Biomethane potential of industrial paper wastes and investigation of the methanogenic communities involved

Diauxie Studies in Biogas Production from Gelatin and Adaptation of the Modified Gompertz Model: Two-Phase Gompertz Model

The anaerobic degradation of gelatin results in a two-phase cumulative biogas production curve, i.e., diauxie behaviour. The modified Gompertz model is normally used to fit these curves but due to the diauxie it would result in a less accurate representation. Furthermore, this inhibition slows down the production of biogas in batch reactors. This study adapted the modified Gompertz model to fit cumulative biogas production curves with diauxie behaviour and to investigate the inhibition that leads to this diauxie. Results show that the two-phase Gompertz model can fit diauxie curves with high accuracy and that diauxie curves are not a direct consequence of the accumulation of volatile fatty acids produced in the process of anaerobic digestion.

Microbiota of a Full-scale UASB Reactor Treating Brewery Wastewater Using Illumina MiSeq Sequencing

Background:

The efficiency of biological wastewater treatment plant is determined by bacterial metabolism. There are data on the effect of operational parameters on microbial consortia present in laboratory scale reactor. However, knowledge on the full-scale reactor is still limited at present, hence the need to define the relations between the microbial structure and the performance of full-scale reactor.

Objective:

In this study, the microbial community structure in a full-scale UASB reactor treating brewery wastewater was assessed using metagenomics Next-Generation Sequencing technique.

Method:

Granular sludge samples were collected from the UASB reactor treating brewery wastewater and extracted genomic DNA was amplified using barcoded bacterial primer sets targeting V3-V4 region of the 16S rRNA genes on sequencing Illumina MiSeq platform.

Results:

The taxonomic analysis revealed the abundance of bacteria (~95%) with considerable Archaea community (~2%) in the granular sludge. After trimming, 18 bacterial phyla, 29 orders, 36 families and 44 genera were recovered from the 48,488 sequences reads of the 16S rRNA genes analysed, where the most abundant community belongs to Firmicutes, Bacteroidetes, Synergistetes and Proteobacteria phyla.

Conclusion:

For a sustainable bioenergy generation, understanding the mechanisms of anaerobic system in relation to microbial community is an important factor to increase the production of biogas production during wastewater treatment. To the best of our knowledge, this report is one of the studies that explored and described bacterial diversity and community structure of a full-scale UASB reactor treating brewery wastewater using high-throughput sequencing. This study provides insight into the dominant microbial community and their phylogenetic diversity in biogas producing reactor.

The correlation of methanogenic communities' dynamics and process performance of anaerobic digestion of thermal hydrolyzed sludge at short hydraulic retention times

Requirement of a long hydraulic retention time (HRT) for efficient degradation restrains the anaerobic digestion of hydrothermal pretreated sludge. Shortening the HRT can increase the treatment capacity of a plant but may also induce digester instability. This study investigated the impact of HRT on process performance and microbial community by consecutively operating a reactor for 145 days. The HRT was gradually decreased from 20 to 10, 5, and 3 days. The methane yield declined from 0.28 to 0.12 L/g-VS_in with this shortening, and acetate concentration increased from 38 to 376 mg/L. Methanoculleus (58%) dominated methanogens at a 20 days HRT. However, the methanogenic structure shifted toward an increased level of Methanospirillum, representing 95% of the total archaea at a 3 days HRT. Microorganisms were almost washed out at the end of experiment. Conclusively, shortening HRTs is a feasible strategy to increase treatment capacity and produce more biogas at existing plants.

Importance of inoculum source and initial community structure for biogas production from agricultural substrates

This study evaluated the importance of inoculum source for start-up and operation of biogas processes. Three different inocula with different community structure were used to initiate six laboratory continuous stirred tank reactor (CSTR) processes operated with a grass manure mixture as substrate. The processes were evaluated by chemical and microbiological analysis, by targeting the overall bacterial community and potential cellulose-degrading bacteria. As expected, the results showed a large difference in community structure in the inocula and in process performance during the first hydraulic retention time (HRT). However, the performance and overall microbial community structure became similar in the reactors over time. An inoculum from a high-ammonia process, characterized by low diversity and low degradation efficiency, took the longest time to reach stability and final methane yield. The overall bacterial community was mainly shaped by the operating conditions but, interestingly, potential cellulose-degrading bacteria seemed mainly to originate from the substrate.

New alternative energy pathway for chemical pulp mills: From traditional fibers to methane production

Chemical pulp mills have a need to diversify their end-product portfolio due to the current changing bio-economy. In this study, the methane potential of brown, oxygen delignified and bleached pulp were evaluated in order to assess the potential of converting traditional fibers; as well as microcrystalline cellulose and filtrates; to energy. Results showed that high yields (380mL CH₄/gVS) were achieved with bleached fibers which correlates with the lower presence of lignin. Filtrates from the hydrolysis process on the other hand, had the lowest yields (253mL CH₄/gVS) due to the high amount of acid and lignin compounds that cause inhibition. Overall, substrates had a biodegradability above 50% which demonstrates that they can be subjected to efficient anaerobic digestion. An energy and cost estimation showed that the energy produced can be translated into a significant profit and that methane production can be a promising new alternative option for chemical pulp mills.

Enhanced biomethane production rate and yield from lignocellulosic ensiled forage ley by in situ anaerobic digestion treatment with endogenous cellulolytic enzymes

BACKGROUND

Enzymatic treatment of lignocellulosic material for increased biogas production has so far focused on pretreatment methods. However, often combinations of enzymes and different physicochemical treatments are necessary to achieve a desired effect. This need for additional energy and chemicals compromises the rationale of using enzymes for low energy treatment to promote biogas production. Therefore, simpler and less energy intensive in situ anaerobic digester treatment with enzymes is desirable. However, investigations in which exogenous enzymes are added to treat the material in situ have shown mixed success, possibly because the enzymes used originated from organisms not evolutionarily adapted to the environment of anaerobic digesters. In this study, to examine the effect of enzymes endogenous to methanogenic microbial communities, cellulolytic enzymes were instead overproduced and collected from a dedicated methanogenic microbial community. By this approach, a solution with very high endogenous microbial cellulolytic activity was produced and tested for the effect on biogas production from lignocellulose by in situ anaerobic digester treatment.

RESULTS

Addition of enzymes, endogenous to the environment of a mixed methanogenic microbial community, to the anaerobic digestion of ensiled forage ley resulted in significantly increased rate and yield of biomethane production. The enzyme solution had an instant effect on more readily available cellulosic material. More importantly, the induced enzyme solution also affected the biogas production rate from less accessible cellulosic material in a second slower phase of lignocellulose digestion. Notably, this effect was maintained throughout the experiment to completely digested lignocellulosic substrate.

CONCLUSIONS

The induced enzyme solution collected from a microbial methanogenic community contained enzymes that were apparently active and stable in the environment of anaerobic digestion. The enzymatic activity had a profound effect on the biogas production rate and yield, comparable with the results of many pretreatment methods. Thus, application of such enzymes could enable efficient low energy in situ anaerobic digester treatment for increased biomethane production from lignocellulosic material.