Photocatalytic degradation of hydroxychloroquine using ZnO supported on clinoptilolite zeolite

Evaluation of diazepam adsorption in aqueous media using low-cost and natural zeolite: equilibrium and kinetics

Diazepam has been detected in water sources around the world affecting the quality of drinking water. Even in small quantities, recent studies have proven the negative effects of the drug on human body. Since traditional water and sewage treatment do not remove this type of contaminant, it became interesting to evaluate forms to remove them from water sources. A cheap and eco-friendly alternative to remove this drug from the water is through adsorption using the natural clinoptilolite zeolite as an adsorbent. This work goal was to study the characterizations of clinoptilolite, such as scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), X-ray diffractometer (XRD), and Fourier transform infrared spectroscopy (FTIR) and analyze the potential of this material as an adsorbent. Kinetic studies and isotherm analysis were performed in batch. The results showed the potential of the natural zeolite to remove the pollutant in an aqueous medium reaching a maximum adsorption capacity of 8.25 mg g^-1. The adsorption process followed a pseudo-second-order kinetics indicating that the adsorption was based on a chemisorption process. The isotherms curves shown favorable adsorption and the Langmuir isotherm model fit the experimental data better.

Ultraviolet-coupled advanced oxidation processes for anti-COVID-19 drugs treatment: Degradation mechanisms, transformation products and toxicity evolution

Remdesivir (RDV), dexamethasone (DEX) and hydroxychloroquine (HCQ) were widely used in the treatment of COVID-19 pneumonia, possibly causing environmental risks and drug-resistance viruses. This study elucidated the degradation mechanisms and potential toxicity risks of the three anti-COVID-19 drugs by UV and ultraviolet-coupled advanced oxidation processes (UV/AOPs). All the drugs could be degraded by more than 98% within 3 min under the following optimal conditions: pH of 5.0 and drug-to-oxidant (H₂O₂) molar ratio of 1:200. Combined with density functional theory (DFT) analysis and high-performance liquid chromatography quadrupole time-of-flight mass spectrometry (HPLC-QTOF-MS), twenty-four transformation products (TPs) were detected and the main degradation pathways were investigated. Based on bacterial luminescence inhibition test and the peak-area evolution of TPs, RDV and HCQ showed an obvious toxicity-increase region when TPs were generated in large quantities, while the toxicity of DEX continued to decline during degradation processes. By QSAR predictions, the main contributors to the toxicity evolution during the UV/AOPs were predicted. Halogen-containing TPs showed significantly higher toxicity than other TPs, and thus the chlorine-containing structure in HCQ presented the potential toxicity. Appropriate reaction parameters and adequate reaction time for the UV/AOPs could eliminate the toxicity of TPs and ensure environmental safety. This study could play a positive role in the treatment of anti-COVID-19 drugs and their environmental hazard assessment.

SARS-CoV-2 pharmaceutical drugs: a critical review on the environmental impacts, chemical characteristics, and behavior of advanced oxidation processes in water

This review summarizes research data on the pharmaceutical drugs used to treat the novel SARS-CoV-2 virus, their characteristics, environmental impacts, and the advanced oxidation processes (AOP) applied to remove them. A literature survey was conducted using the electronic databases Science Direct, Scopus, Taylor & Francis, Google Scholar, PubMed, and Springer. This complete research includes and discusses relevant studies that involve the introduction, pharmaceutical drugs used in the SARS-CoV-2 pandemic: chemical characteristics and environmental impact, advanced oxidation process (AOP), future trends and discussion, and conclusions. The results show a full approach in the versatility of AOPs as a promising solution to minimize the environmental impact associated with these compounds by the fact that they offer different ways for hydroxyl radical production. Moreover, this article focuses on introducing the fundamentals of each AOP, the main parameters involved, and the concomitance with other sources and modifications over the years. Photocatalysis, sonochemical technologies, electro-oxidation, photolysis, Fenton reaction, ozone, and sulfate radical AOP have been used to mineralize SARS-CoV-2 pharmaceutical compounds, and the efficiencies are greater than 65%. According to the results, photocatalysis is the main technology currently applied to remove these pharmaceuticals. This process has garnered attention because solar energy can be directly utilized; however, low photocatalytic efficiencies and high costs in large-scale practical applications limit its use. Furthermore, pharmaceuticals in the environment are diverse and complex. Finally, the review also provides ideas for further research needs and major concerns.

Hydroxychloroquine Adsorption in Aqueous Medium Using Clinoptilolite Zeolite

The presence of drugs on a large scale in aquatic matrices raises concern and requires the study of efficient technologies to remove these compounds. This study investigated the adsorption capacity of the natural zeolite clinoptilolite (CP) in removing the drug hydroxychloroquine (HCQ). Zeolite was characterized by BET, XRD, FT-IR, SEM, and pH_pzc techniques. The kinetic model that best fits the experimental data was the pseudo-first-order and the SIPS isotherm provided the best fit. The Langmuir isotherm RL separation factor (> 0.01) indicated that the adsorption process was favorable and the Freundlich isotherm (n > 1) suggested that the adsorption mechanism occurred mainly by physisorption, with intraparticle diffusion as the step limiting the process. The process was spontaneous (ΔG°_ads < 0), endothermic (ΔH°_ads > 0), and with increased randomness at the solid-solution interface (ΔS°_ads > 0). The initial pH variation of the effluent was not favorable for the adsorption process and the zeolite was easily regenerated for later use. The ecotoxicological tests with Artemia salina and Lactuca Sativa proved that the final effluent did not show toxicity after the adsorption treatment. Based on the results obtained in this work, clinoptilolite zeolite is a potential adsorbent for reducing HCQ toxicity in aquatic matrices.

SUPPLEMENTARY INFORMATION

The online version contains supplementary material available at 10.1007/s11270-022-05787-3.

Nanomaterials for Photocatalytic Degradations of Analgesic, Mucolytic and Anti-Biotic/Viral/Inflammatory Drugs Widely Used in Controlling SARS-CoV-2

The COVID-19 pandemic has been transformed into one of the main worldwide challenges, in recent years. For controlling symptoms that are caused by this disease (e.g., chills or fever, shortness of breath and/or difficulty in breathing, cough, sore throat, fatigue, headache, muscle aches, the new loss of tastes and/or smells, congestion or runny nose, nausea, vomiting and/or diarrhea), lots of medicines including analgesics, mucolytics, and anti-biotic/viral/inflammatory drugs have been frequently prescribed. As these medicines finally contaminate terrestrial and aquatic habitats by entering surface waterways through pharmaceutical production and excreting trace amounts of waste after human usage, they have negative impacts on wildlife’s health and ecosystem. Residual drugs in water have the potential to harm aquatic creatures and disrupt their food chain as well as the breeding cycle. Therefore, proper degradation of these broadly used medicines is highly crucial. In this work, the use of nanomaterials applicable in photocatalytic degradations of analgesics (e.g., acetaminophen, aspirin, ibuprofen, and naproxen), mucolytics (e.g., ambroxol), antibiotics (e.g., azithromycin and quinolones including hydroxychloroquine and chloroquine phosphate), anti-inflammatory glucocorticoids (e.g., dexamethasone and cortisone acetate), antihistamines (e.g., diphenhydramine), H2 blockers (e.g., famotidine), anthelmintics (e.g., praziquantel), and finally antivirals (e.g., ivermectin, acyclovir, lopinavir/ritonavir, favipiravir, nitazoxanide, and remdesivir) which widely used in controlling/treating the coronavirus have been reviewed and discussed.

Achieving Electrochemical-Sustainable-Based Solutions for Monitoring and Treating Hydroxychloroquine in Real Water Matrix

Hydroxychloroquine (HCQ) has been extensively consumed due to the Coronavirus (COVID-19) pandemic. Therefore, it is increasingly found in different water matrices. For this reason, the concentration of HCQ in water should be monitored and the treatment of contaminated water matrices with HCQ is a key issue to overcome immediately. Thus, in this study, the development of technologies and smart water solutions to reach the Sustainable Development Goal 6 (SDG6) is the main objective. To do that, the integration of electrochemical technologies for their environmental application on HCQ detection, quantification and degradation was performed. Firstly, an electrochemical cork-graphite sensor was prepared to identify/quantify HCQ in river water matrices by differential pulse voltammetric (DPV) method. Subsequently, an HCQ-polluted river water sample was electrochemically treated with BDD electrode by applying 15, 30 and 45 mA cm−2. The HCQ decay and organic matter removal was monitored by DPV with composite sensor and chemical oxygen demand (COD) measurements, respectively. Results clearly confirmed that, on the one hand, the cork-graphite sensor exhibited good current response to quantify of HCQ in the river water matrix, with limit of detection and quantification of 1.46 mg L−1 (≈3.36 µM) and 4.42 mg L−1 (≈10.19 µM), respectively. On the other hand, the electrochemical oxidation (EO) efficiently removed HCQ from real river water sample using BDD electrodes. Complete HCQ removal was achieved at all applied current densities; whereas in terms of COD, significant removals (68%, 71% and 84% at 15, 30 and 45 mA cm−2, respectively) were achieved. Based on the achieved results, the offline integration of electrochemical SDG6 technologies in order to monitor and remove HCQ is an efficient and effective strategy.

Removal of hydroxychloroquine from an aqueous solution using living microalgae: Effect of operating parameters on removal efficiency and mechanisms

Wastewater contaminated with hydroxychloroquine (HCQ) poses a serious threat to the environment and human life. This study aimed to evaluate the ability of living microalgae to remove HCQ from an aqueous solution. Batch mode experiments were conducted under different conditions to investigate the effect of operating parameters on HCQ removal efficiency and mechanisms. Equilibrium, kinetic and thermodynamic study was also carried out to better describe the interactions between HCQ and microalgae. The maximum HCQ removal was 92.10 ± 1.25% obtained under optimal pH of 9.9 ± 0.1, a contact time of 45 min, a stirring speed of 300 rpm, an initial HCQ concentration of 20 mg/L, and a microalgae dose of 100 mg/L. The Langmuir isotherm and the pseudo-second-order kinetic model were best suited for the biosorption experiments, and the maximum biosorption capacity was 339.02 mg/g. The thermodynamic study showed that the biosorption process was exothermic and spontaneous. Experiments on real wastewater showed that the HCQ removal was not significantly affected by the presence of other contaminants in the water. PRACTITIONER POINTS: The best HCQ removal was 92.10 ± 1.25% obtained under optimal conditions. The Langmuir isotherm and the pseudo-second-order kinetic model were best suited for the biosorption experiments. The maximum biosorption capacity was 339.02 mg/g. The thermodynamic study showed that the biosorption process was exothermic and spontaneous. The microalgae studied can be successfully used in HCQ removal from water.