A Reconfigurable Multiplanar In Vitro Simulator for Real-Time Absolute Motion With External and Musculotendon Forces

Techniques to determine knee joint contact forces during squatting: A systematic review

This review article provides an overview of techniques used to determine human knee joint contact forces during squatting. The main two approaches are experimental and theoretical. Thigh calf contact has a significant effect on knee forces and should not be neglected. In this study, data were searched electronically and organized by techniques to find knee joint contact force during squatting theoretically and experimentally. There was a large variation in peak tibiofemoral (CV = 0.45) and patellofemoral (CV = 0.38) contact forces predicted theoretically. However, very little variation was observed between peak tibiofemoral contact forces (CV = 0.12) measured in vivo experimentally but measured knee joint force is available up to a limited knee flexion angle. There was a reduction in knee joint contact forces due to thigh calf contact. Literature of knee joint contact force prediction theoretically during squatting incorporating thigh calf contact force is very limited.

Rigid-body modeling of knee cartilage and meniscus using experimental pressure-strain curves

Rigid-body knee models have gained popularity thanks to computational speed and ease of setup compared to finite element models-showing exciting potential for clinical patient-specific models in the future. However, Rigid-body studies in general have encountered difficulty in modeling cartilage and especially meniscus material properties, often relying on computationally costly optimization techniques. This paper presents two new methods to alleviate the difficulty-one to define model contact pressure and one to define meniscus internal forces-and is the first to our knowledge to use experimental pressure-strain curves from the literature to simulate cartilage and meniscus behavior in a rigid body model. This paper describes the methodology to derive the proof of concept model and preliminary results from a gait simulation based on ISO 14243-1.

Quantified in vitro tibiofemoral contact during bodyweight back squats

Squats are a common lower extremity task used in strength and conditioning, balance training, and rehabilitation. It is important to understand how slight alterations in lower extremity kinematics during a squat affect the internal joint loading of the knee. This study directly quantified tibiofemoral contact throughout the in vitro simulation of a bodyweight back squat performed two ways: a heel squat (knees in line with toes) and a toe squat (knees anterior to the toes) at peak knee flexion. Three cadaveric right lower extremities were instrumented and positioned into the University of Texas Joint Load Simulator. Kinematics, kinetics, and predicted muscle forces from a 20-year-old athletic male performing the two back squats were used as inputs for the in vitro simulations. The quantified tibiofemoral contact area, peak pressure, net force, and center of pressure location were significantly different between squat types (p > 0.05). Net contact area on the tibial plateau at peak knee flexion was significantly larger in the heel versus toe squat (599 ± 80 mm² vs. 469 ± 125 mm²; p < 0.05). Peak lateral pressure was significantly higher in the heel versus toe squat (2.73 ± 0.54 MPa vs. 0.87 ± 0.56 MPa; p < 0.05). Results suggest the heel squat generates an even load distribution, which is less likely to affect joint degeneration. Future in vitro simulations should quantify the effects lower extremity kinematics, kinetics, and individual muscle forces have on tibiofemoral contact parameters during common athletic tasks.