Raman Laser Spectrometer: Application to 12C/13C Isotope Identification in CH4 and CO2 Greenhouse Gases

13CH4/12CH4 sensing using Raman spectroscopy

The paper presents a technique for measuring the concentration of 13CH4 in natural methane using Raman spectroscopy. The peak positions and the relative scattering cross-sections of the Q-branches for the most intense vibrational bands of 13CH4 are determined. Features of the 13CH4/12CH4 ratio measurement methods using Q-branches of the ν1 and ν3 bands were considered. It was shown that the 13CH4/12CH4 ratio can be determined by simulation of the ν3 bands of these molecules without the use of experimental spectra. In our experiments the measurement error of δ13C value was 10 ‰ using the 100-s exposure spectrum at a gas pressure close to 1 atm recorded on the developed Raman spectrometer. In addition, the Raman spectra of alkanes (up to n-hexane) in the range of 2850-3050 cm-1 at a resolution of 0.4 cm-1 are presented, and their integrated intensities in the ranges of the characteristic bands of 13CH4 and 12CH4 are provided. The data obtained make it possible to expand the capabilities of Raman gas analyzers in the mud gas logging industry.

Antiresonant fiber-enhanced Raman spectroscopy gas sensing with 1 ppm sensitivity

Antiresonant hollow-core fiber (AR-HCF) exhibits unprecedented optical performance in low transmission attenuation, broad transmission bandwidth, and single spatial mode quality. However, due to its lower numerical aperture, when utilizing the Fiber-Enhanced Raman Spectroscopy (FERS) principle for gas detection, the efficiency of AR-HCF in collecting Raman signals per unit length is significantly lower than that of hollow-core photonic crystal fiber. Nonetheless, AR-HCF effectively suppresses higher-order modes and offers bandwidth in hundreds of nanometers. By increasing the length of AR-HCF, its advantages can be effectively harnessed, leading to a considerable enhancement in the system's ability for low-concentration gas detection. We combine the nodeless antiresonant hollow-core fiber and Raman spectroscopy for enhanced Raman gas sensing in a forward scattering measurement configuration to investigate the attenuation behavior of the silica background signals. The silica background attenuation behavior enables the low baseline of the gas Raman spectroscopy and extends the integration time of the system. In addition, a convenient spatial filtering method is investigated. A multimode fiber with a suitable core diameter was employed to transmit the signal so that the fiber end face plays the role of pinhole, thus filtering the silica signal and reducing the baseline. The natural isotopes 12C16O2, 13C16O2, and 12C18O16O in ambient air can be observed using a 5-meter-long AR-HCF at 1 bar with a laser output power of 1.8 W and an integration time of 300 seconds. Limits of detection have been determined to be 0.5 ppm for 13C16O2 and 1.2 ppm for 12C16O2, which shows that the FERS with AR-HCF has remarkable potential for isotopes and multigas sensing.

Natural Gas Analysis Using Polarized Raman Spectroscopy

Raman spectroscopy is a promising tool for measuring the composition of natural gas. However, to obtain high measurement accuracy, it is necessary to take into account changes in the spectral characteristics of methane, since its spectrum overlaps the characteristic bands of other species. In this study we present a technique for natural gas analysis based on polarized Raman spectroscopy. It is shown that the use of only isotropic components of spectra simplifies the procedure for extracting concentrations and improves the measurement accuracy of components whose spectral bands are significantly overlapped in conventional Raman spectra. The presented technique will be very useful both in the field of analysis of various multicomponent gas mixtures and in the field of measuring the isotopic composition of molecules.

Raman Spectroscopy for Urea Breath Test

The urea breath test is a non-invasive diagnostic method for Helicobacter pylori infections, which relies on the change in the proportion of ¹³CO₂ in exhaled air. Nondispersive infrared sensors are commonly used for the urea breath test in laboratory equipment, but Raman spectroscopy demonstrated potential for more accurate measurements. The accuracy of the Helicobacter pylori detection via the urea breath test using ¹³CO₂ as a biomarker is affected by measurement errors, including equipment error and δ¹³C measurement uncertainty. We present a Raman scattering-based gas analyzer capable of δ¹³C measurements in exhaled air. The technical details of the various measurement conditions have been discussed. Standard gas samples were measured. ¹²CO₂ and ¹³CO₂ calibration coefficients were determined. The Raman spectrum of the exhaled air was measured and the δ¹³C change (in the process of the urea breath test) was calculated. The total error measured was 6% and does not exceed the limit of 10% that was analytically calculated.

Raman Natural Gas Analyzer: Effects of Composition on Measurement Precision

Raman spectroscopy is a promising method for analyzing natural gas due to its high measurement speed and the potential to monitor all molecular components simultaneously. This paper discusses the features of measurements of samples whose composition varies over a wide range (0.005-100%). Analysis of the concentrations obtained during three weeks of experiments showed that their variation is within the error caused by spectral noise. This result confirms that Raman gas analyzers can operate without frequent calibrations, unlike gas chromatographs. It was found that a variation in the gas composition can change the widths of the spectral lines of methane. As a result, the measurement error of oxygen concentration can reach 200 ppm. It is also shown that neglecting the measurement of pentanes and n-hexane leads to an increase in the calculated concentrations of other alkanes and to errors in the density and heating value of natural gas.

Isotopic trace analysis of water vapor with multipass cavity Raman scattering

Cavity-enhanced spontaneous Raman scattering was investigated as a means of simple and inexpensive isotopic water analysis. A multimode blue laser diode equipped with a feedback-generating multipass cavity provided a 100-fold Raman enhancement at a pump linewidth of 3.5 cm^-1. Samples containing trace amounts of ¹H²H¹⁶O were probed at deuterium-hydrogen concentration ratios ranging from 157 parts-per-million (local seawater) down to 8 parts-per-million (deuterium depleted water). All measurements were performed in argon or dried air at atmospheric pressure at ¹H²H¹⁶O concentrations nearing 100 parts per billion with an uncooled camera at exposure times as short as a few minutes.

High-Sensitivity Raman Gas Probe for In Situ Multi-Component Gas Detection

Multiple reflection has been proven to be an effective method to enhance the gas detection sensitivity of Raman spectroscopy, while Raman gas probes based on the multiple reflection principle have been rarely reported on. In this paper, a multi-reflection, cavity enhanced Raman spectroscopy (CERS) probe was developed and used for in situ multi-component gas detection. Owing to signal transmission through optical fibers and the miniaturization of multi-reflection cavity, the CERS probe exhibited the advantages of in situ detection and higher detection sensitivity. Compared with the conventional, backscattering Raman layout, the CERS probe showed a better performance for the detection of weak signals with a relatively lower background. According to the 3σ criteria, the detection limits of this CERS probe for methane, hydrogen, carbon dioxide and water vapor are calculated to be 44.5 ppm, 192.9 ppm, 317.5 ppm and 0.67%, respectively. The results presented the development of this CERS probe as having great potential to provide a new method for industrial, multi-component online gas detection.