Long working distance fluorescence lifetime imaging with stimulated emission and electronic time delay

Spontaneous loss versus stimulation gain in pump-probe microscopy: a proof of concept demonstration

SIGNIFICANCE

The large background, narrow dynamic range, and detector saturation have been the common limiting factors in stimulated emission (SE)-based pump-probe microscopy, attributed to the very small signal overriding the very intense laser probe beam. To better differentiate the signal of interest from the background, lock-in detection is used to measure the fluorescence quenching, which is termed spontaneous loss (SL). The advantages are manifold. The spontaneous fluorescence signal can be well separated from both the pump and the probe beams with filters, thus eliminating the background, enlarging the dynamic range, and avoiding the saturation of the detector.

AIM

We propose and demonstrate an integrated pump-probe microscopy technique based on lock-in detection for background removal and dynamic range enhancement through SL detection.

APPROACH

The experimental setup is configured with a pulsed diode laser at a wavelength λpu  =  635  nm, acting as a pump (excitation) and a mode-locked Ti:sapphire laser at a central wavelength λpr  =  780  nm, serving as the probe beam (stimulation). Both pulse trains are temporally synchronized through high precision delay control by adjusting the length of the triggering cables. The pump and probe beams are alternatively modulated at different frequencies f1 and f2 to extract the stimulated gain (SG) and SL signal.

RESULTS

SG signal shows saturation due to the irradiation of the intense probe beam onto the photodetector. However, the detector saturation does not occur at high probe beam power for SL detection. The fluorescence lifetime images are acquired with reduced background. The theoretical signal-to-noise ratios for SG and SL are also estimated by photon statistics.

CONCLUSION

We have confirmed that the detection of SL allows the elimination of the large background without photodetector saturation, which commonly exists in SG configuration. This modality would allow unprecedented manipulation and investigation of fluorophores in fluorescence imaging.

Synchronized subharmonic modulation in stimulated emission microscopy

In this work, we have demonstrated a stimulated emission (SE)-based pump-probe microscopy with subharmonic fast gate synchronization, which allows over an order of magnitude improvement in signal-to-noise ratio. Critically, the alternative way of modulation is implemented with the highest possible frequency that follows the lasers' repetition rate. Its working is based on a homemade frequency divider that divides the repetition frequency (76 MHz) of the Ti:sapphire (probe) laser to half of the repetition frequency, 38 MHz, which is used to synchronously drive the pump laser and to provide the reference signal for the ensuing lock-in detection. In this way, SE can be detected with sensitivity reaching the theoretical (shot noise) limits, with a much lower time constant (0.1 ms) for faster image acquisition.

Time-domain fluorescence lifetime imaging by nonlinear fluorescence microscopy constructed of a pump-probe setup with two-wavelength laser pulses

We propose a time-domain approach for fluorescence lifetime measurements using nonlinear fluorescence microscopy constructed of a pump-probe setup with two-wavelength laser pulses. Nonlinear fluorescence signals generated by fluorescence reduction due to stimulated emission were detectable through a lock-in technique. Changing the time delay between the two-wavelength pulses enables acquisition of a time-resolved nonlinear fluorescence signal, which directly reflects the fluorescence lifetime of the sample and is thus applicable to fluorescence lifetime imaging. We also quantitatively demonstrate that nonlinear fluorescence microscopy possesses better optical resolution than conventional laser-scanning fluorescence microscopy. Experimental trials indicate that straightforward fluorescence lifetime imaging with high optical resolution is readily available.

Fast stimulated emission nanoscopy based on single molecule localization

For super-resolution microscopy methods based on single molecule stochastic switching and localization, to simultaneously improve the spatial-temporal resolution, it is necessary to maximize the number of photons that can be collected from single molecules per unit time. Here, we describe a novel approach to enhance the signal intensity (collected photons per second) from fluorescence probes by introducing a stimulated emission (SE) optical process. This process is based on the following two properties: first, with reasonable parameters, the photon emission rate can be significantly increased with SE; and second, the SE photons, which are spatially coherent with the stimulation beam, are more favorable for collection than fluorescence. Theoretical results have shown that signal intensity from a single fluorescent molecule can be greatly improved with SE. We therefore showed, using SE in combination with single molecule localization methodology, that fast imaging at a rate of 0.05 s per reconstructed image with lateral resolutions of ∼30  nm can be obtained.

Fluorescence lifetime imaging with pulsed diode laser enabled stimulated emission

We present here a stimulated emission based fluorescence lifetime imaging (FLIM) scheme using a pair of synchronized diode lasers operating at gain switched pulse mode. The two semiconductor lasers, with wavelengths at 635 nm and 700 nm, serve as the excitation and the stimulation light sources for the ATTO647N labeled sample, respectively. FLIM is readily achieved with their relative time delay controlled electronically. The coherent nature of the stimulated emission signal also allows FLIM at long working distance. In this way, a high performance all-semiconductor FLIM module is realized in a flexible, compact, and cost effective configuration.