Ex vivo Skin Permeation of Betulin from Water-in-Oil Foams

Sprayable ciprofloxacin-loaded poloxamer hydrogels for wound infection treatment

Topical antimicrobial treatments for severe burns and chronic wounds provide effective treatment against infections, but cause pain and discomfort with application. This study aimed to develop an antimicrobial topical formulation comprising thermoreversible poloxamers (Pluronic F127 and F68) and a broad-spectrum antimicrobial agent (ciprofloxacin hydrochloride, CH), that could be sprayed to eliminate application pain while maintaining antimicrobial activity. Formulations were characterized to determine their sprayability under cold conditions, gelation temperature, final storage modulus at skin temperature, drug release profile, ex vivo permeation through impaired porcine skin, and inhibition against common bacterial pathogens that colonize wounds. All cold formulations were sprayable from simple hand-held, pump-action sprayers due to their low viscosity. Upon heating, 17 and 20% Pluronic F127 formulations produced hydrogels eight to ten degrees below skin temperature, independent of ciprofloxacin loading. Increasing concentrations of Pluronic F127 increased the final storage modulus and viscosity of the gels, while inclusion of Pluronic F68 reduced these properties, showing that hydrogel rheological properties at skin temperature can be tuned via choice of formulation. Drug release was directly correlated to the rheological properties, with stiffer gels resulting in a decrease in drug release rate. Overall, gels released about 65-90% of their load within 12 hours. Ex vivo skin permeation demonstrated that drug was well retained in impaired porcine skin, which is desired to continuously treat bacteria localized to the wound. A well-diffusion assay indicated that the hydrogels had greater bacterial inhibition against Pseudomonas aeruginosa, Escherichia coli, and two strains of Staphylococcus aureus when compared to commercial controls. Overall, the results show the potential of CH-loaded poloxamer formulations as suitable sprayable topical dressings to deliver antimicrobials directly to wounds.

Effect of Betulin Colloidal Particles on Proliferation and Cytokine Secretion of Human Skin Fibroblasts

The aim of the study was to obtain untreated and treated betulin colloidal particles and assess their effect on the viability, morphology, proliferation and cytokine secretion of human dermal fibroblasts. To improve bioavailability, betulin treatment was performed by an antisolvent precipitation technique. The average particle size after treatment in the aqueous dispersion decreased from 552.9 ± 11.3 to 278.2 ± 1.6 nm. Treated betulin colloidal particles showed no cytotoxicity up to a concentration of 400 µg·mL-1 in the colorimetric tetrazolium salt viability test (CCK-8). Moreover, the cell morphology was not changed in the presence of betulin colloidal particles at a concentration range from 0.78 to 400 µg·mL-1. The obtained results also show that betulin particles induce the secretion of the proinflammatory and angiogenesis-stimulating cytokine IL-8. However, further studies would be required to clarify the mechanism of IL-8 secretion induction.

Lecithin-based nanoemulsions of traditional herbal wound healing agents and their effect on human skin cells

In previous studies, lecithin-based nanoemulsions (NEs) have been shown to be skin friendly drug carrier systems. Due to their nontoxic properties, NEs might also be suitable as wound healing agents. Hence, different O/W NEs based on lecithin Lipoid® S 75 and plant oils or medium chain triglycerides were produced and characterised. Two lipophilic natural wound healing agents, a betulin-enriched extract from birch bark (BET) and a purified spruce balm (PSB), were successfully incorporated and their effects on primary human skin cells were studied in vitro. MTT, BrdU and scratch assays uncovered the positive influence of the drug-loaded NEs on cell viability, proliferation and potential wound closure. Compared to control formulations, the NEs loaded with either BET or PSB led to higher cell viability rates of fibroblasts and keratinocytes. Higher proliferative activity of keratinocytes and fibroblasts was observed after the treatment, which is a prerequisite for wound closure. Indeed, in scratch assays NEs with PSB and notably BET showed significantly ameliorated wound closure rates than the negative control (unloaded NEs) and the positive control (NEs with dexpanthenol). Our findings suggest that BET and PSB are outstanding wound healing drugs and their incorporation into lecithin-based NEs may represent a valid strategy for wound care.

Oleogel Formulations for the Topical Delivery of Betulin and Lupeol in Skin Injuries-Preparation, Physicochemical Characterization, and Pharmaco-Toxicological Evaluation

The skin integrity is essential due to its pivotal role as a biological barrier against external noxious factors. Pentacyclic triterpenes stand as valuable plant-derived natural compounds in the treatment of skin injuries due to their anti-inflammatory, antioxidant, antimicrobial, and healing properties. Consequently, the primary aim of the current investigation was the development as well as the physicochemical and pharmaco-toxicological characterization of betulin- and lupeol-based oleogels (Bet OG and Lup OG) for topical application in skin injuries. The results revealed suitable pH as well as organoleptic, rheological, and textural properties. The penetration and permeation of Bet and Lup oleogels through porcine ear skin as well as the retention of both oleogels in the skin were demonstrated through ex vivo studies. In vitro, Bet OG and Lup OG showed good biocompatibility on HaCaT human immortalized cells. Moreover, Bet OG exerted a potent wound-healing property by stimulating the migration of the HaCaT cells. The in ovo results demonstrated the non-irritative potential of the developed formulations. Additionally, the undertaken in vivo investigation indicated a positive effect of oleogels treatment on skin parameters by increasing skin hydration and decreasing erythema. In conclusion, oleogel formulations are ideal for the local delivery of betulin and lupeol in skin disorders.

Tetracyclic and Pentacyclic Triterpenes with High Therapeutic Efficiency in Wound Healing Approaches

Wounds are among the most common skin conditions, displaying a large etiological diversity and being characterized by different degrees of severity. Wound healing is a complex process that involves multiple steps such as inflammation, proliferation and maturation and ends with scar formation. Since ancient times, a widely used option for treating skin wounds are plant- based treatments which currently have become the subject of modern pharmaceutical formulations. Triterpenes with tetracyclic and pentacyclic structure are extensively studied for their implication in wound healing as well as to determine their molecular mechanisms of action. The current review aims to summarize the main results of in vitro, in vivo and clinical studies conducted on lupane, ursane, oleanane, dammarane, lanostane and cycloartane type triterpenes as potential wound healing treatments.

Influence of PVA Molecular Weight and Concentration on Electrospinnability of Birch Bark Extract-Loaded Nanofibrous Scaffolds Intended for Enhanced Wound Healing

Triterpenes from the outer bark of birch (TE) are known for various pharmacological effects including enhanced wound healing. Apart from an already authorized oleogel, electrospun nanofiber mats containing these triterpenes in a polyvinyl alcohol (PVA) matrix appear to be an advantageous application form. The effects of PVA molecular weight and concentration on the fiber morphology have been investigated. Three different molecular weights of PVA ranging from 67 to 186 kDa were used. The concentration of PVA was varied from 5 to 20 wt%. Polymer solutions were blended with colloidal dispersions of birch bark extract at a weight ratio of 60:40 (wt.%). The estimated viscosity of polymer solutions was directly linked to their concentration and molecular weight. In addition, both pure and blended solutions showed viscoelastic properties with a dominant viscous response in the bulk. Fiber morphology was confirmed using scanning electron microscopy (SEM). Both polymer concentration and molecular weight were found to be significant factors affecting the diameter of the fibers. Fiber diameter increased with a higher molecular weight and polymer concentration as more uniform fibers were obtained using PVA of higher molecular weight (146-186 kDa). In vitro drug release and ex vivo permeation studies indicated a faster drug release of betulin from electrospun scaffolds with lower PVA molecular weight. Our research suggests that the fabricated TE-loaded PVA electrospun dressings represent potential delivery systems of TE for wound care applications.

Optimized Birch Bark Extract-Loaded Colloidal Dispersion Using Hydrogenated Phospholipids as Stabilizer

This study investigated the formulation and processing of aqueous colloidal dispersions containing a birch bark dry extract (TE) as the active substance and hydrogenated phospholipids (Phospholipon 90H) as stabilizer, which can be used in the preparation of electrospun wound dressings. Colloidal dispersions manufactured using a two-stage homogenization process had a bimodal particle size distribution, which was most significantly (p < 0.0001) affected by the phospholipid content. The size of the single particles decreased from an average particle size of about 4 µm to a particle size of approximately 400 nm. Dynamic interfacial tension studies performed using a profile analysis tensiometer (PAT) showed that the phospholipids strongly declined the interfacial tension, whereas a further decrease was observed when phospholipids were combined with birch bark extract. Interfacial viscoelasticity properties analyzed using the oscillating drop technique resulted in an increase of both interfacial elasticity and viscosity values. These results indicated that the phospholipids are preferentially located at the lipophilic/water interface and a stable film is formed. Furthermore, the results point to a synergistic interaction between phospholipids and TE. Confocal Raman microscopy (CRM) suggested that the TE is predominantly located in the oil phase and the phospholipids at the interface.

Electrospun Bioactive Wound Dressing Containing Colloidal Dispersions of Birch Bark Dry Extract

Novel birch bark dry extract (TE)-loaded polyvinyl alcohol (PVA) fiber mats intended for wound therapy were developed through an electrospinning process. Colloidal dispersions containing TE as the active substance were prepared by the high-pressure homogenization (HPH) technique using hydrogenated phospholipids as stabilizer. Subsequently, the colloidal dispersions were blended with aqueous PVA solutions in the ratio of 60:40 (wt.%) and electrospun to form the nanofiber mats. Fiber morphology examined using scanning electron microscopy (SEM) indicated that fibers were uniform and achieved diameters in the size range of 300–1586 nm. Confocal Raman spectral imaging gave good evidence that triterpenes were encapsulated within the electrospun mats. In vitro drug release and ex vivo permeation studies indicated that the electrospun nanofibers showed a sustained release of betulin, the main component of birch bark dry extract, making the examined dressings highly applicable for several wound care applications. Ex vivo wound healing studies proved that electrospun fiber mats containing TE accelerated wound healing significantly more than TE oleogel, which was comparable to an authorized product that consists of TE and sunflower oil and has proved to enhance wound healing. Therefore, our results conclude that the developed TE-PVA-based dressings show promising potential for wound therapy, an area where effective remedy is needed.

Betulin silver nanoparticles qualify as efficient antimelanoma agents in in vitro and in vivo studies

The current study was purported to assess the: (i) in vitro toxicity of betulin silver nanoparticles (AgNPs-B), bare and capped with polyethylene glycol (PEG), on two murine melanoma cell lines (B164A5 and B16Ova) and on healthy cell lines (keratinocytes and melanocytes), and (ii) in vivo antitumor efficacy of PEGylated AgNPs-B in an experimental melanoma model. Bare and PEG-capped AgNPs-B were synthesized by a chemical reduction method resulting in stable and non-aggregated spherical AgNPs-B and PEG-AgNPs-B, of narrow size distributions and mean hydrodynamic diameters of 25 nm and 75 nm, respectively. In vitro assessments were achieved by MTT and Annexin V-FITC assays and in vivo evaluation involved non-invasive techniques for the surveillance of the physiological skin parameters changes and histopathological examination of the harvested organs. The in vitro results revealed selective cytotoxicity against melanoma cells, at low doses that are nontoxic to normal cells; higher doses were associated with the loss of selectivity and toxicity for healthy cells. PEGylated formulation of betulin exerted a dose-dependent pro-apoptotic effect, more obvious in the case of B164A5 cells. Histopathological analysis suggested that PEGylated AgNPs-B developed relevant in vivo effects as antimelanoma agents by decreasing the tumor volume and inhibiting the development of secondary tumors.

Confocal Raman microspectroscopy as an alternative method to investigate the extraction of lipids from stratum corneum by emulsifiers and formulations

The purpose of this study was to investigate the impact of emulsifiers and formulations on intercellular lipids of porcine stratum corneum (SC) and evaluate confocal Raman microscopy (CRM) as an alternative method in this research context. To this end, four different formulations were used: three conventional creams that contained ionic and/or non-ionic emulsifiers and one surfactants-free emulsion stabilized by a polymeric emulsifier. Additionally, all emulsifiers were tested in aqueous solution/dispersion in the respective concentrations as present in the formulations. CRM and HPTLC were used to analyse changes in SC lipid content after treatment. Furthermore, lipid extraction was visualized by fluorescence staining and SC thickness was measured by CRM and light microscopy. Various emulsifiers and emulsifier mixtures showed different impact on SC lipid content and SC thickness, while none of the tested formulations had any effect on SC lipids. Emulsifiers and their mixtures that reduced the lipids content also reduced SC thickness, indicating lipid extraction is the reason for SC thinning. Results from CRM and conventional methods showed a strong positive correlation for both lipid content and SC thickness measurements. With easy sample preparation and fast analytical readout, CRM has the potential to be a standardized analytical method for skin lipids investigation.