Femtosecond Cr:forsterite laser diode pumped by a double-clad fiber

Lasers for nonlinear microscopy

Various versions of nonlinear microscopy are revolutionizing the life sciences, almost all of which are made possible because of the development of ultrafast lasers. In this article, the main properties and technical features of short-pulse lasers used in nonlinear microscopy are summarized. Recent research results on fiber lasers that will impact future instruments are also discussed.

InAs/GaAs quantum-dot saturable absorber for a diode-pumped passively mode-locked Nd:YVO4 laser at 1342 nm

We report that InAs/GaAs quantum dots were developed to be saturable absorbers as well as output couplers in diode-pumped passively mode-locked Nd:YVO4 lasers at 1342 nm. With an incident pump power of 12.6 W, an average output power of 0.85 W with a mode-locked pulse width of 26 ps at a repetition rate of 152 MHz was obtained.

Chromium-doped forsterite: dispersion measurement with white-light interferometry

Using a Michelson white-light interferometer, we measure the group-delay dispersion and third-order dispersion coefficients, d2(phi)/d(omega)2 and d3(phi)/d(omega)3, of chromium-doped forsterite (Cr:Mg2SiO4) over wavelengths of 1050-1600 nm for light polarized along both the c and b crystal axes. In this interval, the second-order dispersion for the c axis ranges from 35 fs2/mm to -14 fs2/mm, and the third-order dispersion ranges from 36 fs3/mm to 142 fs3/mm. For the b axis the second-order dispersion ranges from 35 fs2/mm to -15 fs2/mm and the third-order from 73 fs3/mm to 185 fs3/mm. Our data are relevant for the development of optimized dispersion compensation tools for Cr:Mg2SiO4 femtosecond lasers. These measurements help to clarify previously published results and show some significant discrepancies that existed, especially in the third-order dispersion. Our results should furthermore be useful to build up an analytic expression for the index of refraction of chromium forsterite.

Powerful and tunable operation of a 1-2-kHz repetition-rate gain-switched Cr:forsterite laser and its frequency doubling

We present a comprehensive study of the optimum operating regime in gain-switched Cr:forsterite lasers pumped at kilohertz repetition rates, comparing five crystals of similar quality but different dopant levels. The optimization of the cavity design includes selection of the proper pump fluence to account for excited-state absorption, optimum matching of the pump and laser modes, and consideration of thermal effects. As a result >1-W average output power is demonstrated at 2 kHz. The maximum conversion efficiencies achieved at 1 kHz are 24.2% (slope) and 20% (absolute). Narrow-band operation of this laser is possible with a birefringent filter, which is a prerequisite for efficient frequency doubling to cover the 585-660-nm part of the visible spectral range. Tunable second-harmonic generation in a temperature-tuned noncritical scheme that employs LiB(3)O(5) produces 60 mW of average power near 619 nm with 13.5% conversion efficiency.

Diode-Pumped Cr:forsterite Laser Mode Locked by a Semiconductor Saturable Absorber

We report the passive mode locking of a diode-pumped Cr:forsterite laser using a semiconductor saturable absorber. The laser generates 10-pJ pulses as short as 1.5 ps in duration with ~650 mW of absorbed pump power. We measured the transient reflectance of the saturable absorber mirror under different incident energy fluences by using a standard pump-probe method. The performance of this laser is also compared with a high-power fiber-laser-pumped femtosecond forsterite laser mode locked with the same absorber.