Efficient laser operation based on transparent Nd:Lu2O3 ceramic fabricated by Spark Plasma Sintering

3.73 W all-solid-state dual-wavelength Nd:Lu2O3 crystal laser

The laser output characteristics of N d:L u 2 O 3 crystals were investigated in detail to obtain a dual-wavelength all-solid-state laser. Using 806 nm LD end-face pumped N d:L u 2 O 3 crystals with lengths of 6 mm, a 1076 & 1080 nm laser outputs with a maximum output power of 3.73 W were obtained, with a slope efficiency of 30.4%, an optical-to-optical conversion efficiency of 28.5%, and a power stability of 0.41% for 4 h of continuous measurement. Furthermore, by suppressing the higher-order modes, a high beam quality laser output with beam quality factors of 2.092 and 1.589 in the x and y directions, respectively, and a maximum output power of 1.27 W were obtained. In addition, it was experimentally verified that both wavelengths of the output laser were elliptically polarized.

Modeling nonlinear high-pressure sensors based on degenerate four-wave mixing in photonic crystal fibers

We propose a high-pressure sensing mechanism in solid-core silica photonic crystal fibers (PCF) that is based on the nonlinear optical process of degenerate four-wave mixing. A quite simple configuration for the pressure sensor is given and is theoretically investigated by obtaining signal gain spectra. We focus on the Stokes and anti-Stokes sidebands that are generated during propagation of the field along the PCF due to the interplay of dispersion and nonlinear optical effects. We have considered wave propagation in the normal dispersion regime with the inclusion of negative fourth-order dispersion. We have also considered a pumping field with wavelength of 1076 nm and peak power of 3000 W that propagates along a PCF with 40 cm of length. We have optimized sensitivity, varying lattice pitch and air-hole diameter, and we have obtained high sensitivities of the Stokes and anti-Stokes lines of 3.672 and -0.146nm/MPa, respectively. The proposed sensors have potential applicability in high-pressure environments.

Pressure-assisted sintering and characterization of Nd:YAG ceramic lasers

Spark plasma sintering (SPS) is an advanced one-stage, rapid, near-net shape densification technique combining uniaxial pressure with resistive heating. Various transparent ceramics have been successfully fabricated by SPS, despite the existence of inherent carbon contamination and residual pores. Due to the disk-shape of SPS-processed samples, the technique may be suited for producing thin-disk ceramic laser materials. Nevertheless, an in-depth study of these materials has never been reported. With that goal in mind, the major focus of this study was to characterize the laser performance of Nd:YAG ceramics fabricated by one-stage SPS under conventional (60 MPa) and high (300 MPa) applied pressures. In addition to measuring the lasing slope efficiency and threshold, the passive losses associated with each sample were also evaluated. Surprisingly, it was found that in-line transmittance spectra do not provide accurate predictions of laser performance due to the nature of residual porosity. Moreover, homogeneity and beam quality were assessed, and comparisons were drawn between conventional and high-pressure SPS ceramics. This study lays the groundwork for the future of laser materials fabricated by SPS or similar pressure-assisted techniques.