Photocatalytic and adsorptive performance of polyvinyl alcohol/chitosan/TiO2 composite for antibiotics removal: single- and multi-pollutant conditions

Temperature effects and molecular insights towards the optimization of polyvinyl alcohol as adsorbent of organic pollutants from aqueous solution

One of the easier methods of wastewater treatment is adsorption due to its simplicity in implementation, environmental friendliness, and economic feasibility. Polyvinyl alcohol (PVA) looks promising as an adsorbent due to its biocompatible, non-toxic, water-soluble and eco-friendly nature. The investigation of PVA for its potential in the adsorption of pollutants has been reported in many studies but the mechanistic understanding of the adsorption is poor. The present study used a theoretical approach through density functional theory and Monte Carlo with molecular dynamics simulations to investigate the adsorption mechanism behaviors of model organic molecules (bromothymol blue (BTB), methylene blue (MB), metronidazole (MNZ) and tetracycline (TC)) on PVA surface. The quantum chemical calculations result showed that with the increase in PVA chains (2, 4, 8, 16, and 32 units), the zero-point energy decreases (from -308.79 to -4922.93 kcal/mol) while the dipole moment increases (from 4.37 to 87.52 Debye). Temperature effect on the PVA chain structures showed the same trends for all the chain units and with the increase in temperature (50-600 K), there are no appreciable changes in zero-point energy, enthalpy energy increases while Gibbs free energy decreases. Considering PVA-pollutant complexes, the effects of temperature on the structures showed that there are no appreciable changes in the zero-point energy, Gibbs free and thermal energies increase with an increase in temperature while the kinetic rate of reactions decreases with an increase in temperature. The enthalpy of the reaction showed different trends with antibiotic and dye complexes. In all the thermodynamic properties investigated and the rate of reaction, the order of affinity of the pollutants with PVA followed TC > MNZ > MB > BTB. Monte Carlo simulation was used to investigate the adsorption behavior of the pollutants on the surface of PVA. The negative adsorption energies (-366.56 to -2266.81 kcal/mol) in terms of affinity towards the pollutants on the surface of PVA followed the sequence TC > MNZ > BTB > MB and the molecular dynamic simulation results followed the same order. The obtained results give valuable insights into the mechanism and performance of PVA as an adsorbent. Most of these computational observations are in good agreement with the available experimental results.

Bioactivity of Eugenol: A Potential Antibiotic Adjuvant with Minimal Ecotoxicological Impact

Combining commercial antibiotics with adjuvants to lower their minimum inhibitory concentration (MIC) is vital in combating antimicrobial resistance. Evaluating the ecotoxicity of such compounds is crucial due to environmental and health risks. Here, eugenol was assessed as an adjuvant for 7 commercial antibiotics against 14 pathogenic bacteria in vitro, also examining its acute ecotoxicity on various soil and water organisms (microbiota, Vibrio fischeri, Daphnia magna, Eisenia foetida, and Allium cepa). Using microdilution methods, checkerboard assays, and kinetic studies, the MICs for eugenol were determined together with the nature of its combinations with antibiotics against bacteria, some unexposed to eugenol previously. The lethal dose for the non-target organisms was also determined, as well as the Average Well Color Development and the Community-Level Physiological Profiling for soil and water microbiota. Our findings indicate that eugenol significantly reduces MICs by 75 to 98%, which means that it could be a potent adjuvant. Ecotoxicological assessments showed eugenol to be less harmful to water and soil microbiota compared to studied antibiotics. While Vibrio fischeri and Daphnia magna were susceptible, Allium cepa and Eisenia foetida were minimally affected. Given that only 0.1% of eugenol is excreted by humans without metabolism, its environmental risk when used with antibiotics appears minimal.

Bio-based matrix photocatalysts for photodegradation of antibiotics

Antibiotics development during the last century permitted unprecedent medical advances. However, it is undeniable that there has been an abuse and misuse of antimicrobials in medicine and cosmetics, food production and food processing, in the last decades. The pay toll for human development and consumism is the emergence of extended antimicrobial resistance and omnipresent contamination of the biosphere. The One Health concept recognizes the interconnection of human, environmental and animal health, being impossible alter one without affecting the others. In this context, antibiotic decontamination from water-sources is of upmost importance, with new and more efficient strategies needed. In this framework, light-driven antibiotic degradation has gained interest in the last few years, strongly relying in semiconductor photocatalysts. To improve the semiconductor properties (i.e., efficiency, recovery, bandgap width, dispersibility, wavelength excitation, etc.), bio-based supporting material as photocatalysts matrices have been thoroughly studied, exploring synergetic effects as operating parameters that could improve the photodegradation of antibiotics. The present work describes some of the most relevant advances of the last 5 years on photodegradation of antibiotics and other antimicrobial molecules. It presents the conjugation of semiconductor photocatalysts to different organic scaffolds (biochar and biopolymers), then to describe hybrid systems based on g-C3N4 and finally addressing the emerging use of organic photocatalysts. These systems were developed for the degradation of several antibiotics and antimicrobials, and tested under different conditions, which are analyzed and thoroughly discussed along the work.

Multi-antibiotics removal under UV-A light using sol-gel prepared TiO2: Central composite design, effect of persulfate addition and degradation pathway study

The removal of three antibiotics i.e., metronidazole (MNZ), ciprofloxacin (CIP) and tetracycline (TET), from aqueous system via TiO2 photocatalysis under UV-A light was investigated. Photocatalyst(s) were prepared using sol-gel method under different calcination temperatures (400-800 °C) and water-alcohol ratio. The spherical shaped catalyst (mean particle size ∼ 61 nm) was characterized via FTIR, XRD, BET, SEM, Raman, XPS, UV-DRS, and Fluorometry, and point of zero charge was also determined (pHPZC ∼ 6.6). Batch photo-catalytic degradation studies have shown complete degradation of MNZ, CIP and TET after 50, 75 and 20 min with a TOC removal of 37%, 44% and 31%, respectively. The activity of sol-gel prepared TiO2 was comparatively higher than commercially available pure anatase TiO2 nanoparticles due to lesser mean particle size. The ratio of water to alcohol in the preparation of TiO2 catalyst was found to have significant effect on antibiotic removal. Moreover, persulfate (PS) addition of 0.1 g/L amplified the pseudo-first-order removal-rate constant by 2.75, 3.3 and 1.6 times for MNZ, CIP and TET, respectively. The higher initial pH values (8 and 10) have shown the best removal efficiency for all antibiotics. Subsequently, central composite design (CCD) experiments were conducted under multi-antibiotic conditions. Near complete removal of all antibiotics were observed within 120 min. Scavenging studies revealed that hydroxyl and superoxide radicals play major roles in photo-catalytic degradation of MNZ, CIP and TET. During photocatalysis, MNZ degradation was initiated by hydroxylation reaction, CIP by piperazine ring opening by hydroxyl attack and TET by multiple hydroxylation process. Overall, TiO2 showed good efficiency at degrading multiple antibiotics and has the potential for practical application on a larger scale.