Effect of the high-pressure-release phase on the protein composition of the soluble milk fraction

The efficacy and safety of high-pressure processing of food

High-pressure processing (HPP) is a non-thermal treatment in which, for microbial inactivation, foods are subjected to isostatic pressures (P) of 400-600 MPa with common holding times (t) from 1.5 to 6 min. The main factors that influence the efficacy (log10 reduction of vegetative microorganisms) of HPP when applied to foodstuffs are intrinsic (e.g. water activity and pH), extrinsic (P and t) and microorganism-related (type, taxonomic unit, strain and physiological state). It was concluded that HPP of food will not present any additional microbial or chemical food safety concerns when compared to other routinely applied treatments (e.g. pasteurisation). Pathogen reductions in milk/colostrum caused by the current HPP conditions applied by the industry are lower than those achieved by the legal requirements for thermal pasteurisation. However, HPP minimum requirements (P/t combinations) could be identified to achieve specific log10 reductions of relevant hazards based on performance criteria (PC) proposed by international standard agencies (5-8 log10 reductions). The most stringent HPP conditions used industrially (600 MPa, 6 min) would achieve the above-mentioned PC, except for Staphylococcus aureus. Alkaline phosphatase (ALP), the endogenous milk enzyme that is widely used to verify adequate thermal pasteurisation of cows' milk, is relatively pressure resistant and its use would be limited to that of an overprocessing indicator. Current data are not robust enough to support the proposal of an appropriate indicator to verify the efficacy of HPP under the current HPP conditions applied by the industry. Minimum HPP requirements to reduce Listeria monocytogenes levels by specific log10 reductions could be identified when HPP is applied to ready-to-eat (RTE) cooked meat products, but not for other types of RTE foods. These identified minimum requirements would result in the inactivation of other relevant pathogens (Salmonella and Escherichia coli) in these RTE foods to a similar or higher extent.

The Effect of High-Pressure Treatment and Skimming on Caprine Milk Proteins

Background: Proteins are susceptible to HP-treatment and there is a need to determine the applicability of HP-treatment in dairy production. The aim of this study was to determine the effect of HP-treatment at 200–500 MPa (tconst. = 10 min; Tconst. = 20 °C) and skimming of HP-treated milk on the content of nitrogen compounds and protein composition of caprine milk. Methods: The content of nitrogen (total, non-casein, non-protein) was determined using the Kjeldahl method. Casein fractions and whey proteins were separated using SDS-PAGE electrophoresis. Color parameters were measured in the CIELAB color space. Results: HP-treatment decreased (p < 0.05) the content of non-casein nitrogen and soluble whey proteins. Skimming decreased the content of nitrogen compounds, and the noted decrease was more pronounced in HP-treated milk. Pressure and skimming had no influence on the proportions of α-, β-, κ-casein, β-lactoglobulin and α-lactalbumin. Total color difference (ΔE) increased with a rise in pressure, particularly in skim milk. Conclusion: HP-treatment led to a loss of protein solubility at pH 4.6 in caprine milk. In HP-treated milk, skimming did not induce changes in protein composition, despite a decrease in the content of nitrogen compounds after the separation of the cream layer. Higher values of ΔE in skim milk than in whole milk point to changes in colloidal phase components.

Retrogradation of Maize Starch after High Hydrostatic Pressure Gelation: Effect of Amylose Content and Depressurization Rate

High hydrostatic pressure (HHP) has been employed to gelatinize or physically modify starch dispersions. In this study, waxy maize starch, normal maize starch, and two high amylose content starch were processed by a HHP of the order of 600 MPa, at 25°C for 15min. The effect of HHP processing on the crystallization of maize starches with various amylose content during storage at 4°C was investigated. Crystallization kinetics of HHP treated starch gels were investigated using rheology and FTIR. The effect of crystallization on the mechanical properties of starch gel network were evaluated in terms of dynamic complex modulus (G*). The crystallization induced increase of short-range helices structures were investigated using FTIR. The pressure releasing rate does not affect the starch retrogradation behaviour. The rate and extent of retrogradation depends on the amylose content of amylose starch. The least retrogradation was observed in HHP treated waxy maize starch. The rate of retrogradation is higher for HHP treated high amylose maize starch than that of normal maize starch. A linear relationship between the extent of retrogradation (phase distribution) measured by FTIR and G* is proposed.