AmF/NaF/SnCl2 solution reduces in situ enamel erosion - profilometry and cross-sectional nanoindentation analysis

Pilot clinical study to evaluate the efficacy of a professionally delivered high fluoride varnish on erosive tooth wear in an in-situ model

OBJECTIVES

The aim for this pilot study was to investigate the effect of a sodium fluoride varnish on step height measured by a profilometer from human enamel worn by healthy volunteers with a novel in situ/ex vivo erosion design.

METHOD

Healthy volunteers aged 18-70 years wore a palatal splint containing 8 human enamel samples and underwent two 3-day treatment periods for 6 h a day with a varnish containing sodium fluoride at 22,600 ppm and the control with the same ingredients but without fluoride. Each splint contained 4 polished and 4 unpolished samples. The interventions were applied to the surface of the enamel samples in randomised order, removed after 6 h, then immersed ex-vivo in 1 %, pH 2.7 citric acid for 2 min, repeated 4 times a day, over 2 days. Measurements of enamel were assessed blindly by microhardness on day 2 and by non-contact laser profilometry on day 3 for the two treatments.

RESULTS

24 volunteers, 2 males and 22 females aged 27-54 years, were screened and recruited. The delta microhardness, from polished samples removed at the end of day 2, for the control and fluoride treatment was 95.7 (22.9) kgf/mm2 and 123.7 (28.9) kgf/mm2, respectively (p < .005). The mean (SD) step height for the control polished enamel surfaces was 3.67 (2.07) µm and for the fluoride varnish was 1.79 (1.01) µm (p < .0005). The control unpolished enamel surfaces had a mean 2.09 (1.53) µm and the fluoride varnish was 2.11 (1.53) µm but no statistical difference was detected.

CONCLUSIONS

The results from this pilot study, utilizing an in-situ model where enamel was exposed to acid over the course of 2 days, demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm prevented erosive wear compared to a control on the polished enamel surfaces.

CLINICAL SIGNIFICANCE

Intra-oral study demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm reduced erosive tooth wear.

Combined use of stannous fluoride-containing mouth rinse and toothpaste prevents enamel erosion in vitro

OBJECTIVE

To compare the protective effect of commercial stannous-containing mouth rinses on enamel erosion in a simulated 5-day in vitro cycling model.

MATERIALS AND METHODS

81 human enamel specimens were embedded in resin blocks and divided into nine groups as follows; group 1: stannous fluoride (1000SnF2) toothpaste; groups 2,3, and 4 were the same as group 1 plus Elmex®, PerioMed™, and Meridol®, respectively, group 5: stannous fluoride (1450SnF2) toothpaste, groups 6, 7, and 8 were the same as group 5 plus Elmex®, PerioMed™, and Meridol®, respectively, group 9: negative control. An erosive challenge was induced with a 1 min hydrochloric acid (0.01 M, pH 2.2) treatment 3 times per day. Each cycle included immersing in the toothpaste slurry twice for two minutes and a one-minute rinse. The enamel slabs were immersed in artificial saliva between each erosive cycle and incubated overnight at 37 °C. Surface hardness loss and enamel loss were determined by Knoop surface hardness and non-contact profilometry, respectively. Finally, enamel surfaces were analyzed by scanning electron microscopy and X-ray energy dispersive spectroscopy (SEM/EDS).

RESULTS

All three mouth rinses had similar protective effects against erosion when using adjunct with 1000 SnF2 toothpaste (p > 0.05). With 1450 SnF2 toothpaste, Elmex® presented significantly lower surface hardness loss than Meridol® (p < 0.05). The combined use of Elmex® or PerioMed™ with toothpaste provided significantly better erosion protection than toothpaste alone, either 1000 or 1450 SnF2. In addition, 1000SnF2 toothpaste adjunct with mouth rinse is comparable to 1450 SnF2 toothpaste alone in preventing enamel erosion.

CONCLUSION

All three mouth rinses reduced enamel erosion. The additional use of a high concentration stannous containing mouth rinse with 1450 SnF2 toothpaste increases the protective effect against enamel erosion in vitro.

CLINICAL SIGNIFICANCE

To date, no standard protocol for preventing dental erosion is available. There are three stannous-containing mouth rinses on the market; however, no study compared their efficacy or indicated whether using adjuncts with anti-erosion toothpaste provides additional benefits. This study found that adding stannous mouth rinse to twice-daily toothpaste increases erosion protection.

Is the Erosion-Protective Effect Still Maintained when Tin Concentrations Are Reduced in Mouth Rinse Solutions?

OBJECTIVE

As a preventive measure, tin (Sn2+)-containing products have a great potential to prevent enamel surface loss during erosive challenges, but adverse effects of high Sn2+ concentrations, such as astringent feeling of the teeth, are reported. Therefore, the main aim of this in vitro study was to develop a solution with lower Sn2+ concentrations that can still prevent dental erosion.

METHODS

A total of 162 enamel specimens were prepared from human premolars, which were selected from a pool of extracted teeth. The specimens were randomly distributed to 9 groups (each group n = 18 enamel specimens) according to the different test treatments: a humid chamber (no treatment) as the negative control, the commercial Elmex® Erosion Protection mouth rinse as the positive control, and 7 solutions either with lower Sn2+ concentrations and/or containing flavoring. The experiment included 4 cycles, consisting of pellicle formation by incubating the specimens with 200 μL of human saliva at 37°C for 1 h, then placing the specimens in the treatment for 2 min (60 mL, 30°C, shaking at 70 rpm), and later submitting them to an erosive challenge for 1 min in citric acid (60 mL 1%, pH 3.6, 30°C). Surface hardness was measured with a Vickers diamond and surface reflection intensity was measured with a reflectometer.

RESULTS

The control group performed significantly worse than all other solutions containing Sn2+. In general, there were no significant differences among the Sn2+-containing groups, and they presented similar protective effects on the enamel even when Sn2+ concentrations were reduced and flavorings were added.

CONCLUSION

Sn2+ concentrations in mouth rinses may be lowered to 200 ppm without compromising the anti-erosive properties of the solution.

Characterization of the in situ pellicle ultrastructure formed under the influence of bovine milk and milk protein isolates

OBJECTIVES

The present study aimed to investigate if bovine milk or milk protein isolates, respectively, alter the ultrastructure of thein situ pellicle and might therefore have an influence on oral health.

METHODS

In situ pellicle samples were formed on bovine enamel slabs exposed in the oral cavity of three subjects for 6, 30, 60 or 120 min. After 3 min of pellicle formation, mouthrinses were performed for 3 min with (non-)homogenized UHT- or fresh milk (0.3% or 3.8% fat), 30% UHT-treated cream or different types of casein- or milk protein isolates containing preparations. The specimens were removed after the exposure times and transmission electron microscopy (TEM) was performed. Native pellicle samples served as controls.

RESULTS

Topical ultrastructural pellicle modifications were detected after mouthrinses with all types of homogenized UHT- or fresh milk and after the application of a 3% native casein micelles containing experimental solution. Atypical globular protein structures, identified as casein micelles, were temporarily adsorbed onto the pellicle. They were closely associated with lipid droplets. Furthermore, the mouthrinses occasionally affected the morphology of salivary bacteria. However, no notable ultrastructural alterations remained after 120 min of pellicle formation.

CONCLUSION

For the first time, bovine milk- and micellar casein-induced pellicle modifications were revealed by TEM. The adsorption of micellar casein is possibly due to its molecular interactions.

CLINICAL SIGNIFICANCE

Bovine milk or micellar caseins provide some potential for the development of preventive strategies against bacterial biofilm formation or erosive processes at the tooth surface.

Effect of fluoride mouthrinses and stannous ions on the erosion protective properties of the in situ pellicle

The particular feature of this study is the investigation of effects of pure fluoride- or stannous ions based mouthrinses on the erosion protective properties and the ultrastructure of the in situ pellicle (12 volunteers). Experimental solutions were prepared either from 500 ppm NaF, SMFP, AmF or SnF₂ or 1563 ppm SnCl₂, respectively. After 1 min of in situ pellicle formation on bovine enamel slabs, rinses with one of the preparations were performed for 1 min and intraoral specimens’ exposure was continued for 28 min. Native enamel slabs and rinses with bidestilled water served as controls. After oral exposure, slabs were incubated in HCl (pH 2; 2.3; 3) for 120 s and kinetics of calcium- and phosphate release were measured photometrically; representative samples were analysed by TEM and EDX. All mouthrinses reduced mineral loss compared to the native 30-min pellicle. The effect was pH-dependent and significant at all pH values only for the tin-containing mouthrinses. No significant differences were observed between the SnF₂- and the SnCl₂-containing solutions. TEM/EDX confirmed ultrastructural pellicle modifications. SnF₂ appears to be the most effective type of fluoride to prevent erosive enamel demineralisation. The observed effects primarily have to be attributed to the stannous ions’ content.

Impact of customary fluoride rinsing solutions on the pellicle's protective properties and bioadhesion in situ

This study investigated the impact of customary fluoride based mouthrinses on the ultrastructure and the functional properties of the in situ pellicle, considering the prevention of erosion (8 volunteers) and initial biofilm formation (12 volunteers). Bovine enamel slabs were carried intraorally. After 1 min of pellicle formation, the subjects rinsed with elmex Kariesschutz (A), Dontodent Med Care (B), meridol (C) or elmex Zahnschmelzschutz Professional (D) for 1 min. In situ pellicle formation was continued up to 30 min/8 h before processing the slabs in vitro. Erosion was simulated by incubating the specimens in HCl (pH 3.0, 2.3, 2.0) for 120 s, measuring the kinetics of calcium/phosphate release photometrically; representative samples were evaluated by TEM and EDX. Bacterial adhesion was visualized fluorescence microscopically (DAPI/BacLight). Native enamel slabs or physiological pellicle samples served as controls. All investigated mouthrinses enhanced the erosion preventive pellicle effect in dependence of the pH-value. A significant decrease of Ca/P release at all pH values was achieved after rinsing with D; TEM/EDX confirmed ultrastructural pellicle modifications. All mouthrinses tendentially reduced bacterial adherence, however not significantly. The mouthrinse containing NaF/AmF/SnCl₂ (D) offers an effective oral hygiene supplement to prevent caries and erosion.