Use of real-time sensors for compliance monitoring of nitrate in finished drinking water

Potential for managing pool levels in a flood-control reservoir to increase nitrate-nitrogen load reductions

Few strategies are available to reduce nitrate-nitrogen (NO3 -N) loads at larger landscape scales, but flood control reservoirs are known to reduce riverine loads. In this study, we evaluated the potential to increase nitrogen (N) loss at Lake Red Rock, a large reservoir located in central Iowa, by evaluating the inundation of sediments deposited at the reservoir inflow. Sediment samples were collected at 51 locations in the lower delta region and analyzed for particle size and nutrient content. Nitrogen loss rates in delta sediments were determined from laboratory assays, and satellite imagery was used to develop a rating curve to quantify land area inundated within the delta. The daily mass of NO3 -N reduced with delta inundation was estimated by applying the mean N 24-h loss rate (0.66 g N m2 day-1 ) by the area of inundation (m2 ). Results indicated that raising pool elevations to inundate more of the delta would result in greater N losses, ranging from 2 to 377 Mg per year. Potential N loss of 102 Mg achieved by increasing pool stage by 0.5 m would be equivalent to installing nearly 650 edge-of-field practices in the watershed. Although more work is needed to integrate with an existing environmental pool management plan, study results indicate that reservoir management could achieve N reductions at a novel landscape scale.

End-user perspective of low-cost sensors for urban stormwater monitoring: a review

The large-scale deployment of low-cost monitoring systems has the potential to revolutionize the field of urban hydrology monitoring, bringing improved urban management, and a better living environment. Even though low-cost sensors emerged a few decades ago, versatile and cheap electronics like Arduino could give stormwater researchers a new opportunity to build their own monitoring systems to support their work. To find out sensors which are ready for low-cost stormwater monitoring systems, for the first time, we review the performance assessments of low-cost sensors for monitoring air humidity, wind speed, solar radiation, rainfall, water level, water flow, soil moisture, water pH, conductivity, turbidity, nitrogen, and phosphorus in a unified metrological framework considering numerous parameters. In general, as these low-cost sensors are not initially designed for scientific monitoring, there is extra work to make them suitable for in situ monitoring, to calibrate them, to validate their performance, and to connect them with open-source hardware for data transmission. We, therefore, call for international cooperation to develop uniform low-cost sensor production, interface, performance, calibration and system design, installation, and data validation guides which will greatly regulate and facilitate the sharing of experience and knowledge.