Characterization of Convection for Molecularly Imprinted Monolith

Cholesterol-imprinted macroporous monoliths: Preparation and characterization

The development of sorbents for selective binding of cholesterol, which is a risk factor for cardiovascular disease, has a great importance for analytical science and medicine. In this work, two series of macroporous cholesterol-imprinted monolithic sorbents differing in the composition of functional monomers (methacrylic acid, butyl methacrylate, 2-hydroxyethyl methacrylate and ethylene dimethacrylate), amount of a template (4, 6 and 8 mol%) used for molecular imprinting, as well as mean pore size were synthesized by in situ free-radical process in stainless steel housing of 50 mm × 4.6 mm i.d. All prepared materials were characterized regarding to their hydrodynamic permeability and porous properties, as well as examined by BET and SEM methods. Imprinting factors, apparent dynamic dissociation constants, the maximum binding capacity, the number of theoretical plates and the height equivalent to a theoretical palate of MIP monoliths at different mobile phase flow rates were determined. The separation of a mixture of structural analogues, namely, cholesterol and prednisolone, was demonstrated. Additionally, the possibility of using the developed monoliths for cholesterol solid-phase extraction from simulated biological solution was shown.

Molecular imprinting science and technology: a survey of the literature for the years 2004-2011

Herein, we present a survey of the literature covering the development of molecular imprinting science and technology over the years 2004-2011. In total, 3779 references to the original papers, reviews, edited volumes and monographs from this period are included, along with recently identified uncited materials from prior to 2004, which were omitted in the first instalment of this series covering the years 1930-2003. In the presentation of the assembled references, a section presenting reviews and monographs covering the area is followed by sections describing fundamental aspects of molecular imprinting including the development of novel polymer formats. Thereafter, literature describing efforts to apply these polymeric materials to a range of application areas is presented. Current trends and areas of rapid development are discussed.

Synthesis of imprinted monolithic column with high content of monomers in ionic liquid

A MIP monolith with good permeability was successfully achieved using a strategy involving a high content of monomers in a [BMIM][BF₄]-based green solvent.

Molecularly imprinted nanoparticles with nontailing peaks in capillary electrochromatography

The combination of microparticles of molecularly imprinted polymers (MIPs) with partial filling capillary electrochromatography (CEC) has previously been demonstrated for the enantiomer separation. In this paper, precipitation polymerization was used to prepare d-zopiclone imprinted nanoparticles (50-80 nm) by a strategy of the dilution of pre-polymerization mixtures. The influence of some important parameters on the preparation of MIPs nanoparticles, including template to monomer ratio, type and amount of cross-linking monomer, and functional monomer composition ratio were investigated. In addition, the effect of separation condition, e.g., organic modifier content, pH value and salt concentration of buffer, on the electrochromatographic behavior of the MIP nanoparticles were studied. In spite of lower selectivity factor (1.11), high column performance (theoretical plates 41,400) of template was obtained and the resolution of enantiomers separation was 4.75 under the optimized conditions. Compared to the previously reported MIP microparticles, the MIP nanoparticles showed good peak symmetry and an ability of high speed separation (<15 min) in CEC mode.