) and 3D (microCT) reference methods for assessing jawbone microarchitecture in vivo.

MATERIAL AND METHODS

Forty-four bone specimens from 32 patients were obtained during implant placement and examined by microCT, followed by hematoxylin-eosin staining and histomorphometric analysis. The morphometric parameters included bone volume density (BV/TV), bone surface fraction (BS/TV), bone surface density, trabecular thickness, trabecular number, and trabecular separation (Tb.Sp). Bland-Altman plots were used for pairwise agreement analysis between the equivalent 3D and 2D parameters, and complemented with Mountain plots. The association between the two methods was tested using Pearson's correlation followed by Passing-Bablok regression.

RESULTS

Systematic bias was observed in all Bland-Altman and Mountain plots, including constant bias for BV/TV and Tb.Sp, and proportional bias for all other parameters. Significant correlation was found for BV/TV (r = 0.80; p < .001) and BS/TV (r = 0.44; p = .003), and the Passing-Bablok regression showed constant bias for BV/TV and proportional bias for BS/TV.

CONCLUSION

Because of the poor agreement between measures obtained by histomorphometry and microCT, these methods should not be used interchangeably for jawbones.

Texture analysis of computed tomographic images in osteoporotic patients with sinus lift bone graft reconstruction

OBJECTIVE

Bone implants are now widely used to replace missing teeth. Bone grafting (sinus lift) is a very useful way to increase the bone volume of the maxilla in patients with bone atrophy. There is a 6- to 9-month delay for the receiver grafted site to heal before the implants can be placed. Computed tomography is a useful method to measure the amount of remaining bone before implantation and to evaluate the quality of the receiver bone at the end of the healing period. Texture analysis is a non-invasive method useful to characterize bone microarchitecture on X-ray images.

PATIENTS AND METHODS

Ten patients in which a sinus lift surgery was necessary before implantation were analyzed in the present study. All had a bone reconstruction with a combination of a biomaterial (beta tricalcium phosphate) and autograft bone harvested at the chin. Computed tomographic images were obtained before grafting (t0), at mid-interval (t1, 4.2 ± 0.7 months) and before implant placement (t2, 9.2 ± 0.6 months). Texture analysis was done with the run-length method.

RESULTS

A significant increase of texture parameters at t1 reflected a gain of homogeneity due to the graft and the beginning of bone remodeling. At t2, some parameters remained high and corresponded to the persistence of bone trabeculae while the resorption of biomaterials was identified by other parameters which tended to return to pregraft values.

CONCLUSION

Texture analysis identified changes during the healing of the receiver site.

CLINICAL RELEVANCE

The method is known to correlate with microarchitectural changes in bone and could be a useful approach to characterized osseointegrated grafts.