Kinetics of Ca2+ binding to the SR Ca-ATPase in the E1 state

Kinetic and mesoscopic non-equilibrium description of the Ca(2+) pump: a comparison

We analyse the operation of the Ca(2+)-ATPase ion pump using a kinetic cycle diagram. Using the methodology of Hill, we obtain the cycle fluxes, entropy production and efficiency of the pump. We compare these results with a mesoscopic non-equilibrium description of the pump and show that the kinetic and mesoscopic pictures are in accordance with each other. This gives further support to the mesoscopic theory, which is less restricted and also can include the heat flux as a variable. We also show how motors can be characterised in terms of unidirectional backward fluxes. We proceed to show how the mesoscopic approach can be used to identify fast and slow steps of the model in terms of activation energies, and how this can be used to simplify the kinetic diagram.

Kinetics of luminal proton binding to the SR Ca-ATPase

An open membrane preparation containing SR Ca-ATPase was prepared from sarcoplasmic-reticulum vesicles to study the ion binding kinetics in the P-E(2) conformation. Because Ca(2+) and H(+) binding are electrogenic reactions, fluorescent styryl dyes could be used to determine changes in the binding site occupation in equilibrium titration experiments and time-resolved relaxation processes triggered by a pH jump. By photo release from caged proton the pH of the electrolyte could be decreased in a step of 0.1 pH units by a single ultraviolet-laser flash. Analysis of the pH-jump induced relaxation process in the P-E(2) conformation showed that three Ca-ATPase-specific processes could be identified, fast H(+) binding (τ < 100 μs) and pH-insensitive conformational relaxations after the release of the Ca(2+) ion (τ ∼160 ms), and a slow process (τ ∼3.4 s) whose origin could not be unambiguously revealed. The Ca(2+)-binding affinity in the P-E(2) conformation was reduced with increasing pH, a behavior that can be explained by a reversible transition of the empty P-E(2) state to an inactivated state of the ion pump. All findings are interpreted in the framework of the Post-Albers pump cycle introduced previously, supplemented by an additional transition to an inhibited state of the ion pump.

The sarcoplasmic Ca2+-ATPase: design of a perfect chemi-osmotic pump

The sarcoplasmic (SERCA 1a) Ca2+-ATPase is a membrane protein abundantly present in skeletal muscles where it functions as an indispensable component of the excitation-contraction coupling, being at the expense of ATP hydrolysis involved in Ca2+/H+ exchange with a high thermodynamic efficiency across the sarcoplasmic reticulum membrane. The transporter serves as a prototype of a whole family of cation transporters, the P-type ATPases, which in addition to Ca2+ transporting proteins count Na+, K+-ATPase and H+, K+-, proton- and heavy metal transporting ATPases as prominent members. The ability in recent years to produce and analyze at atomic (2·3-3 Å) resolution 3D-crystals of Ca2+-transport intermediates of SERCA 1a has meant a breakthrough in our understanding of the structural aspects of the transport mechanism. We describe here the detailed construction of the ATPase in terms of one membraneous and three cytosolic domains held together by a central core that mediates coupling between Ca2+-transport and ATP hydrolysis. During turnover, the pump is present in two different conformational states, E1 and E2, with a preference for the binding of Ca2+ and H+, respectively. We discuss how phosphorylated and non-phosphorylated forms of these conformational states with cytosolic, occluded or luminally exposed cation-binding sites are able to convert the chemical energy derived from ATP hydrolysis into an electrochemical gradient of Ca2+ across the sarcoplasmic reticulum membrane. In conjunction with these basic reactions which serve as a structural framework for the transport function of other P-type ATPases as well, we also review the role of the lipid phase and the regulatory and thermodynamic aspects of the transport mechanism.

Molecular dynamics simulation exploration of cooperative migration mechanism of calcium ions in sarcoplasmic reticulum Ca2+-ATPase

Calcium ATPase is a member of the P-type ATPase, and it pumps calcium ions from the cytoplasm into the reticulum against a concentration gradient. Several X-ray structures of different conformations have been solved in recent years, providing basis for elucidating the active transport mechanism of Ca2+ ions. In this work, molecular dynamics (MD) simulations were performed at atomic level to investigate the dynamical process of calcium ions moving from the outer mouth of the protein to their binding sites. Five initial locations of Ca2+ ions were considered, and the simulations lasted for 2 or 6 ns, respectively. Specific pathways leading to the binding sites and large structural rearrangements around binding sites caused by uptake of calcium ions were identified. A cooperative binding mechanism was observed from our simulation. Firstly, the first Ca2+ ion binds to site I, and then, the second Ca2+ ion approaches. The interactions between the second Ca2+ and the residues around site I disturb the binding state of site I and weaken its binding ability for the first bound Ca2+. Because of the electrostatic repulsion of the second Ca2+ and the electrostatic attraction of site II, the first bound Ca2+ shifts from site I to site II. Concertedly, the second Ca2+ binds to site I, forming a binding state with two Ca2+ ions, one at site I and the other at site II. Both of Glu908 and Asp800 coordinate with the two Ca2+ ions simultaneously during the concerted binding process, which is believed to be the hinge to achieve the concerted binding. In our simulations, four amino acid residues that serve as the channel to link the outer mouth and the binding sites during the binding process were recognized, namely Tyr837, Tyr763, Asn911, and Ser767. The analyses regarding the activity of the proteins via mutations of some key residues also supported our cooperative mechanism.

Coefficients for active transport and thermogenesis of Ca2+-ATPase isoforms

Coefficients for active transport of ions and heat in vesicles with Ca(2+)-ATPase from sarcoplasmic reticulum are defined in terms of a newly proposed thermodynamic theory and calculated using experiments reported in the literature. The coefficients characterize in a quantitative manner different performances of the enzyme isoforms. Four enzyme isoforms are examined, namely from white and red muscle tissue, from blood platelets, and from brown adipose mitochondria. The results indicate that the isoforms have a somewhat specialized function. White muscle tissue and brown adipose tissue have the same active transport coefficient ratio, but the activity level of the enzyme in white muscle is higher than in brown adipose tissue. The thermogenesis ratio is high in both white muscle and brown adipose tissue, in agreement with a specific role in nonshivering thermogenesis. Other isoforms do not have this ability to generate heat. A calcium-dependence of the coefficients is found, which can be understood as being in accordance with the role of this ion as a messenger in muscle contraction as well as in thermogenesis. The investigation points to new experiments related to structure as well as to function of the isoforms.

A thermodynamic model of the cardiac sarcoplasmic/endoplasmic Ca(2+) (SERCA) pump

We present a biophysically based kinetic model of the cardiac SERCA pump that consolidates a range of experimental data into a consistent and thermodynamically constrained framework. The SERCA model consists of a number of sub-states with partial reactions that are sensitive to Ca(2+) and pH, and to the metabolites MgATP, MgADP, and Pi. Optimization of model parameters to fit experimental data favors a fully cooperative Ca(2+)-binding mechanism and predicts a Ca(2+)/H(+) counter-transport stoichiometry of 2. Moreover, the order of binding of the partial reactions, particularly the binding of MgATP, proves to be a strong determinant of the ability of the model to fit the data. A thermodynamic investigation of the model indicates that the binding of MgATP has a large inhibitory effect on the maximal reverse rate of the pump. The model is suitable for integrating into whole-cell models of cardiac electrophysiology and Ca(2+) dynamics to simulate the effects on the cell of compromised metabolism arising in ischemia and hypoxia.

The measurable heat flux that accompanies active transport by Ca2+-ATPase

We present a new mesoscopic basis which can be used to derive flux equations for the forward and reverse mode of operation of ion-pumps. We obtain a description of the fluxes far from global equilibrium. An asymmetric set of transport coefficients is obtained, by assuming that the chemical reaction as well as the ion transports are activated, and that the enzyme has a temperature independent of the activation coordinates. Close to global equilibrium, the description reduces to the well known one from non-equilibrium thermodynamics with a symmetric set of transport coefficients. We show how the measurable heat flux and the heat production under isothermal conditions, as well as thermogenesis, can be defined. Thermogenesis is defined via the onset of the chemical reaction or ion transports by a temperature drop. A prescription has been given for how to determine transport coefficients on the mesocopic level, using the macroscopic coefficient obtained from measurements, the activation enthalpy, and a proper probability distribution. The method may give new impetus to a long-standing unsolved transport problem in biophysics.

Properties of the SR Ca-ATPase in an Open Microsomal Membrane Preparation

SR vesicles isolated from rabbit muscle were treated by a SDS incubation and subsequent dialysis to obtain open membrane fragments that allow a direct access to the luminal membrane surface and especially to the ion-binding sites in the P-E(2) conformation of the Ca-ATPase. The open membrane fragments showed about 80% of the enzyme activity in the untreated membranes. Pump function was investigated by using electrochromic styryl dyes. The kinetic properties of cytoplasmic ion binding showed no significant differences between the Ca-ATPases in SR vesicles and in membrane fragments. From pH-dependent Ca(2+) binding it could be deduced that due to the SDS treatment the density of negatively charged lipid was increased by one elementary charge per 12 lipid molecules. Major differences between Ca-ATPase from SR vesicles and membrane fragments were the respective fluorescence amplitudes. This effect is, however, produced by dye-lipid interaction and not by pump function. It was demonstrated that time-resolved kinetics may be study by the use of caged compounds such as caged ATP or caged calcium also in the case of the membrane fragments.

Charge transfer in P-type ATPases investigated on planar membranes

Planar lipid bilayers, e.g., black lipid membranes (BLM) and solid supported membranes (SSM), have been employed to investigate charge movements during the reaction cycle of P-type ATPases. The BLM/SSM method allows a direct measurement of the electrical currents generated by the cation transporter following chemical activation by a substrate concentration jump. The electrical current transients provides information about the reaction mechanism of the enzyme. In particular, the BLM/SSM technique allows identification of electrogenic steps which in turn may be used to localize ion translocation during the reaction cycle of the pump. In addition, using the high time resolution of the technique, especially when rapid activation via caged ATP is employed, rate constants of electrogenic and electroneutral steps can be determined. In the present review, we will discuss the main results obtained by the BLM and SSM methods and how they have contributed to unravel the transport mechanism of P-type ATPases.

Electrogenic steps of the SR Ca-ATPase enzymatic cycle and the effect of curcumin

Sarcoplasmic reticulum (SR) vesicles were adsorbed on an octadecanethiol/phosphatidylcholine mixed bilayer anchored to a gold electrode, and the Ca-ATPase contained in the vesicles was activated by ATP concentration jumps in the presence of calcium ions. The resulting capacitive current transients are compared with those calculated on the basis of the enzymatic cycle of the calcium pump. This comparison provides information on the kinetics of the E(2)-E(1) conformational change and on its pH dependence. The alteration in the current transients following ATP concentration jumps in the presence of curcumin is examined. In particular, curcumin decreases the rate of slippage of the Ca-ATPase, and at concentrations above 10 microM reduces calcium transport by this pump.

Kinetics of proton binding to the sarcoplasmic reticulum Ca-ATPase in the E1 state

A new caged proton, 2-methoxy-5-nitrophenyl sulfate, was synthesized and used in time-resolved pH jump experiments to study proton binding in the sarcoplasmic reticulum Ca-ATPase. The major advantage of this compound is that it does not produce significant artifacts in experiments in which the fluorescent styryl dye 2BITC is used to monitor ion movements in the Ca pump. Two rate-limiting processes were resolved and their dependence on pH, Ca(2+) concentration, and temperature investigated. The faster process showed a relaxation time between 4 and 8 ms independent on pH and Ca(2+) concentration, and the time constant of the slower process varied between 31 ms (0 Ca(2+)) and 100 ms (100 microM Ca(2+)). A consistent mechanism to explain the results was derived in agreement with previous studies and the generally accepted Post-Albers scheme of the pump cycle. This mechanism requires that under physiological conditions the ion-binding sites are always occupied and two protons and a Ca(2+) ion replace each other. In the absence of ATP at low pH a nonphysiological state can be induced in which up to four protons bind to the Ca pump in the E(1) conformation. So far it could not be verified whether these additional protons bind to amino acid side chains or are coordinated as hydronium ions.

Pre-steady state electrogenic events of Ca2+/H+ exchange and transport by the Ca2+-ATPase

Native or recombinant SERCA (sarco(endo)plasmic reticulum Ca(2+) ATPase) was adsorbed on a solid supported membrane and then activated with Ca(2+) and ATP concentration jumps through rapid solution exchange. The resulting electrogenic events were recorded as electrical currents flowing along the external circuit. Current transients were observed following Ca(2+) jumps in the absence of ATP and following ATP jumps in the presence of Ca(2+). The related charge movements are attributed to Ca(2+) reaching its binding sites in the ground state of the enzyme (E(1)) and to its vectorial release from the enzyme phosphorylated by ATP (E(2)P). The Ca(2+) concentration and pH dependence as well as the time frames of the observed current transients are consistent with equilibrium and pre-steady state biochemical measurements of sequential steps within a single enzymatic cycle. Numerical integration of the current transients recorded at various pH values reveal partial charge compensation by H(+) in exchange for Ca(2+) at acidic (but not at alkaline) pH. Most interestingly, charge movements induced by Ca(2+) and ATP vary over different pH ranges, as the protonation probability of residues involved in Ca(2+)/H(+) exchange is lower in the E(1) than in the E(2)P state. Our single cycle measurements demonstrate that this difference contributes directly to the reduction of Ca(2+) affinity produced by ATP utilization and results in the countertransport of two Ca(2+) and two H(+) within each ATPase cycle at pH 7.0. The effects of site-directed mutations indicate that Glu-771 and Asp-800, within the Ca(2+) binding domain, are involved in the observed Ca(2+)/H(+) exchange.