Modification of Oligo- and Polylactides With Macrocyclic Fragments: Synthesis and Properties

Calixarene-Metal Complexes in Lactide Polymerization: The Story so Far

Polylactide synthetic procedures have lately gained attention, possibly due to their biocompatibility and the environmental problems associated with fossil-fuel-based polymers. Polylactides can be obtained from natural sources such as cassava, corn, and sugar beet, and polylactides can be manufactured in a laboratory using a variety of processes that begin with lactic acid or lactide. One of the most effective synthetic pathways is through a Lewis acid catalyzed ring-opening polymerization of lactides to obtain a well-defined polymer. In this regard, calixarenes, because of their easy functionalization and tunable properties, have been widely considered to be a suitable 3D molecular scaffold for new metal complexes that can be used for lactide polymerization. This review summarizes the progress made in applying some metal-calixarene complexes in the ring-opening polymerization of lactide.

Nanoprecipitation of Biocompatible Poly(malic acid) Derivative, Its Ability to Encapsulate a Molecular Photothermal Agent and Photothermal Properties of the Resulting Nanoparticles

Biocompatible nanoparticles (NPs) of hydrophobic poly(benzyl malate) (PMLABe) were prepared by nanoprecipitation. The influence of nanoprecipitation parameters (initial PMLABe, addition rate, organic solvent/water ratio and stirring speed) were studied to optimize the resulting formulations in terms of hydrodynamic diameter (Dh) and dispersity (PDI). PMLABe NPs with a Dh of 160 nm and a PDI of 0.11 were isolated using the optimized nanoprecipitation conditions. A hydrophobic near infra-red (NIR) photothermally active nickel-bis(dithiolene) complex (Ni8C12) was then encapsulated into PMLABe NPs using the optimized nanoprecipitation conditions. The size and encapsulation efficiency of the NPs were measured, revealing that up to 50 weight percent (wt%) of Ni8C12 complex can efficiently be encapsulated with a slight increase in Dh of the corresponding Ni8C12-loaded NPs. Moreover, we have shown that NP encapsulating Ni8C12 were stable under storage conditions (4 °C) for at least 10 days. Finally, the photothermal properties of Ni8C12-loaded NPs were evaluated and a high photothermal efficiency (62.7 ± 6.0%) waswas measured with NPs incorporating 10 wt% of the Ni8C12 complex.

PAMAM-calix-dendrimers: Synthesis and Thiacalixarene Conformation Effect on DNA Binding

A convenient method for the synthesis of the first generation PAMAM dendrimers based on the thiacalix[4]arene has been developed for the first time. Three new PAMAM-calix-dendrimers with the macrocyclic core in cone, partial cone, and 1,3-alternate conformations were obtained with high yields. The interaction of the obtained compounds with salmon sperm DNA resulted in the formation of the associates of the size up to 200 nm, as shown by the UV-Vis spectroscopy, DLS, and TEM. It was demonstrated by the CD method that the structure of the DNA did not undergo significant changes upon binding. The PAMAM-calix-dendrimer based on the macrocycle in cone conformation stabilized DNA and prevented its degradation.

Catechol-Containing Schiff Bases on Thiacalixarene: Synthesis, Copper (II) Recognition, and Formation of Organic-Inorganic Copper-Based Materials

For the first time, a series of catechol-containing Schiff bases, tetrasubstituted at the lower rim thiacalix[4]arene derivatives in three stereoisomeric forms, cone, partial cone, and 1,3-alternate, were synthesized. The structure of the obtained compounds was proved by modern physical methods, such as NMR, IR spectroscopy, and HRMS. Selective recognition (K_b difference by three orders of magnitude) of copper (II) cation in the series of d-metal cations (Cu²⁺, Ni²⁺, Co²⁺, Zn²⁺) was shown by UV-vis spectroscopy. Copper (II) ions are coordinated at the nitrogen atom of the imine group and the nearest oxygen atom of the catechol fragment in the thiacalixarene derivatives. High thermal stable organic-inorganic copper-based materials were obtained on the base of 1,3-alternate + Cu (II) complexes.

Thiacalixarene based quaternary ammonium salts as promising antibacterial agents

The search for new antibacterial and antiseptic drugs is an urgent problem due to the resistance of microorganisms to existing drugs. In this work, for the first time, the design of antibacterial and bactericidal agents based on quaternary ammonium compounds on thiacalixarene macrocyclic platform was proposed and implemented. A series of tetrasubstituted quaternary ammonium salts with different nature and length of the substituent (-N⁺(CH₃)₂R, R = CH₂Ph, C_nH_2n+1, n = 1, 4, 8, 10) based on p-tert-butylthiacalix[4]arene in cone and 1,3-alternate conformations was obtained with excellent yields. The obtained compounds have a high antibacterial effect against Gram-positive (S. aureus, S. epidermidis, B. subtilis) bacteria comparable with commercial antiseptics chlorhexidine, miramistin and benzalkonium chloride. It was found that quaternary ammonium derivatives of thiacalix[4]arene in 1,3-alternate conformation more effectively inhibit the growth of the tested bacterial strains in comparison with compounds in cone conformation. Cytotoxicity studies on human skin fibroblast (HSF) cells demonstrated that all compounds were less toxic compared to reference drugs. The different type of interaction of the studied compounds with model DPPC lipid membranes explains different antibacterial activity and cytotoxicity of compounds. The compounds in cone conformation are adsorbed on the DPPC vesicles membrane surface, while the incorporation of lipophilic alkyl fragments of macrocycles in 1,3-alternate conformation into the membrane leads to "clumping" of DPPC vesicles. It was shown the saving of antibacterial activity of thiacalixarene derivatives in 1,3-alternate conformation on Gram-positive clinical strains. The obtained results allow viewing the described thiacalixarene based quaternary ammonium compounds as promising molecules in the development of the new antibacterial agents.

2D Monomolecular Nanosheets Based on Thiacalixarene Derivatives: Synthesis, Solid State Self-Assembly and Crystal Polymorphism

Synthetic organic 2D materials are attracting careful attention of researchers due to their excellent functionality in various applications, including storage batteries, catalysis, thermoelectricity, advanced electronics, superconductors, optoelectronics, etc. In this work, thiacalix[4]arene derivatives functionalized by geranyl fragments at the lower rim in cone and 1,3-alternate conformations, that are capable of controlled self-assembly in a 2D nanostructures were synthesized. X-ray diffraction analysis showed the formation of 2D monomolecular-layer nanosheets from synthesized thiacalix[4]arenes, the distance between which depends on the stereoisomer used. It was established by DSC, FSC, and PXRD methods that the obtained macrocycles are capable of forming different crystalline polymorphs, moreover dimethyl sulphoxide (DMSO) is contributing to the formation of a more stable polymorph for cone stereoisomer. The obtained crystalline 2D materials based on synthesized thiacalix[4]arenes can find application in material science and medicine for the development of modern pharmaceuticals and new generation materials.

Supramolecular Interactions in Hybrid Polylactide Blends-The Structures, Mechanisms and Properties

The conformation of polylactide (PLA) chains can be adjusted by supramolecular interactions (the formation of hydrogen bonds or host-guest complexes) with appropriate organic molecules. The structures formed due to those intermolecular interactions may act as crystal nuclei in the PLA matrix ("soft templating"). In this review, the properties of several supramolecular nucleating systems based on synthetic organic nucleators (arylamides, hydrazides, and 1,3:2,4-dibenzylidene-d-sorbitol) are compared to those achieved with biobased nucleating agents (orotic acid, humic acids, fulvic acids, nanocellulose, and cyclodextrins) that can also improve the mechanical properties of PLA. The PLA nanocomposites containing both types of nucleating agents/additives are discussed and evaluated in the context of their biomedical applicability.

The Role of Calix[n]arenes and Pillar[n]arenes in the Design of Silver Nanoparticles: Self-Assembly and Application

Silver nanoparticles (AgNPs) are an attractive alternative to plasmonic gold nanoparticles. The relative cheapness and redox stability determine the growing interest of researchers in obtaining selective plasmonic and electrochemical (bio)sensors based on silver nanoparticles. The controlled synthesis of metal nanoparticles of a defined morphology is a nontrivial task, important for such fields as biochemistry, catalysis, biosensors and microelectronics. Cyclophanes are well known for their great receptor properties and are of particular interest in the creation of metal nanoparticles due to a variety of cyclophane 3D structures and unique redox abilities. Silver ion-based supramolecular assemblies are attractive due to the possibility of reduction by “soft” reducing agents as well as being accessible precursors for silver nanoparticles of predefined morphology, which are promising for implementation in plasmonic sensors. For this purpose, the chemistry of cyclophanes offers a whole arsenal of approaches: exocyclic ion coordination, association, stabilization of the growth centers of metal nanoparticles, as well as in reduction of silver ions. Thus, this review presents the recent advances in the synthesis and stabilization of Ag (0) nanoparticles based on self-assembly of associates with Ag (I) ions with the participation of bulk platforms of cyclophanes (resorcin[4]arenes, (thia)calix[n]arenes, pillar[n]arenes).