Microfluidic Inverted Flow of Ternary Water/Hydrophilic/Hydrophobic Organic Solvent Solution in a Y-Type Microchannel and a Proposal of the Response Microfluidic Analysis through the Experiment

Phase-separation multiphase flow: preliminary application to analytical chemistry

A two-phase separation mixed solution can undergo phase separation from one phase to two phases (i.e., upper and lower phases) in a batch vessel in response to changes in temperature and/or pressure. This phase separation is reversible. When the mixed solution undergoes a phase change while being fed into a microspace region, a dynamic liquid-liquid interface is formed, leading to a multiphase structure. This flow is called a phase-separation multiphase flow. Annular flow in a microspace, which is one such phase-separation multiphase flow, is interesting and has been applied to chromatography, extraction, reaction fields, and mixing. Here, research papers related to phase-separation multiphase flows-ranging from the discovery of the phenomenon to basic and technical research from the viewpoint of analytical science-are reviewed. In addition, the development of a new separation mode in a high-performance liquid chromatography system based on phase-separation multiphase flow is introduced.

Observation of the phase-separation multiphase flow using a polyethylene glycol/phosphate mixed solutions and the aqueous two-phase distribution of red blood cells in the flow system

Phase-separation multiphase flow at a liquid-liquid interface was successfully formed in an aqueous two-phase system of polyethylene glycol/phosphate mixed solutions when fed into a microchannel (100 µm wide and 40 µm deep) on a microchip and a fused-silica capillary tube (100 µm ID). As one example, tube radial distribution flow (annular flow) was observed when 10.0 wt% polyethylene glycol 6000 and 8.5 wt% dipotassium hydrogen phosphate aqueous solution containing 1.0 mM Rhodamine B was fed at 40 ℃, recorded by bright field microscopy. It exhibited a dipotassium hydrogen phosphate-rich inner phase and polyethylene glycol-rich outer phase. Effects of conditions including composition, flow rate, viscosity, and contact angle on tube radial distribution flow were analyzed. It was found out that although the viscosity of PEG-rich solution was much higher than that of phosphate-rich one, the phase configuration in tube radial distribution flow did not necessarily obey the viscous dissipation law in untreated microchannel and capillary tube, as well as for all the types of PEG/phosphate mixed solution the PEG-rich solution occupied the outer phase near the ODS-treated inner wall of both microchannel and capillary tube against the law. To assess the use of microfluidic flow in applications, we examined the distribution of red blood cells in the inner and outer phases fed into double capillary tubes with different inner diameters. Cell distribution was found to concentrate in the inner (dipotassium hydrogen phosphate-rich) phase compared to the outer (polyethylene glycol-rich) phase at a ratio of 1.8.

Stable Formation of Aqueous/Organic Parallel Two-phase Flow in Nanochannels with Partial Surface Modification

In microfluidics, various chemical processes can be integrated utilizing parallel multiphase flows. Our group has extended this research to nanofluidics, and recently performed the extraction of lipids using parallel two-phase flow in nanochannels. Although this was achieved in surface-modified nanochannels, a stable condition of parallel two-phase flow remains unknown due to difficulties in device fabrication, for a suitable method of bonding surface-modified substrates is lacking. Therefore, research on parallel two-phase flow in nanochannels has been limited. Herein, a new bonding method which improves the wash process for the substrates and increases the bonding rate to ∼100% is described. The conditions to achieve parallel organic/aqueous two-phase flow were then studied. It was revealed that in nanochannels, higher capillary numbers for the organic phase flow were required compared to that in microchannels. The newly developed fabrication process and flow regimes will contribute to realize integrated nanofluidic devices capable of analyzing single molecules/cells.

Remote Investigation of Total Chromium Determination in Environmental Samples of the Kombolcha Industrial Zone, Ethiopia, Using Microfluidic Paper-based Analytical Devices

Microfluidic paper-based analytical devices (μ-PADs) fabricated in Japan were employed for the determination of total chromium (Cr) in water, soil, and lettuce irrigated with wastewater in Ethiopia. The μ-PADs, which were printed by wax printing in Japan, were transported to Ethiopia and prepared for the determination of total Cr by adding appropriate reagents to the pretreatment and detection zones. Soil and lettuce samples were determined by the μ-PADs and a UV-Vis spectrophotometer in Ethiopia. A paired t-test showed that the mean total Cr concentrations determined in the soil and lettuce samples were not significantly different between μ-PADs and UV-Vis spectrophotometric analysis at the 5% level of significance. This implies that the μ-PADs have good accuracy and reliability, and could be employed to monitor Cr in environmental samples. We found that the total Cr concentrations in all soil and lettuce samples were above the permissible limit. Moreover, evaluating Cr contamination level using the geo-accumulation index indicated that the soils were contaminated with Cr moderately to heavily. Thus, the present work successfully demonstrated the potential of remote investigations of pollution in a less-equipped laboratory by transporting the μ-PADs fabricated in another laboratory.

Development of Tube Radial Distribution Chromatography Based on Phase-Separation Multiphase Flow Created via Pressure Loss

A tube radial distribution chromatography (TRDC) method based on phase-separated multiphase flow created through phase transformation via temperature change has been developed. These systems typically required a temperature-controlling device containing a water bath and a stirrer. Herein, we proposed a novel TRDC system without a cooling device, where the phase transformation was achieved via pressure loss in a capillary tube of 50 μm inner diameter and 550 cm length. Model analytes were successfully separated with the developed TRDC system, which provided a simplified platform and helped to clarify the operating principle of TRDC based on phase transformation in a capillary tube.