Revisiting the Enhanced Red Upconversion Emission from a Single β-NaYF4:Yb/Er Microcrystal By Doping with Mn2+ Ions

Understanding the effect of Mn2+ on Yb3+/Er3+ co-doped NaYF4 upconversion and obtaining the optimal combination of these tridoping

In this work, we investigated in detail the upconversion properties of several types of nanoparticles, including NaYF4:5%Yb3+/30%Mn2+, NaYF4:40%Mn2+/x%Yb3+ (x% = 1, 5, 10, 20, 30, and 40), NaYF4:2%Er3+/x%Mn2+ (x% = 20, 30, 40, 50, 60, and 70), NaYF4:40%Mn2+/x%Er3+ (x% = 1, 2, 5, and 10), and NaYF4:40%Mn2+/1%Yb3+/x%Er3+ (x% = 0, 2, 5, and 10). We studied their upconversion emission under 980 nm excitation in both pulsed and continuous wave modes at different synthesis temperatures. The nanoparticles were characterized using transmission electron microscopy (TEM), X-ray diffraction (XRD), and photoluminescence (PL) spectroscopy. The doping of Yb3+ and Mn2+ ions resulted in the nanoparticles assuming cubic and hexagonal crystal structures. The emission intensity increased (106.4 (a.u.*103) to 334.4(a.u.*103)) with increasing synthesis temperature from 120 to 140 °C, while a sharp decrease was observed when the synthesis temperature was increased to 200 °C. The gradual decrease in peak intensity with increasing Mn2+ concentration from 20 to 70% was attributed to energy transfer from Mn2+ to Yb3+. In NaYF4:Mn2+/Yb3+/Er3+ UCNPs, increasing the Er3+ concentration from 0 to 10% led to the disappearance of the blue, orange, and green emission bands. The intense upconversion luminescence pattern with high spatial resolution indicates excellent potential for applications in displays, biological sensors, photodetectors, and solar energy converters.

Utilizing Energy Transfer in Mn2+/Ho3+/Yb3+ Tri-doped ZnAl2O4 Nanophosphors for Tunable Luminescence and Highly Sensitive Visual Cryogenic Thermometry

Lanthanide (Ln3+)-doped upconversion (UC) phosphors converting near-infrared (NIR) light to visible light hold very high promise toward biomedical applications. The scientific findings on luminescent thermometers revealed their superiority for noninvasive thermal sensing. However, only few reports showcase their potential for applications in extreme conditions (temperatures below -70 °C) restricted by low thermal sensitivity. Here, we demonstrate the tailoring of luminescence properties via introducing Ho3+-Mn2+ energy transfer (ET) routes with judicious codoping of Mn2+ ions in ZnAl2O4/Ho3+,Yb3+ phosphor. Preferentially, a singular red UC emission is required to improve the bioimaging sensitivity and minimize tissue damage. We could attain UC emission with 94% red component by a two-photon UC process. Higher temperature annealing brings the color coordinates to the green domain, highlighting the potential for color-tunable luminescence switch. Moreover, this work investigates the thermometric properties of ZnAl2O4/Yb3+, Ho3+ in the range of 80-300 K and influence of inducing extra ET pathways by Mn2+ codoping. Interestingly, the luminescence intensities for nonthermally coupled (5F4,5S2) and the 5F5 radiative transitions of Ho3+ ions display opposite behavior at 80 and 300 K, which revealed competition between temperature-sensitive decay pathways. The codoping of Mn2+ ions is fruitful in causing a fourfold increase of absolute sensitivity. Notably, the color tunability from green through yellow to red is helpful in rough temperature estimation by naked eyes. The maximum relative (Sr) and absolute sensitivities (Sa) were estimated to be 1.89% K-1 (140 K) and 0.0734 K-1 (300 K), respectively. Even at 80 K, a Sa of 0.00447 K-1 and Sr of 0.6025% K-1 were achievable in our case, which are higher than most of the other Ln3+-based systems. The above-mentioned results demonstrate the potential of ZnAl2O4/Yb3+,Ho3+ for cryogenic optical thermometry and a strategy to design new Ln3+-based UC thermometers by taking advantage of ET routes.

Mechanically induced enhancement and modulation of upconversion photoluminescence by bending lanthanide-doped perovskite oxides

We report experimental studies of the bending strain impact on the upconversion processes in Yb³⁺, Er³⁺, and Mn²⁺ co-doped BaTiO₃ (BTO) thin films with mica as the flexible substrate. Bending strain induces strong enhancement and modulation of the upconversion emission in doped BTO thin films. Because the unshielded 3d⁵ configuration of Mn²⁺ is more susceptible to crystal field changes, the introduction of an Mn²⁺ ion further promotes the strain-induced modulation effect. The upconversion intensity is amplified by six times at bending strain ε = 1.83% in BTO:Yb³⁺/Er³⁺/Mn²⁺ thin films. These results demonstrate the opportunity of rendering an upconversion emission through integrating lanthanide-doped ferroelectric films with flexible mica, especially by incorporating an Mn²⁺ ion.