Novel Parallelized Electroporation by Electrostatic Manipulation of a Water-in-Oil Droplet as a Microreactor

Influence of DNA characteristics on cell membrane damage stimulated by electrical short-circuiting via a low-conductive aqueous droplet in dielectric oil

We investigated gene electrotransfer using electrical short-circuiting via a cell suspension droplet in dielectric oil. An aqueous droplet of a few microliters placed between a pair of electrodes can be deformed by an intense DC electric field depending on the electric field intensity. When a droplet containing suspended cells and plasmid DNA elongates during deformation and connects the electrodes, the resulting short circuit can cause successful gene electrotransfection into various mammalian cells. We also investigated the influence of the electroporation medium on membrane permeabilization and the mechanisms of gene electrotransfection using short-circuiting via an aqueous droplet. One aim of this study was to investigate the influence of the conductivity of electroporation medium on gene electrotransfer stimulated by short-circuiting. It was found that low-conductivity medium with plasmid DNA resulted in a significant decrease in cell viability compared to the high-conductivity medium with plasmid DNA. Therefore, we demonstrated the influence of exogenous DNA on membrane damage stimulated by droplet electroporation using a low-conductivity medium. Thus, electrical stimulation with the combination of plasmid DNA and the low-conductivity medium resulted in tremendous membrane damage. Linearized plasmid DNA stimulated more significant membrane damage than circular DNA. However, the size of linear DNA did not influence the efflux of small intracellular molecules.

Influence of Electroporation Medium on Delivery of Cell-Impermeable Small Molecules by Electrical Short-Circuiting via an Aqueous Droplet in Dielectric Oil: A Comparison of Different Fluorescent Tracers

Membrane permeabilization stimulated by high-voltage electric pulses has been used to deliver cell-impermeable exogenous molecules. The electric field effect on the cells depends on various experimental parameters, such as electric field strength, the number of electric pulses, and the electroporation medium. In this study, we show the influence of the electroporation medium on membrane permeabilization stimulated by electrical short-circuiting via an aqueous droplet in dielectric oil, a novel methodology developed by our previous investigations. We investigated the membrane permeabilization by three methods, influx of calcium ions, uptake of nucleic acid-binding fluorophores (YO-PRO-1), and calcein leakage. We demonstrated that the external medium conductivity had a significant impact on the cells in all described experiments. The short-circuiting using a low-conductivity electroporation medium enhanced the formation of both transient and irreversible membrane pores. We also found that clathrin-mediated endocytosis contributed to YO-PRO-1 uptake when a cell culture medium was used as an electroporation medium.

Nanoscale-tipped wire array injections transfer DNA directly into brain cells ex vivo and in vivo

Genetic modification to restore cell functions in the brain can be performed through the delivery of biomolecules in a minimally invasive manner into live neuronal cells within brain tissues. However, conventional nanoscale needles are too short (lengths of ~10 µm) to target neuronal cells in ~1‐mm‐thick brain tissues because the neuronal cells are located deep within the tissue. Here, we report the use of nanoscale‐tipped wire (NTW) arrays with diameters < 100 nm and wire lengths of ~200 µm to address biomolecule delivery issues. The NTW arrays were manufactured by growth of silicon microwire arrays and nanotip formation. This technique uses pinpoint, multiple‐cell DNA injections in deep areas of brain tissues, enabling target cells to be marked by fluorescent protein (FP) expression vectors. This technique has potential for use for electrophysiological recordings and biological transfection into neuronal cells. Herein, simply pressing an NTW array delivers and expresses plasmid DNA in multiple‐cultured cells and multiple‐neuronal cells within a brain slice with reduced cell damage. Additionally, DNA transfection is demonstrated using brain cells ex vivo and in vivo. Moreover, knockdown of a critical clock gene after injecting a short hairpin RNA (shRNA) and a genome‐editing vector demonstrates the potential to genetically alter the function of living brain cells, for example, pacemaker cells of the mammalian circadian rhythms. Overall, our NTW array injection technique enables genetic and functional modification of living cells in deep brain tissue areas, both ex vivo and in vivo.

Review of Microfluidic Methods for Cellular Lysis

Cell lysis is a process in which the outer cell membrane is broken to release intracellular constituents in a way that important information about the DNA or RNA of an organism can be obtained. This article is a thorough review of reported methods for the achievement of effective cellular boundaries disintegration, together with their technological peculiarities and instrumental requirements. The different approaches are summarized in six categories: chemical, mechanical, electrical methods, thermal, laser, and other lysis methods. Based on the results derived from each of the investigated reports, we outline the advantages and disadvantages of those techniques. Although the choice of a suitable method is highly dependent on the particular requirements of the specific scientific problem, we conclude with a concise table where the benefits of every approach are compared, based on criteria such as cost, efficiency, and difficulty.

Mechanistic studies of gene delivery into mammalian cells by electrical short-circuiting via an aqueous droplet in dielectric oil

We have developed a novel methodology for the delivery of cell-impermeable molecules, based on electrical short-circuiting via a water droplet in dielectric oil. When a cell suspension droplet is placed between a pair of electrodes with an intense DC electric field, droplet bouncing and droplet deformation, which results in an instantaneous short-circuit, can be induced, depending on the electric field strength. We have demonstrated successful transfection of various mammalian cells using the short-circuiting; however, the molecular mechanism remains to be elucidated. In this study, flow cytometric assays were performed with Jurkat cells. An aqueous droplet containing Jurkat cells and plasmids carrying fluorescent proteins was treated with droplet bouncing or short-circuiting. The short-circuiting resulted in sufficient cell viability and fluorescent protein expression after 24 hours’ incubation. In contrast, droplet bouncing did not result in successful gene transfection. Transient membrane pore formation was investigated by uptake of a cell-impermeable fluorescence dye YO-PRO-1 and the influx of calcium ions. As a result, short-circuiting increased YO-PRO-1 fluorescence intensity and intracellular calcium ion concentration, but droplet bouncing did not. We also investigated the contribution of endocytosis to the transfection. The pre-treatment of cells with endocytosis inhibitors decreased the efficiency of gene transfection in a concentration-dependent manner. Besides, the use of pH-sensitive dye conjugates indicated the formation of an acidic environment in the endosomes after the short-circuiting. Endocytosis is a possible mechanism for the intracellular delivery of exogenous DNA.

Effect of Deformation on Droplet Contact Charge Electrophoresis

The effect of deformation on the droplet contact charge electrophoresis (CCEP) was investigated for consistent droplet movement control. Through systematic experiments and numerical simulations, it has been found that overcharging by deformation is up to about 130% of the sphere and is mainly driven by the concentration of the electric field near the tip of the droplet rather than an increase in the surface area. Dimensional analysis revealed a consistent droplet CCEP motion with the electric capillary number range of 0.01-0.09. We also found that the dimensionless droplet charge follows a universal curve proportional to the electric capillary number, regardless of the droplet size, and the weak dependence on the droplet size shown in the experimental results is due to hydrodynamic effects, not electrostatic ones. Changes in droplet velocity distribution with droplet size and the electric capillary number were also investigated. Using the perfect conductor theory and Stokes law, we derived an analytical relationship between the droplet center velocity and the electric capillary number and analyzed the experimental results based on this relationship. This study implies that if proper hydrodynamic correction is applied, the droplet CCEP and its deformation effect can be explained by a perfect conductor theory.

Wall Effects on Hydrodynamic Drag and the Corresponding Accuracy of Charge Measurement in Droplet Contact Charge Electrophoresis

Droplet size dependent wall effects on hydrodynamic drag and the corresponding droplet contact charge estimations were experimentally and theoretically investigated. The consistent reduction in the dimensionless droplet contact charges proportional to droplet size was reported and explained by the parallel and approaching wall effects on the drag coefficient. Extrapolation of the size dependent droplet charge data showed that the droplet charge follows the perfect conductor theory when the droplet radius approaches zero. The proposed model was applied to the drag calculation to estimate and compare dimensionless charges before and after consideration of the wall effects. The droplet free fall test concluded that the droplets in the current experimental setup follow Stokes' law. The theoretical velocity profile of the droplet approaching the wall perpendicularly is proposed considering the approaching wall effect on hydrodynamic drag and verified by comparison with the experiment. The droplet size dependent velocity profile shape change was also explained by this approaching wall effect. The shape of the asymmetric velocity profile along the direction of droplet movement was explained by the effect of the image charge through direct numerical calculation of the electric force. The direct calculation of the electric force also showed that the electric correction at the center of the cuvette is negligible; thus, it is sufficient to consider only hydrodynamic correction for accurate charge measurement in this experimental system. The present study will contribute to the accurate measurement of the droplet charges under contact charge electrophoresis. It also provides the basis for precise control of droplet movement in lab-on-a-chip devices.

Introduction of a plasmid and a protein into bovine and swine cells by water-in-oil droplet electroporation

Instrument cost is a major problem for the transduction of DNA fragments and proteins into cells. Water-in-oil droplet electroporation (droplet-EP) was recently invented as a low-cost and effective method for the transfection of plasmids into cultured human cells. We here applied droplet-EP to livestock animal cells. Although it is difficult to transfect plasmids into bovine fibroblasts using conventional lipofection methods, droplet-EP enabled us to introduce an enhanced green fluorescent protein (EGFP)-expressing plasmid into bovine earlobe fibroblasts. The optimal transfection condition was 3.0 kV, which allowed 19.1% of the cells to be transfected. For swine earlobe fibroblasts, the maximum transfection efficacy was 14.0% at 4.0 kV. After transfection with droplet-EP, 69.1% of bovine and 76.5% of swine cells were viable. Furthermore, droplet-EP successfully transduced Escherichia coli recombinant EGFP into frozen-thawed bovine sperm at 1.5 kV. Flow cytometry analysis revealed that 71.5% of spermatozoa exhibited green fluorescence after transfection. Overall, droplet-EP is suitable for the transfection of plasmids and proteins into cultured livestock animal cells.

Optimization of the droplet electroporation method for wild type Chlamydomonas reinhardtii transformation

We performed the transformation of a wild type Chlamydomonas reinhardtii by optimizing previously developed droplet EP method. For more effective and faster optimization, we used DNA dying fluorescent molecule (Yo-Pro-1) for finding optimal EP conditions instead of using protein expression based evaluation method. By examining wider range of electrical parameter space together with the analysis of total current flow of EP process, we found optimal EP conditions. The obtained optimal EP conditions were verified by CFP transgene expression experiments. By applying the optimal EP conditions to the transformation of C. reinhardtii, we obtained transformants and analyzed them using PCR. Finally, implications and future work are discussed.

Electrostatic Origins of the Positive and Negative Charging Difference in the Contact Charge Electrophoresis of a Water Droplet

The positive and negative charging difference in the contact charge electrophoresis of a water droplet suspended in oil was investigated to find out the origin of this charging difference. Through numerous experiments and numerical analysis, the charging difference has been found to be mainly originated from electrostatic sources. Two electrostatic sources were found in the present experimental setup, and by excluding those two sources the charging difference was successfully diminished. The present findings well explain previous experimental results and also provide design guidelines for consistent droplet movement control in contact charge electrophoresis-based digital microfluidic systems. Finally, further discussions on the obtained results, its implications, and future work are discussed.

Fundamental study on a gene transfection methodology for mammalian cells using water-in-oil droplet deformation in a DC electric field

We have developed a gene transfection method called water-in-oil droplet electroporation (EP) that uses a dielectric oil and a liquid droplet containing live cells and exogenous DNA. When a cell suspension droplet is placed between a pair of electrodes, an intense DC electric field can induce droplet deformation, resulting in an instantaneous short circuit caused by the droplet elongating and contacting the two electrodes simultaneously. Small transient pores are generated in the cell membrane during the short, allowing the introduction of exogenous DNA into the cells. The droplet EP was characterized by varying the following experimental parameters: applied voltage, number of short circuits, type of medium (electric conductivity), concentration of exogenous DNA, and size of the droplet. In addition, the formation of transient pores in the cell membrane during droplet EP and the transfection efficiency were evaluated.

•

Characterization of water-in-oil droplet electroporation.

•

The electric field strength is the most critical experimental parameter.

•

The volume of the droplet affects viability and gene expression.

•

Droplet deformation under a DC electric field is critical.