Coagulation measurement from whole blood using vibrating optical fiber in a disposable cartridge

Recent advancements in microfluidics that integrate electrical sensors for whole blood analysis

Whole blood analysis reveals crucial information about various physiological and pathological conditions, including cancer metastasis, infection, and immune status, among others. Despite this rich information, the complex composition of whole blood usually required multiple sample preparation steps to purify targeted analytes. Traditionally, whole blood preparation processes, including centrifugation, lysis, dilution, or staining, are usually manually operated by well-trained technicians using bench-top instruments. This preparation can require a large blood volume and cannot be directly integrated with detection systems. Recently, various studies have integrated microfluidics with electrical sensors for whole blood analysis, with a focus on cell-based analysis, such as cell type, number, morphology, phenotype, and secreted molecules. These miniaturized systems require less sample and shorter reaction times. Besides, the sample processing and analysis can be fully integrated and automated with minimal operations. We believe these systems can transfer the current whole blood analysis from hospitals or laboratories into clinics or home settings to enable real-time and continuous health condition monitoring in point-of-care settings.

Point-of-Care Assessment of Hemostasis with a Love-Mode Surface Acoustic Wave Sensor

Monitoring of the hemostasis status is essential for therapeutic anticoagulants, undergoing surgery, cardiovascular diseases, etc. Although the clinical values of conventional blood coagulation tests have been well demonstrated, these devices have limitations such as large and expensive equipment, excessive sample volumes, long turnaround times, and difficulty in miniaturization for point-of-care use. Here, we present a novel strategy to evaluate blood hemostasis using the single-port Love-mode surface acoustic wave (SLSAW) sensor. The SLSAW sensor was designed as a plug-and-play-type unit for disposable use and operated under the harmonic resonant mode to produce frequency response to the blood coagulation cascade. Compared with a quartz crystal microbalance, Lamb wave, and film bulk acoustic resonator, the frequency shift of SLSAW was significantly increased, ranging from approximately 8960 to 10 368 kHz, which indicated enhancement of the signal-to-noise ratio. To demonstrate the feasibility of the SLSAW, studies were carried out to examine the effects of temperature and clotting reagents on coagulation times and kinetics. Activated partial thromboplastin times of plasma were validated by comparing with SYSMEX CA-7000 with the correlation (R²) as 0.996. In terms of coagulation kinetics, reaction time, clot formation time, maximum frequency shift, and clot formation rate of whole blood correlated well with corresponding parameters of the standard thromboelastography (TEG) analyzer (R² = 0.9942, 0.9868, 0.9712, and 0.9939, respectively). The SLSAW sensor, with the advantages of low cost, small size, little sample consumption (1 μL), disposable use, and simple operation, is a promising tool for point-of-care diagnosis of hemostasis.