Size Distribution and Characteristics of Chemical Components in Ambient Particulate Matter

Ambient particulate matter and gas in Kyoto were investigated by gravimetric analysis, X-ray fluorescence spectrometry, and ion chromatography in order to clarify their behavior and origin. The size distribution and characteristics of the chemical components in ambient particulates collected on PTFE membrane filters using an Andersen air sampler were examined from August 2001 to April 2004. A four-stage filter pack method was used to sample the atmosphere for the determination of gas (SO2, HNO3, HCl, NH3) and particulate matter (SO42, NO3, Cl-, Na+, K+, Ca2+, Mg2+, NH4+) concentrations from October 2002 to April 2004. The concentration of SPM mass was in the range of 6.7 - 80.2 microg/m3. The size distributions of SPM mass were bimodal, peaking at around 0.65 - 1.1 and 3.3 - 4.7 microm, and 40 - 85% of SPM mass was fine particles (< 2.1 microm). Na, Mg, Al, Si, Ca, Cl, and Fe were mainly present in coarse particles (2.1 to 11.0 microm), while S was present in fine particles. The concentrations of Al, Si, Ca, Mg, and Fe in fine particles increased from March to April in 2002, and those in coarse particulates increased in November 2002 and from March to April in 2004. This may be the effect of the continental yellow sand "Kosa." The differences in the size distributions of Al, Si, Ca, Mg, and Fe in particles may depend on differences in their place of occurrence and course of transport from China to Japan. The concentration of HCl gas was higher than that of particulate chloride ion in summer. Nitric acid gas existed at higher concentrations in summer, but fine particulate nitrate ion was observed in winter. The gaseous-to-fine aerosol nitrate fraction became higher at warmer temperatures. Coarse sulfate was below 10%, and SO2 gas and fine particulate sulfate were above 90%.

Passive sampling and/or extraction techniques in environmental analysis: a review

The current state-of-the-art of passive sampling and/or extraction methods for long-term monitoring of pollutants in different environmental compartments is discussed in this review. Passive dosimeters that have been successfully used to monitor organic and inorganic contaminants in air, water, sediments, and soil are presented. The application of new approaches to the determination of pollutants at the sampling stage is discussed. The main milestones in the development of passive techniques for sampling and/or extraction of analytes, and in biomonitors used in environmental analysis, are summarized in this review. Passive samplers and biomonitors are compared.

Simple Analysis of Volatile Organic Compounds (VOCs) in the Atmosphere Using Passive Samplers

A simple analysis of volatile organic compounds (VOCs), such as benzene, toluene, m,p-xylene, and o-xylene, at low levels in the atmosphere was conducted using passive samplers. The methods were applied to analyzing the behavior and origin of VOCs in Kyoto City. The passive samplers were exposed for 7 - 14 days at sampling sites in Kyoto City and for 30 days in the mountains (Mt. Hiei and Mt. Daimonji). Shibata gas-tube samplers packed with activated carbon were used for the determination of VOCs. The absorbed VOCs were extracted into carbon disulfide (CS2) and measured by FID-GC. The determination limits and relative standard deviations for VOCs were 0.3 microg/m3 and 3%, respectively. The samplers were set up at 5 sites in March, 2001 and at 13 stations on Mt. Hiei in November, 2002. The average concentrations of ambient benzene, which were higher than the environmental criterion (3.0 microg/m3), except for those on Mt. Daimonji from March, 2001, to February, 2002, decreased to below 3.0 microg/m3 from March, 2002, to February, 2003. The decrease in ambient benzene may have been due to a decrease in the benzene content in gasoline by the end of 1999, and also by implementation of the Pollutant Release and Transfer Register (PRTR) Act in 2001.

Speciation of aluminum in soil extracts using cation and anion exchangers followed by a flow-injection system with fluorescence detection using lumogallion

Flow-injection analysis (FIA) with fluorescence detection of aluminum using lumogallion was applied to the chemical speciation of aluminum in soil extracts after the separation of aluminum species with ionic exchangers. Aluminum complexes with organic substances (anion species) can be specified from other species by using a strongly acidic cation exchanger in the pH range of 3 to 5. Furthermore, aluminum can be separated into three categories, namely, (i) the Al3+ and Al-OH complex, (ii) aluminum organic complexes (cation species), and (iii) its anion species by using a strongly acidic and a weakly acidic cation exchanger at around pH 5. A considerable percentage of water-soluble aluminum in soils was found to be complexes with humic substances.