Evaluation of pH-Dependent Metal Speciation Artifacts in Whole-Cell Bioreporter Analysis

Application of whole-cell bioreporters for ecological risk assessment and bioremediation potential evaluation after a benzene exceedance accident in groundwater in Lanzhou, China

Oil spill events challenge human health and ecosystem safety, which are priority concerned issues for sustainable development. There is then an increasing demand of tools for ecological risks assessment at contaminated sites. In this study, we introduced two whole-cell bioreporters, ADPWH_alk and ADPWH_recA, to measure the available n-alkanes and the genotoxicities of total petroleum hydrocarbons in soils and groundwater which were contaminated by the Benzene Exceedance Accident in Lanzhou, China. Comparing to traditional chemical analysis methods, the whole-cell bioreporter method could provide risk assessment on cell level within a shorter time and a less cost, which is economical and environment friendly. The highest contents of available alkanes in soil and groundwater were 18,737 mg/kg and 308.4 mg/L, respectively. In addition, the available n-alkanes significantly (p < 0.01) correlated to chemical analysis of total n-alkanes. The highest genotoxicity level was found in soil and groundwater samples with lower TPHs concentration (4338.0 mg/kg and 1.4 mg/L Mitomycin C equivalent), suggesting the significant impacts of geochemical variables and alkane availability on the ecological risks of petroleum contamination. Combining chemical analysis and whole-cell bioreporter results, bioremediation strategies were suggested for groundwater and soils with higher n-alkane availability and lower ecological risks, whereas chemical oxidation were suggested for other contaminated sites. For the first time, we mapped the distribution of available n-alkanes and petroleum toxicities in a large scale soil-groundwater system using whole-cell bioreporters, showing their huge potential for rapid contaminant detection and fast risk assessment.

Impacts of biochar materials on copper speciation, bioavailability, and toxicity in chromated copper arsenate polluted soil

Trace element polluted soils pose risks to human and environmental health. Biochar can decrease trace element bioavailability in soils, but their resulting ability to reduce soil toxicity may vary significantly depending on feedstocks used, pyrolysis conditions, and the target pollutants. Chromated copper arsenate (CCA) polluted sites are common, but only very few types of biochar have been tested for these sites. Hence, we tested fourteen well-characterized biochar materials for their ability to bind Cu and reduce toxicity in a CCA polluted soil in a 56-day experiment. Biochar (1%, wt/wt) increased plant (wheat, Triticum aestivum L.) shoot and root growth by 6-58% and 0-73%, reduced soil toxicity to Arthrobacter globiformis by 7-55%, decreased bioavailable Cu (Pseudomonas fluorescens bioreporter) by 5-65%, and decreased free Cu2+ ion activities by 27-89%. The A. globiformis solid-contact test constituted a sensitive ecotoxicological endpoint and deserves further attention for assessment of soil quality. Oil seed rape straw biochar generally performed better than other tested biochar materials. Biochar performance was positively correlated with its high cation exchange capacity, multiple surface functional groups, and high nitrogen and phosphorus content. Our results pave the way for future selection of feedstocks for creation of modified biochar materials with optimal performance in CCA polluted soil.

Use of whole-cell bioreporters to assess bioavailability of contaminants in aquatic systems

Water contamination has become increasingly a critical global environmental issue that threatens human and ecosystems’ health. Monitoring and risk assessment of toxic pollutants in water bodies is essential to identifying water pollution treatment needs. Compared with the traditional monitoring approaches, environmental biosensing via whole-cell bioreporters (WCBs) has exhibited excellent capabilities for detecting bioavailability of multiple pollutants by providing a fast, simple, versatile and economical way for environmental risk assessment. The performance of WCBs is determined by its elements of construction, such as host strain, regulatory and reporter genes, as well as experimental conditions. Previously, numerous studies have focused on the design and construction of WCB rather than improving the detection process and commercialization of this technology. For investigators working in the environmental field, WCB can be used to detect pollutants is more important than how they are constructed. This work provides a review of the development of WCBs and a brief introduction to genetic construction strategies and aims to summarize key studies on the application of WCB technology in detection of water contaminants, including organic pollutants and heavy metals. In addition, the current status of commercialization of WCBs is highlighted.

From speciation to toxicity: Using a "Two-in-One" whole-cell bioreporter approach to assess harmful effects of Cd and Pb

Due to the sheer number of contaminated sites, bioavailability-based measurement and modeling of toxicity is used to triage response; despite advances, both remain relatively cumbersome. Cadmium (Cd) and lead (Pb) are two of the most toxic and globally prevalent pollutants, disproportionately impacting disadvantaged communities. Here we demonstrate the use of high throughput lights-on bioreporter technology to measure both speciation and toxicity. The organism's response is fit-for-purpose to parameterize the Biotic Ligand Model used in risk assessment of aquatic ecotoxicity and setting environmental Water Quality Criteria. Toxicity endpoints for analogous Cd and Pb models reported in literature average 71st and 44th rank-percentile sensitivity of Genus Mean Acute Values for acute toxicity (i.e., insensitive) in comparison to the bioreporter, the unique dual-mode measurement ability of which can predict toxicity endpoints from below the 5th percentile up to the 50th rank-percentile. These results are extensible to other reporters, paving the way to cost-efficient environmental risk assessment of aquatic ecotoxicity for a wide range of priority toxic pollutants.

Long-term application of Swedish sewage sludge on farmland does not cause clear changes in the soil bacterial resistome

The widespread practice of applying sewage sludge to arable land makes use of nutrients indispensable for crops and reduces the need for inorganic fertilizer, however this application also provides a potential route for human exposure to chemical contaminants and microbial pathogens in the sludge. A recent concern is that such practice could promote environmental selection and dissemination of antibiotic resistant bacteria or resistance genes. Understanding the risks of sludge amendment in relation to antibiotic resistance development is important for sustainable agriculture, waste treatment and infectious disease management. To assess such risks, we took advantage of an agricultural field trial in southern Sweden, where land used for growing different crops has been amended with sludge every four years since 1981. We sampled raw, semi-digested and digested and stored sludge together with soils from the experimental plots before and two weeks after the most recent amendment in 2017. Levels of selected antimicrobials and bioavailable metals were determined and microbial effects were evaluated using both culture-independent metagenome sequencing and conventional culturing. Antimicrobials or bioavailable metals (Cu and Zn) did not accumulate to levels of concern for environmental selection of antibiotic resistance, and no coherent signs, neither on short or long time scales, of enrichment of antibiotic-resistant bacteria or resistance genes were found in soils amended with digested and stored sewage sludge in doses up to 12 metric tons per hectare. Likewise, only very few and slight differences in microbial community composition were observed after sludge amendment. Taken together, the current study does not indicate risks of sludge amendment related to antibiotic resistance development under the given conditions. Extrapolations should however be done with care as sludge quality and application practices vary between regions. Hence, the antibiotic concentrations and resistance load of the sludge are likely to be higher in regions with larger antibiotic consumption and resistance burden than Sweden.

Development of a Sensitive Escherichia coli Bioreporter Without Antibiotic Markers for Detecting Bioavailable Copper in Water Environments

The whole-cell bioreporters based on the cop-operon sensing elements have been proven specifically useful in the assessment of bioavailable copper ions in water environments. In this study, a series of experiments was conducted to further improve the sensitivity and robustness of bioreporters. First, an Escherichia coli △copA△cueO△cusA mutant with three copper transport genes knocked out was constructed. Then, the copAp::gfpmut2 sensing element was inserted into the chromosome of E. coli △copA△cueO△cusA by gene knock-in method to obtain the bioreporter strain E. coli WMC-007. In optimized assay conditions, the linear detection range of Cu²⁺ was 0.025–5 mg/L (0.39–78.68 μM) after incubating E. coli WMC-007 in Luria–Bertani medium for 5 h. The limit of detection of Cu²⁺ was 0.0157 mg/L (0.25 μM). Moreover, fluorescence spectrometry and flow cytometry experiments showed more environmental robustness and lower background fluorescence signal than those of the sensor element based on plasmids. In addition, we found that the expression of GFPmut2 in E. coli WMC-007 was induced by free copper ions, rather than complex-bound copper, in a dose-dependent manner. Particularly, the addition of 40 mM 3-(N-Morpholino)propanesulfonic acid buffer to E. coli WMC-007 culture enabled accurate quantification of bioavailable copper content in aqueous solution samples within a pH range from 0.87 to 12.84. The copper recovery rate was about 95.88–113.40%. These results demonstrate potential applications of E. coli WMC-007 as a bioreporter to monitor copper contamination in acidic mine drainage, industrial wastewater, and drinking water. Since whole-cell bioreporters are relatively inexpensive and easy to operate, the combination of this method with other physicochemical techniques will in turn provide more specific information on the degree of toxicity in water environments.

Assessment of biochar and zero-valent iron for in-situ remediation of chromated copper arsenate contaminated soil

Chromated copper arsenates (CCA) have been extensively used as wood impregnation agents in Europe and North America. Today, CCA contaminated sites remain abundant and pose environmental risks that need to be properly managed. Using a TRIAD approach that combined chemical, ecotoxicological and ecological assessment of soil quality, we investigated the abilities of biochar and zero-valent iron (ZVI) to remediate CCA contaminated soil in a microcosm experiment. Soil samples from a highly contaminated CCA site (1364, 1662 and 540 μg g^-1 of As, Cu and Cr, respectively) were treated with two different biochars (fine and coarse particle size; 1% w w^-1) and ZVI (5% w w^-1), both as sole and as combined treatments, and incubated for 56 days at 15 °C. In general, bioavailable As (As_bio) and Cu (Cu_bio) determined by whole-cell bacterial bioreporters corresponded well to water-extractable As and Cu (As_water and Cu_water). However, in biochar treatments, only Cu_bio and not Cu_water was significantly reduced. In contrast, under ZVI treatments only Cu_water and not Cu_bio was reduced, demonstrating the value of complementing analytical with bacterial bioreporter measurements to infer bioavailability of elements to soil microorganisms. The combined fine particle size biochar and ZVI treatment effectively reduced water extractable concentrations of Cr, Cu, and As on site by 45%, 45% and 43% respectively, and led to the highest ecological recovery of the soil bacterial community, as measured using the [³H]leucine incorporation technique. We conclude that the combined application of biochar and ZVI as soil amendments holds promise for in-situ stabilization of CCA contaminated sites.